Features General • High-performance, Low-power secureAVR® RISC Architecture • • • • • • – 135 Powerful Instructions (Most Executed in a Single Clock Cycle) Low Power Idle and Power-down Modes Bond Pad Locations Conforming to ISO 7816-2 ESD Protection to ± 6000V Operating Ranges: 1.62 to 5.5V Compliant with GSM, 3GPP and EMV 2000 Specifications; PC Industry Compatible Available in Wafers, Modules, QFN44 and SOIC8 packages Memory • 256K Bytes of ROM Program Memory • 72K Bytes of EEPROM, Including 128 OTP Bytes and 384-byte Bit-addressable Area – 1 to 128-byte Program / Erase – 1.25 ms Program / 1.25 ms Erase – Typically More than 500,000 Write/Erase Cycles at a Temperature of 25oC – 10 Years Data Retention – EEPROM Erase Only Mode – Write EEPROM With or Without Autoerase • 8K Bytes of RAM • 32K Bytes of ROM Dedicated to Atmel’s Crypto-library Secure Microcontroller for Smart Cards AT90SC25672RCT -USB Summary Peripherals • ISO 7816 Controller • • • • • • • • • • • – Up to 625 kbps at 5 MHz – Compliant with T = 0 and T = 1 Protocols One I/O Port USB 2.0 Full Speed interface with 5 endpoints and DMA controller Programmable Internal Oscillator (Up to 40 MHz for CPU and Crypto Accelerator) Two 16-bit Timers Random Number Generator (RNG) 2-level, 9-vector Interrupt Controller Hardware DES and Triple DES DPA/DEMA Resistant Checksum Accelerator CRC 16 & 32 Engine (Compliant with ISO/IEC 3309) 32-bit AdvX™ Cryptographic Accelerator for Public Key Operations with GF(2n) Multiplier and Firmware (RSA, ECC, Key Generation) Security • • • • • • • • Dedicated Hardware for Protection Against SPA/DPA Attacks Advanced Protection Against Physical Attack, Including Active Shield Environmental Protection Systems Voltage Monitor Frequency Monitor Light Protection Temperature Monitor Secure Memory Management/Access Protection (Supervisor Mode) Certification • • • • CC EAL4+ VISA CAST USB 2.0 6522DS–SPD–07Sep07 Note: This is a summary document. A complete document will be available under NDA. For more information, please contact your local Atmel sales office. Development Tools • Voyager Emulation Platform (ATV4 Standard) to Support Software Development • IAR Systems EWAVR® V4.21A Debugger or Above • Software Libraries and Application Notes Description The AT90SC25672RCT-USB is a low-power, high-performance, 8/16-bit microcontroller with ROM program memory, EEPROM data memory, cryptographic accelerator based on the secureAVR enhanced RISC architecture. By executing powerful instructions in a single clock cycle, the AT90SC25672RCT-USB achieves throughputs close to 1 MIPS per MHz. Its Harvard architecture includes 32 general purpose working registers directly connected to the ALU, allowing two independent registers to be accessed in one single instruction executed in one clock cycle. The AT90SC25672RCT-USB uses a new AVR® architecture, the secureAVR that allows the linear addressing of up to 8M bytes of code and up to 16M bytes of data as well as a number of new functional and security features. The cryptographic accelerator featured in this product is the AdvX, a 32-bit accelerator dedicated to performing fast encryption and authentication functions. It is combined with a 32K byte-ROM for a high-performance and secure crypto firmware. The ability to map the EEPROM in the code space allows parts of the program memory to be reprogrammed in-system. This technology combined with the versatile 8/16-bit CPU on a monolithic chip provides a highly flexible and cost-effective solution to many smart card applications. Additional security features include