CY3280-20X66 UNIVERSAL CAPSENSE CONTROLLER KIT QUICK START GUIDE 1 2 Remove CY3280-20x66 Universal CapSense Controller Board from package. Connect the CY3280-SLM board (to be purchased separately) to the P2 connector. Ensure that shunt is placed between 5 V and VCC of jumper J1. Plug in the USB cable to the CY3280-20x66 Universal CapSense Controller Board. 3 4 Touch the CapSense button or slider. The respective LEDs lights up. Insert the kit CD into the CD drive of your PC. Install the kit contents, PSoC Designer, PSoC Programmer, and Bridge Control Panel. After the kit contents and software are installed, PSoC Designer can be used to customize existing example projects or create new ones. CY3280-20X66 UNIVERSAL CAPSENSE CONTROLLER KIT QUICK START GUIDE CY3280-20x66 Universal CapSense Controller Board Details ISSP Connector 9 V Battery Terminal LEDs DC Supply Socket 5 V and Vadj Voltage Regulator ICs Variable Voltage Controller Reset Switch SPI/I2C Header Jumper for XRES Selection GPIO Pins Jumper to Select Power Option ICE-Cube Debug Connector PSoC CY8C20066A Mini B USB Connetor CapSense Module Connector For the latest information about this kit visit www.cypress.com/go/CY3280-20x66 © 2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. DOC#: 001-53020 REV *A