Rohm DTDG23YP 1a / 60v digital transistor (with built-in resistors and zener diode) Datasheet

DTDG23YP
Transistors
1A / 60V Digital transistor
(with built-in resistors and zener diode)
DTDG23YP
zExternal dimensions (Unit : mm)
MPT3
4.5
1.6
1.5
2.5
4.0
zFeatures
1) High DC current gain. (Min. 300 at VO / IO=2V /
0.5A)
2) Low Vo(on). (Typ. 0.4V at IO / II=500mA / 5mA)
3) Built-in zener diode gives strong protection against
reverse surge by L-load (an inductive load).
0.5
zApplications
Inverter, Interface, Driver
(2)
(3)
1.0
(1)
0.5
0.4
zStructure
NPN epitaxial planar silicon transistor
(with built-in resistors and zener diode)
1.5
(1)Base
(2)Collector
(3)Emitter
0.4
0.4
1.5
3.0
Abbreviated symbol : E02
zPackaging specifications
Part No.
MPT3
Taping
T100
1000
Package
Packaging type
Code
Basic ordering unit (pieces)
DTDG23YP
zAbsolute maximum ratings (Ta=25°C)
Parameter
Supply voltage
Input voltage
Symbol
VCC
VIN
IC
ICP
Pd
Tj
Tstg
Collector current
Unit
OUT
V
R1
IN
A
A
W
C
C
R2
GND
OUT
IN
GND
+
+
Power dissipation
Junction temperature
Storage temperature
∗1 Pw <− 10ms, Duty cycle <− 2%
∗2 When mounted on 40 40 0.7mm ceramic board.
zEquivalent circuit
Limits
60±10
−6 to +40
1
2
∗1
1.5 ∗2
150
−55 to +150
R1=2.2kΩ R2=10kΩ
zElectrical characteristics (Ta=25°C)
Parameter
Input voltage
Output voltage
Input current
Output current
DC current gain
Transition frequency
Input resistance
Emitter-base resistance
Symbol
VI(off)
VI(on)
VO(on)
II
IO(off)
GI
fT ∗
R1
R2
Min.
−
2
−
−
−
300
−
1.54
7
Typ.
−
−
−
−
−
−
80
2.2
10
Max.
0.3
−
0.4
3.6
0.5
−
−
2.86
13
Unit
V
V
mA
µA
−
MHz
kΩ
kΩ
Conditions
VCC=5V , IO=100µA
VO=0.4V , IO=100mA
IO/II=500mA/5mA
VI=5V
VCC=40V , VI=0V
VO=2V , IO=500mA
VCE=5V , IE= −0.1A , f=30MHz
−
−
∗ Characteristics of built-in transistor
Rev.B
1/2
DTDG23YP
Transistors
zElectrical characteristics curves
10m
VO=0.4V
2m
Ta= −40°C
25°C
125°C
1
0.5m
0.2m
Ta=125°C
25°C
−40°C
1m
500µ
DC CURRENT GAIN : GI
10
2
VO=2V
5k
20
5
10k
VCC=5V
5m
50
OUTPUT CURRENT : IO (A)
INPUT VOLTAGE : VI(on) (V)
100
200µ
100µ
50µ
20µ
10µ
5µ
2µ
0.1m
1m 2m
5m 10m 20m 50m 100m 200m 500m 1
OUTPUT CURRENT : IO (A)
Fig.1 Input voltage vs. output current
(ON characteristics)
1
1µ
0
2k
1k
Ta=125°C
25°C
−40°C
500
200
100
50
20
0.5
1.0
1.5
2.0
2.5
3.0
INPUT VOLTAGE : VI(off) (V)
Fig.2 Output current vs. Input voltage
(OFF characteristics)
10
1m 2m
5m 10m 20m 50m 100m200m 500m 1
OUTPUT CURRENT : IO (A)
Fig.3 DC current gain vs. Output current
IO / II=100/1
OUTPUT VOLTAGE : VO(on) (V)
500m
Ta=125°C
25°C
−40°C
200m
100m
50m
20m
10m
5m
2m
1m
1m
2m
5m 10m 20m 50m100m 200m 500m 1
OUTPUT CURRENT : IO (A)
Fig.4 Output voltage vs. Output current
Rev.B
2/2
Appendix
Notes
No technical content pages of this document may be reproduced in any form or transmitted by any
means without prior permission of ROHM CO.,LTD.
The contents described herein are subject to change without notice. The specifications for the
product described in this document are for reference only. Upon actual use, therefore, please request
that specifications to be separately delivered.
Application circuit diagrams and circuit constants contained herein are shown as examples of standard
use and operation. Please pay careful attention to the peripheral conditions when designing circuits
and deciding upon circuit constants in the set.
Any data, including, but not limited to application circuit diagrams information, described herein
are intended only as illustrations of such devices and not as the specifications for such devices. ROHM
CO.,LTD. disclaims any warranty that any use of such devices shall be free from infringement of any
third party's intellectual property rights or other proprietary rights, and further, assumes no liability of
whatsoever nature in the event of any such infringement, or arising from or connected with or related
to the use of such devices.
Upon the sale of any such devices, other than for buyer's right to use such devices itself, resell or
otherwise dispose of the same, no express or implied right or license to practice or commercially
exploit any intellectual property rights or other proprietary rights owned or controlled by
ROHM CO., LTD. is granted to any such buyer.
Products listed in this document are no antiradiation design.
The products listed in this document are designed to be used with ordinary electronic equipment or devices
(such as audio visual equipment, office-automation equipment, communications devices, electrical
appliances and electronic toys).
Should you intend to use these products with equipment or devices which require an extremely high level of
reliability and the malfunction of with would directly endanger human life (such as medical instruments,
transportation equipment, aerospace machinery, nuclear-reactor controllers, fuel controllers and other
safety devices), please be sure to consult with our sales representative in advance.
About Export Control Order in Japan
Products described herein are the objects of controlled goods in Annex 1 (Item 16) of Export Trade Control
Order in Japan.
In case of export from Japan, please confirm if it applies to "objective" criteria or an "informed" (by MITI clause)
on the basis of "catch all controls for Non-Proliferation of Weapons of Mass Destruction.
Appendix1-Rev1.1
Similar pages