PANDUIT D-436-0128-ND Stub splice sealing system, tin plated crimp Datasheet

SPECIFICATION CONTROL DRAWING
MATERIALS
1. INSULATION SLEEVE: Heat-shrinkable, transparent blue, radiation cross-linked modified polyvinylidene
fluoride.
2. MELTABLE INSERTS: Low-outgassing thermoplastic, color-natural.
3. SEAMLESS STUB SPLICE: Base Metal: Copper Alloy 101 or 102 per ASTM B-75.
Plating: Tin plated per MIL-T-10727.
CMA Range: 300 to 1510 circular mils.
APPLICATION
1. This system is designed to provide an environmentally resistant splice in wires rated for at least 125°C. Splices may be
either two wire stub splices or 1 to 1 or 2 to 1 parallel splices. If two wires exit from one end, they must have a combined
outer diameter of less than 2.03 (0.080).
2. Parts when installed as detailed on Raychem Specification Control Drawing D-436-58/-59 shall meet
performance requirements of MIL-S-81824.
3. Acceptance testing shall be in accordance with Paragraph 4.6 of MIL-S-81824.
Tyco Electronics Corporation
305 Constitution Drive
Menlo Park, CA 94025, USA
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.
INCHES DIMENSIONS ARE BETWEEN BRACKETS.
Tyco Electronics reserves the right to amend this
ANGLES: N/A
TOLERANCES:
drawing at any time. Users should evaluate the
0.00 N/A
suitability of the product for their application.
ROUGHNESS IN
0.0 N/A
MICRON
0 N/A
DRAWN BY:
REPLACES:
DCR NUMBER:
M. FORONDA
D001280
TITLE :
Raychem
Products
D010047
If this document is printed it becomes uncontrolled. Check for the latest revision.
DOCUMENT NO.:
STUB SPLICE SEALING
SYSTEM,
TIN PLATED CRIMP
D-436-0128
DATE:
DOC ISSUE:
2
26-Jan.-00
PROD. REV.
A
SCALE:
None
SIZE:
A
SHEET:
1 of 1
Similar pages