power and frequency protection logic, logical scrambling on program data and addresses, Power Analysis countermeasures and memory accesses controlled by a supervisor mode. A block diagram of the AT90SC25672RCT-USB is shown in Figure 1 hereafter. USB Controller Description The AT90SC25672RCT-USB features an USB V2.0 Full Speed controller which requires a 48 MHz external crystal for the data transfer. The USB interface consists of a Serial Interface Engine (SIE) and a Universal Function Interface (UFI). The SIE performs clock/data separation, NRZI encoding and decoding, bit stuffing, CRC generation and checking and serialparallel data conversion. The UFI connects the USB interface to the AVR. It consists of a protocol engine and provides five configurable data transfer endpoints, each with its own DPRAM in the memory area. The data transfer type for each endpoint is configured by software. The table below indicates the characteristics of each endpoint: Table 1: Characteristics of each endpoint. Endpoint number Size (bytes) Available data transfer modes EP0 64 BULK, ISOCHRONOUS, INTERRUPT, CONTROL EP1 2 * 64 BULK, ISOCHRONOUS, INTERRUPT EP2 2 * 64 BULK, ISOCHRONOUS, INTERRUPT EP3 64 BULK, ISOCHRONOUS, INTERRUPT, CONTROL EP4 64 BULK, ISOCHRONOUS, INTERRUPT, CONTROL A DMA controller allows a fast communication rate between the RAM of the CPU and the DPRAM. The USB controller provides a dynamic pull-up attachment and detachment and a host detection mechanism. In addition, it offers an automatic interface detection between the USB 2.0 and the ISO7816 port. 2 AT90SC25672RCT-USB 6522DS–SPD–07Sep07 AT90SC25672RCT-USB Figure 1. AT90SC25672RCT -USB secureAVR RISC Architecture Data Bus 8-bit OTP Access Control USBDM USBDP XIN XOUT USB Module EEPROM User Memory PC CRYPTO ROM General Purpose Registers Program Memory X 16 Instruction Register 8 ALU 16 8 Instruction Decoder 16 Control Lines Access Control Y Z 8 Status Register RNG Secure Control CLK GND VCC / VBus AdvX CryptoCoprocessor RAM Data Memory Interrupt Unit ISO 7816 Controller ISO 7816 I/O Port 0 IN/OUT0 Timer 0 Timer 1 Reset Circuit RST DES DPA Counter measures CRC and Checksum Accelerator A DMA controller allows a fast communication rate between the RAM of the CPU and the DPRAM. 3 6522DS–SPD–07Sep07 NC 4 NC USB_DP NC NC NC NC NC NC NC USB_DM NC 44 43 42 41 40 39 38 37 36 35 34 Figure 2. Pinout AT90SC25672RCT-USB - Package QFN44 1 33 NC ISO_CLK 2 32 NC USB_XOUT 3 31 ISO_IO0 / GPIO NC 4 30 NC USB_XIN 5 29 NC ISO_RST 6 28 NC NC 7 27 NC NC 8 26 NC NC 9 25 NC VCC / VBUS 10 24 GND NC 11 23 NC INDEX CORNER AT90SC25672RCT-USB 20 21 22 NC NC 17 NC NC 16 NC 18 15 NC 19 14 NC NC 13 NC NC 12 NC (44-lead QFN top view) AT90SC25672RCT-USB 6522DS–SPD–07Sep07 AT90SC25672RCT-USB Figure 3. Pinout AT90SC25672RCT-USB - Package SOIC8 - ISO Mode GND 1 8 VCC 7 ISO_RST 6 NC 5 ISO_CLK INDEX CORNER NC 2 AT90SC25672RCT-USB ISO_IO0 3 NC 4 SOIC8 Figure 4. Pinout AT90SC25672RCT-USB - Package SOIC8 - USB Mode GND 1 8 VBUS 7 USB_XIN 6 USB_XOUT 5 USB_DP INDEX CORNER NC 2 AT90SC25672RCT-USB GPIO 3 USB_DM 4 SOIC8 5 6522DS–SPD–07Sep07 Figure 5. Quad Flat No Lead Package, 44 Leads 6 AT90SC25672RCT-USB 6522DS–SPD–07Sep07 AT90SC25672RCT-USB Figure 6. Plastic Small Outline Package - 8-lead - 0.209” Body C 1 E E1 L N Top View ? End View e b A COMMON DIMENSIONS (Unit of Measure = mm) A1 SYMBOL D Side View NOM MAX NOTE A 1.70 2.16 A1 0.05 0.25 b 0.35 0.48 5 C 0.15 0.35 5 D 5.13 5.35 E1 5.18 5.40 E 7.70 8.26 L 0.51 0.85 ? 0˚ 8˚ e Notes: 1. 2. 3. 4. 