CY8CKIT-019 PSoC® Shield Adapter User Switches ArduinoTM Compatible I/O Header (J3) Power LED ArduinoTM Compatible I/O Header (J4) Prototyping Connector (J9) Thermistor User LEDs ArduinoTM Compatible I/O Header (J12) Reset Switch PSoC 5LP Header (J8) PSoC Expansion Board Kit Selectors Power Jumper ArduinoTM Compatible I/O Header (J2) ArduinoTM Compatible I/O Header (J1) Potentiometer PSoC Expansion Board Kit Adapter Header (J10) PSoC Shield Adapter Features: • • • • • • 1 Potentiometer 1 Thermistor 2 Switches 1 Reset Switch 4 LEDs 6 Jumper Wires CY8CKIT-019 PSoC Shield Adapter The CY8CKIT-019 is intended to be used with a number of Cypress development and evaluation kits. 1. 2. 3. 4. 5. 6. Download the Blinking LED example project from web page and unzip it: www.cypress.com/go/CY8CKIT-019 Connect the CY8CKIT-019 PSoC Shield Adapter to the CY8CKIT-042 PSoC 4 Pioneer Board. Connect the USB cable from the PC to the CY8CKIT-042. Connect a jumper wire from the prototyping connector pin 1 (LED1) to P0.4 (on J4). Launch PSoC Programmer from the Start menu. - Go to Start > All Programs > Cypress > PSoC programmer Using the ‘File Load’ button, navigate to the Hex File downloaded from the web page and select the ‘Blinking LED.hex’ file. Click the ‘Program’ button on PSoC Programmer. After successful programming, LED1 blinks. For more information about CY8CKIT-019 PSoC Shield Adapter including using it with Cypress expansion board kits, go to www.cypress.com/go/CY8CKIT-019 For technical support, visit http://www.cypress.com/support © Cypress Semiconductor Corporation, 2013. All rights reserved. PSoC® is a registered trademark and PSoC Creator™ is a trademark of Cypress Semiconductor Corp. All other trademarks or registered trademarks referenced herein are the property of their respective owners. The information contained here is subject to change without notice. Doc. #: 001-89826 Rev. **