CYPRESS EZ-PDTM CCG2: USB Type-C Port Controller Build a USB 3.1 Type-C Solution P R O D UC T O VE RVI E W INTRODUCTION: F E AT U R E S EZ-PDTM CCG2 is a low cost, one-chip USB Type-C port controller solution with Power • 32-Bit MCU subsystem: Delivery (PD). CCG2 is optimized for notebook applications and for all cable applications - 48-MHz ARM® Cortex®-M0 MCU including passive EMCA1, active EMCA, cable adapters. CCG2 enables the smallest foot - 32 KB Flash and 4 KB SRAM print EMCA solution by integrating most external components including isolation diodes, • Type-C support termination resistors, and system level ESD protection. CCG2 requires only up to five external - Integrated Type-C Transceiver with termination resistors components to operate. CCG2 has an ARM® Cortex® -M0 with 32 KB flash to enable firmware upgrades. CCG2 is available in 20-ball WLCSP, 14-pin DFN and 24-pin QFN packages. - 2x I2C/SPI/UART interface to EEPROM/ device controller • Power - Wide operating voltages: 2.7 V – 5.5 V - Enhanced ESD protection: ±8-kV contact and ±15-kV air - Low current: deep sleep – 2.5 uA • Package - 20-WLCSP - 14-DFN - 24-QFN A Type-C cable with a controller on both ends of the cable KEY APPLICATIONS Cables, tablets, notebooks, dongles 1 An Electronically Marked Cable Assembly (EMCA ) is a USB cable with an IC that reports cable characteristics (e.g., current rating) to the Type-C ports cypress.com/ccg2 P R O D UC T O VE RVI E W BLOCK DIAGRA MS MCU Subsystem Integrated Digital Blocks Data Lines (USB SuperSpeed, USB Hi-Speed, PCle1, Display Port2) 12 I/O Subsystem VBUS3 CC4 TCPWM7 CORTEX -M0 ® 48 MHZ Flash (32 KB) SRAM (4 KB) Serial Wire Debug VCONN5 SCB1 x2 (I2C, SPI, UART) Programmable I/O Matrix Advanced High-Performance Bus (AHB) CC4 Profiles and Configuration Baseband MAC VCONN1 CCG2 CYPD2103-20FNXI VCONN2 GND VDDIO Peripheral Component Interconnect Express is an interface standard for connecting peripherals 1 Baseband PHY GPIO5 Port Integrated RD2, RA3, RP6 A display interface standard developed by the Video Electronics Standards Association (VESA) used primarily to connect a video source to a display such as a computer monitor 2 Serial communication block configurable as UART, SPI or I2C Termination resistor read as a UFP 3 Termination resistor read as an EMCA 4 Configuration Channel 5 General-purpose input/output 6 Current sources to indicate a DFP 7 Timer, counter, pulse-width modulation block 1 The power wire of the USB bus 3 2 Configuration Channel 4 USB Type-C bus wire used to power the IC in the EMCA 5 CCG2: USB Type-C Port controller Type-C cable with CCG2 cable controller CCG2 PORTFOLIO Part Number Application Type-C Ports Overcurrent Protection Over voltage Protection Termination Resistor Role Package CYPD2103-20FNXIT Cable 1 No No RA Cable 20-Ball CSP CYPD2103-14LHXIT Cable 1 No No RA Cable 14-Pin DFN CYPD2104-20FNXIT Accessory 1 No No RA , RD UFP 20-Ball CSP CYPD2105-20FNXIT Active Cable 1 No No RA Active Cable 20-Ball CSP CYPD2120-24LQXIT Accessory 1 No No RA , RD UFP 24-Pin QFN CYPD2122-24LQXIT Note Books 1 No No RP , RD DRP 24-Pin QFN CYPD2134-24LQXIT DFP 1 No No RP DFP 24-Pin QFN CYPD2122-20FNXIT Tablets 1 No No RP , RD DRP 24-Pin QFN GET TING STARTED For more information on CCG2 email us at [email protected] or visit www.cypress.com/ccg2 Cypress Semiconductor Corporation 198 Champion Court, San Jose CA 95134 phone +1 408.943.2600 toll free +1 800.858.1810 (U.S. only) © 2015 Cypress Semiconductor Corporation. All Rights Reserved. Cypress and Cypress logo are registered trademarks of Cypress Semiconductor Corp. ARM and Cortex are registered trademarks of ARM Limited. All other trademarks are the property of their respective owners. 001-95714 Rev*C