5. MIN 1.27 BSC 2, 3 4 This drawing is for general information only; refer to EIAJ Drawing EDR-7320 for additional information. Mismatch of the upper and lower dies and resin burrs are not included. It is recommended that upper and lower cavities be equal. If they are different, the larger dimension shall be regarded. Determines the true geometric position. Values b and C apply to pb/Sn solder plated terminal. The standard thickness of the solder layer shall be 0.010 +0.010/-0.005 mm. 7 6522DS–SPD–07Sep07 8 AT90SC25672RCT-USB 6522DS–SPD–07Sep07 Atmel Corporation 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 487-2600 Regional Headquarters Europe Atmel Sarl Route des Arsenaux 41 Case Postale 80 CH-1705 Fribourg Switzerland Tel: (41) 26-426-5555 Fax: (41) 26-426-5500 Asia Room 1219 Chinachem Golden Plaza 77 Mody Road Tsimshatsui East Kowloon Hong Kong Tel: (852) 2721-9778 Fax: (852) 2722-1369 Japan 9F, Tonetsu Shinkawa Bldg. 1-24-8 Shinkawa Chuo-ku, Tokyo 104-0033 Japan Tel: (81) 3-3523-3551 Fax: (81) 3-3523-7581 Atmel Operations Memory 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 436-4314 RF/Automotive Theresienstrasse 2 Postfach 3535 74025 Heilbronn, Germany Tel: (49) 71-31-67-0 Fax: (49) 71-31-67-2340 Microcontrollers 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 436-4314 La Chantrerie BP 70602 44306 Nantes Cedex 3, France Tel: (33) 2-40-18-18-18 Fax: (33) 2-40-18-19-60 ASIC/ASSP/Smart Cards 1150 East Cheyenne Mtn. Blvd. Colorado Springs, CO 80906, USA Tel: 1(719) 576-3300 Fax: 1(719) 540-1759 Biometrics/Imaging/Hi-Rel MPU/ High Speed Converters/RF Datacom Avenue de Rochepleine BP 123 38521 Saint-Egreve Cedex, France Tel: (33) 4-76-58-30-00 Fax: (33) 4-76-58-34-80 Zone Industrielle 13106 Rousset Cedex, France Tel: (33) 4-42-53-60-00 Fax: (33) 4-42-53-60-01 1150 East Cheyenne Mtn. Blvd. Colorado Springs, CO 80906, USA Tel: 1(719) 576-3300 Fax: 1(719) 540-1759 Scottish Enterprise Technology Park Maxwell Building East Kilbride G75 0QR, Scotland Tel: (44) 1355-803-000 Fax: (44) 1355-242-743 Literature Requests www.atmel.com/literature Disclaimer: The information in this document is provided in connection with Atmel products. No license, express or implied, by estoppel or otherwise, to any intellectual property right is granted by this document or in connection with the sale of Atmel products. EXCEPT AS SET FORTH IN ATMEL’S TERMS AND CONDITIONS OF SALE LOCATED ON ATMEL’S WEB SITE, ATMEL ASSUMES NO LIABILITY WHATSOEVER AND DISCLAIMS ANY EXPRESS, IMPLIED OR STATUTORY WARRANTY RELATING TO ITS PRODUCTS INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT, CONSEQUENTIAL, PUNITIVE, SPECIAL OR INCIDENTAL DAMAGES (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF PROFITS, BUSINESS INTERRUPTION, OR LOSS OF INFORMATION) ARISING OUT OF THE USE OR INABILITY TO USE THIS DOCUMENT, EVEN IF ATMEL HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Atmel makes no representations or warranties with respect to the accuracy or completeness of the contents of this document and reserves the right to make changes to specifications and product descriptions at any time without notice. Atmel does not make any commitment to update the information contained herein. Atmel’s products are not intended, authorized, or warranted for use as components in applications intended to support or sustain life. © Atmel Corporation 2007. All rights reserved. Atmel ®, logo and combinations thereof, and others are registered trademarks. Everywhere You Are SM, and others are the trademarks of Atmel Corporation or its subsidiaries. Other terms and product names may be trademarks of others. 6522DS–SPD–07Sep07