BOURNS MF-MSMF110-16-2

LED PWM Dimmer
PWM / Power
Solution Products
MF-MSMF110/16-2
Objective
Compliance
This solution is designed to protect LED
dimmer controls with 12 VDC/1 Amp and
PWM control signal from overcurrent,
overvoltage, ESD and surge events.
IEC61000-4-2 ESD Level 4 (8 kV / 15 kV)
IEC61000-4-4 EFT
IEC61000-4-5 Surge / Lightning
Solution
Alternate Recommendations
Solutions are available for lower/higher levels of
overvoltage/overcurrent protection
1 Multifuse® PPTC Resettable Fuse:
MF-MSMF110/16-2
2 TVS Diode Arrays: CDSOT23-T12C
Benefit
This solution provides ESD/EFT/surge and
supplies overcurrent protection from potential
faults during installation within rated limits.
CDSOT23-T12C
MF-MSMF110/16-2
12 VDC
LED
Dimmer
Control
CDSOT23-T12C
0-12 V PWM
Design Kit
The schematic above illustrates the application protection and does not constitute the complete circuit design.
Customers should verify actual device performance in their specific applications.
PN-DESIGNKIT-29
Americas: Tel +1-951 781-5500
Fax +1-951 781-5700
Europe: Tel +41-(0)41 768 55 55 Asia-Pacific: Tel +886-2 256 241 17
Fax +41-(0)41 768 55 10 Fax +886-2 256 241 16
COPYRIGHT© 2012 • BOURNS, INC. • 6/12 • e/CPK1144 • “PortNote” is a registered service mark of Bourns, Inc.
“Bourns” and “Multifuse” are registered trademarks of Bourns, Inc. in the U.S. and other countries.
Bourns® PortNote® solutions provide protection
recommendations for typical port threats.
For more information, go to:
www.bourns.com
or email: protection@bourns.com