Assmann DN-93501-U/BL Cat.5e unshielded keystone jack, 90 ë tool free type, blue Datasheet

Material:
1 RJ45 Jack Housing: ABS, UL94V-0
- with optional color
2. Jack Bracket Set: PBT, UL94V-0
3. RJ45 Jack Contact Material & Finished
- Phosphor Bronze
- Contact area: Min. 3MM 50 Micro-inch Gold
plated over Nickel plated
4. IDC Housing: PC, 94V-2
5. IDC Terminal material & finished:
- Phosphor Bronze w/Min. 50 Micro-inch Tin plated
- Suitable for 23-24AWG stranded & solid wire
6. IDC CAP: PC, UL94V-2
Electrical:
• Wiring: T568A & T568B
• Insertion Force: 900 GM for 8 contacts
• Retention Strength: 7.7Kg between Jack & Plug
• Operating Temperature: -10°C ~ +60°C
• Durability: Jack: 750 cycles Plug-Jack mating and
unmating test, Insertion cycles at 20 cycles/
minute max. Contact resistance test per 100
cycles.
• The Cat.5e transmission performance is in compliance
with the ANSI/TIA/EIA 568 B.2 standard
ITEM NO.
RoHS
Compliant
TITLE
DN-93501-U/BL
Cat.5e Unshielded Keystone Jack,
90° Tool Free Type, Blue
ASSMANN
Electronics, Inc.
1840 W. Drake Drive, Suite 101 • Tempe, AZ 85283
Toll Free: 1-877-277-6266 • Email: [email protected]
THIS DRAWING IS UNPUBLISHED
©Copyright 2009 by Assmann Electronic Components
All International Rights Reserved
1
3
30mm
ASSMANN
Electronics, Inc.
2
2 1 6 3
5 4 7 8
Unshielded type
Tool
Colored Sticker
A
BB
AA
BB
Shielded type
5
5
White/Green
Green
White/Orange
Blue
White/Blue
Orange
White/Brown
Brown
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
T568B
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Cable tie
Cable tie
Insert the cable tie to tight up the cable
jacket. Then complete the installation.
Fully Shielded
Half Shielded
Complete the installation.
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
T568A
DN-93501-U/X and DN-93601-U/X
Keystone Jack Installing Instruction
the wires.
4
the wires.
press down to close plastic lid to connect
Plug the easy tool into upper hole, then
Tool
press down to close plastic lid to connect
Plug the easy tool into upper hole, then
4
Strip approximately 30mm of the cable
jacket, and separate to 4 pair each.
Attn: Suitable for 23~24 AWG Solid Wire
Follow the direction on the plastic
lid color- coding to position T568A
or T568B wiring, separate a little
space on proper position and insert
the wire pair by pair into each slot.
3
Follow the direction on the plastic
lid color- coding to position T568A
or T568B wiring, separate a little
space on proper position and insert
the wire pair by pair into each slot.
Similar pages