CY4638 WIRELESSUSBâ„¢ LP VOIP DEMO KIT QUICK START GUIDE 1 2 Remove the CY4638 bridge dongle, remote, radio board, mono headset, battery charger, and USB extension cable from the package. Connect the bridge dongle to the PC. The bridge enumerates as an USB audio device in the Device Manager. 3 4 Connect the radio module board on the remote. The remote board binds with the bridge dongle automatically. Insert the CY4638 kit CD. Connect the headset and start using the VoIP kit. To check the VoIP kit, make a call on Skype or Google Talk, or play a music file. If the battery is drained, open jumper J5 and connect the power supply to the remote board to charge the battery. Install PSoC Designer and PSoC Programmer. CY4638 WIRELESSUSBâ„¢ LP VOIP DEMO KIT QUICK START GUIDE CY4638 WirelessUSB LP VoIP Demo Kit Details CY7C64215 Chip Bridge Dongle Bind Button Dual LED 12-MHz Oscillator Antenna CYRF6936 Chip USB Connector Radio Board Remote CY7C60323 Chip Antenna Channel Switch Button ISSP Header Antenna CYRF6936 Chip 12-MHz Oscillator DC Supply Connector Radio Interface Header Speaker Winbond Codec Microphone For the latest information about this kit, visit http://www.cypress.com/go/CY4638 © 2011-2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc #: 001-69344 Rev. *B