CY3280-BK1 UNIVERSAL CAPSENSE® CONTROLLER BASIC KIT 1 QUICK START GUIDE 1 1. Insert the kit CD/DVD into the CD/DVD drive of your PC. 2. Install the kit contents, PSoC Designer, and PSoC Programmer, by clicking on the Install CY3280-BK1... button. After installation, the kit contents are available at <Install_Directory>:\Cypress\CY3280-BK1\<version> 2 1. Connect the CY3280-SLM board to the CY3280-20x34 UCC board’s P2 connector. 2. In the CY3280-20x34 board, ensure that the jumper is placed on header J1 to short pins 2 and 3 (Vcc and 5 V). 3. In the CY3280-SLM board, ensure that the jumper is placed on header J2 to short pins 2 and 3 (Shield and Ground pins). 3 1. Connect the MiniProg1 to the CY3280-20x34 UCC board’s ISSP connector (J3). Connect it to your PC using an USB A to mini-B cable. 2. Open PSoC Programmer. 3. Click Connect; connect MiniProg1 to your PC. 4. Click the Toggle button to power the board. 4 1. Touch and move your finger over the linear slider on the CY3280-SLM module board. The corresponding LEDs on the CY3280-SLM board light up. 2. Touch a button. The corresponding LED on the CY3280-SLM module board lights up. 3. You can touch multiple buttons simultaneously. The linear slider and buttons can be used at the same time. Repeat steps 2, 3, and 4 to test the CY3280-21x34 CapSense Controller. For assistance, go to http://www.cypress.com/go/support, or contact our customer support at +1 (800) 541-4736 Ext. 8 (in the USA) or +1 (408) 943-2600 Ext. 8 (International) CY3280-BK1 UNIVERSAL CAPSENSE® CONTROLLER BASIC KIT 1 QUICK START GUIDE CY3280-20x34 Board Details LEDs D1 and D2 9-V Battery Jumper to Select Terminal Power Option ISSP Header DC Supply Jack SPI / I2C Expansion Header 5-V Voltage Regulator IC Jumper for XRES Selection Adjustable Voltage Regulator IC Footprint for ICE-Cube Connector CMod CapSense Controller CY8C20000 CapSense Module Connector CY3280-21x34 Board Details LEDs D1 and D2 9-V Battery Terminal Jumper to Select Power Option ISSP Header DC Supply Jack 5-V Voltage Regulator IC SPI / I2C Expansion Header Jumper for XRES Selection Adjustable Voltage Regulator IC Rbleed (Rb) CapSense Controller CY8C21001 Footprint for ICE-Cube Connector CMod CapSense Module Connector For the latest information about this kit, visit http://www.cypress.com/go/CY3280-BK1 © 2011-2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc#: 001-43363 Rev. *D