MACOM AT-255 3 volt voltage variable attenuator 25 db, dc-2.5 ghz Datasheet

3 Volt Voltage Variable Attenuator
25 dB, DC-2.5 GHz
Features
•
•
•
•
•
AT-255
V7
Functional Schematic 1
Single Voltage Control: 0 to -3 Volts
25 dB Attenuation Range at 0.9 GHz
Low DC Power Consumption
SOT-25 Plastic Package
Tape and Reel Packaging Available
Vc
GND
5
4
Description
M/A-COM’s AT-255 is a GaAs MMIC voltage
variable absorptive attenuator in a low cost SOT-25
surface mount plastic package. The AT-255 is
ideally suited for use where variable attenuation, fine
tuning, and very low power consumption are
required.
Typical applications include radio, cellular, GPS
equipment and automatic gain/level control circuits.
The AT-255 is fabricated using a mature 1-micron
GaAs MESFET process. The process features full
chip passivation for increased performance and
reliability.
1
2
3
RF
GND
RF
1. VC = -3 V to 0 V @ 25 µA maximum.
Pin Configuration
Ordering Information
Part Number
Package
AT-255
SOT-25 Plastic
AT-255TR
1000 piece reel
Note: Reference Application Note M513 for reel size
information.
Pin No.
Function
Pin No.
Function
1
RF Port
4
Ground
2
Ground
5
VC
3
RF Port
Absolute Maximum Ratings 2
Parameter
Absolute Maximum
Input Power
+21 dBm
Control Voltage VC
-8 V to +0.5 V
Operating Temperature
-40°C to +85°C
Storage Temperature
-65°C to +150°C
2. Exceeding any one or combination of these limits may cause
permanent damage to this device.
1
M/A-COM Inc. and its affiliates reserve the right to make changes to the
product(s) or information contained herein without notice. M/A-COM makes
no warranty, representation or guarantee regarding the suitability of its
products for any particular purpose, nor does M/A-COM assume any liability
whatsoever arising out of the use or application of any product(s) or
information.
• North America Tel: 800.366.2266 / Fax: 978.366.2266
• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300
• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298
Visit www.macom.com for additional data sheets and product information.
3 Volt Voltage Variable Attenuator
25 dB, DC-2.5 GHz
AT-255
V7
Electrical Specifications: TA = 25°C, Z0 = 50 Ω
Parameter
Test Conditions
Units
Min
Typ
Max
DC—2.0 GHz
dB
—
3.6
4.2
Attenuation
DC—1.0 GHz
1.0—2.0 GHz
dB
dB
23
18
25
20
—
—
Flatness
(Peak-to-Peak)
0.5—1.0 GHz
1.0—2.0 GHz
dB
dB
—
+7
+5
+ 10
+8
VSWR
DC—2.0 GHz
Ratio
—
3:1
—
Trise, Tfall
10% to 90% RF, 90% to 10% RF
nS
—
10
—
Ton, Toff
50% Control to 90% RF,
50% Control to 10% RF
nS
—
20
—
Transients
In Band
mV
—
10
—
Insertion Loss
3
3. Insertion loss varies 0.003 dB/°C.
SOT-25
2
M/A-COM Inc. and its affiliates reserve the right to make changes to the
product(s) or information contained herein without notice. M/A-COM makes
no warranty, representation or guarantee regarding the suitability of its
products for any particular purpose, nor does M/A-COM assume any liability
whatsoever arising out of the use or application of any product(s) or
information.
• North America Tel: 800.366.2266 / Fax: 978.366.2266
• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300
• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298
Visit www.macom.com for additional data sheets and product information.
3 Volt Voltage Variable Attenuator
25 dB, DC-2.5 GHz
AT-255
V7
Typical Performance Curves
Relative Attenuation vs. Control
Voltage
50MHz
1.0GHz
Insertion Loss vs. Frequency
+25C
2.5GHz
35
Insertion Loss (dB)
30
Attenuation (dB)
+85C
-40C
4
25
20
15
10
3
2
1
5
0
0
-3.0
-2.5
-2.0
-1.5
-1.0
-0.5
0.0
0.0
0.5
+85C
-40C
S11
35
2.0
2.5
3.0
-0.5
0.0
-0.5
0.0
S22
0
S11, S22 (dB)
30
Attenuation (dB)
1.5
Return Loss vs. Control Voltage
@ 900 MHz
Maximum Relative Attenuation vs. Frequency
+25C
1.0
Frequency (GHz)
Control Voltage (V)
25
20
15
10
-5
-10
-15
-20
5
-25
-3.0
0
0.0
0.5
1.0
1.5
2.0
2.5
3.0
-2.5
Input IP3 vs. Control Voltage
50MHz
500MHz
500MHz
35
Compression Point (dBm)
25
IP3 (dBm)
-1.0
Input P1dB vs. Control Voltage
30
20
15
10
5
0
-3.0
-1.5
Control Voltage (V)
Frequency (GHz)
50MHz
-2.0
-2.5
-2.0
-1.5
-1.0
-0.5
0.0
Control Voltage (V)
3
M/A-COM Inc. and its affiliates reserve the right to make changes to the
product(s) or information contained herein without notice. M/A-COM makes
no warranty, representation or guarantee regarding the suitability of its
products for any particular purpose, nor does M/A-COM assume any liability
whatsoever arising out of the use or application of any product(s) or
information.
30
25
20
15
10
5
0
-3.0
-2.5
-2.0
-1.5
-1.0
Control Voltage (V)
• North America Tel: 800.366.2266 / Fax: 978.366.2266
• Europe Tel: 44.1908.574.200 / Fax: 44.1908.574.300
• Asia/Pacific Tel: 81.44.844.8296 / Fax: 81.44.844.8298
Visit www.macom.com for additional data sheets and product information.
Similar pages