CY3280-28XXX UNIVERSAL CAPSENSE™ CONTROLLER DEVELOPMENT KIT QUICK START GUIDE This kit needs to be plugged into the CY3280-SLM Linear Slider Module Kit to get started. For information on CY3280-SLM, visit www.cypress.com. 1 2 Install Software Kit Setup Install Software PSoC Programmer and PSoC Designer • Connect the CY3280-SLM Module with the CY3280-28XXX Board • Place shunts on pins 2 and 3 of JP1 and pins 1 and 2 of JP4 of CY3280-28XXX Board • Place shunt on pins 2 and 3 of JP2 on CY3280-SLM module 3 4 Program the Board Test the Board • Connect your computer to the CY3280-28XXX by the PSoC MiniProg and a USB cable • Program the board with the file CY3280_28XXX_SLM.hex on the CD • Power on the board with external power supply • Touch one or more buttons with your finger • The LEDs light up corresponding to the buttons being pressed [+] Feedback CY3280-28XXX UNIVERSAL CAPSENSE CONTROLLER DEVELOPMENT KIT QUICK START GUIDE CY3280-28XXX Universal CapSense Controller Board CY3280 CPM1 Board Connector External INT Selection SPI/I2C Interface ICE Interface CY3280 SLM Board Connector UART Interface Voltage Test Power Supply ISSP VCC Select Jumper For the latest information about this kit visit www.cypress.com/go/CY3280-28XXX © 2010 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. DOC#: 001-57454 REV ** [+] Feedback