TPS615(F) TOSHIBA Phototransistor Silicon NPN Epitaxial Planar TPS615(F) Lead(Pb)-Free Floppy Disk Drive VCR Position Detector Of Home Electric Equipment Stroboscope Opto−Electronic Switch • φ3.1mm epoxy resin package • Light current: IL = 20μA (min.) at E = 0.1mW / cm2 • Half value angle: θ1/2 = ±30° (typ.) Unit in mm Absolute Maximum Ratings (Ta = 25°C) Characteristic Symbol Rating Unit Collector−emitter voltage VCEO 30 V Emitter−collector voltage VECO 5 V Collector current IC 20 mA TOSHIBA Collector power dissipation PC 75 mW Weight: 0.12 g (typ.) ΔPC /°C −1 mW /°C Operating temperature range Topr −30~85 °C Storage temperature range Tstg −30~100 °C Collector power dissipation derating (Ta > 25°C) 0−3D1 Pin Connection 1 1. Emitter 2. Collector Note: Using continuously under heavy loads (e.g. the application of high 2 temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook (“Handling Precautions”/“Derating Concept and Methods”) and individual reliability data (i.e. reliability test report and estimated failure rate, etc). 1 2007-10-01 TPS615(F) Opto−Electrical Characteristics (Ta = 25°C) Characteristic Symbol Dark current ID (ICEO) Light current Test Condition VCE = 24 V Min. Typ. Max. Unit — 0.01 0.1 μA 20 — 150 μA 2 IL (Note 2) VCE = 3 V, E = 0.1 mW / cm (Note 1) VCE (sat) IC = 10 μA, E = 0.1 mW / cm (Note 1) — 0.2 0.4 V λP — — 800 — nm 1 2 — ⎯ ±30 ⎯ ° ⎯ 9 ⎯ ⎯ 10 ⎯ 2 Collector−emitter saturation voltage Peak Sensitivity wavelength Half value angle Switching time θ Rise time tr Fall time tf VCC = 10 V, IC = 1 mA RL = 1kΩ μs Note 1: Color temperature = 2870K standard tungsten lamp Note 2: IL Classification A: 20~50 μA, B: 34~85 μA, C: 60~150 μA, AB: 20~85 μA, BC: 34~150μA Precaution Please be careful of the followings. 1. Soldering temperature: 260°C max. Soldering time: 3s max. (Soldering portion of lead: above 1.5mm from the body of the device) 2. If the lead is formed, the lead should be formed at a distance of 2mm from the body of the device. Soldering shall be performed after lead forming. 2 2007-10-01 TPS615(F) Fig. 1 Switching Time Test Circuit Input Input pulse VCC 0 TPS615(F) TLN119(F) 90% Output R RL Output pulse 10% 0 tr tf ID – Ta PC – Ta 80 1 (typ.) VCE = 24V 60 Dark current ID (μA) Allowable collector power dissipation PC (mW) E=0 40 10-1 10-2 20 0 0 20 40 60 80 10-3 0 100 Ambient temperature Ta (°C) IL - E 500 40 60 80 100 Ambient temperature Ta (°C) (typ.) VCE = 3 V IL - VCE 300 Ta = 25°C Color (typ.) 500 Ta = 25°C Temperature = 2870K 100 Light current IL (μA) Light current IL (μA) 20 50 30 400 0.6 0.5 300 0.4 200 0.3 10 0.2 100 5 2 0.01 E=0.1mW/cm2 0.03 0.05 0.1 0.3 0.5 0 1 0 2 4 6 Collector-emitter voltage Radiant incidence E (mW/cm2) 3 8 10 VCE (V) 2007-10-01 TPS615(F) Directional Sensitivity Characteristic (typ.) (Ta = 25°C) Frequency Characteristics 12 VCC = 5V Ta = 25°C 8 Light source = TLN119(F) 20° 10° 0° 10° 4 20° Relative output (dB) Radiation Angle 30° 30° 40° 40° 50° 50° 60° 60° 70° 70° 0 RL=100Ω -4 -8 -12 10kΩ 80° 80° 90° 1.0 0.8 0.6 (typ.) 0.4 0.2 -20 Relative sensitivity 500Ω 1kΩ -16 90° 0 5kΩ 1 3 10 5 50 100 30 300 500 1000 Frequency f (kHz) Coupling Characteristics With TLN119(F) Switching Characteristics(typ.) 3000 Ta = 25°C VCC= 10V Input TLN119(F) R Output RL Output pulse 1000 90% 10% Input pulse 500 tr tf TLN119(F) IE = 3.0mW/sr 300 (μA) 200 Collector current IC tr (RL=10kΩ) Switching time (μs) 100 tf (RL=10kΩ) 50 30 tf (RL=1kΩ) 10 tf (RL=100Ω) 5 3 50 30 10 tr (RL=1kΩ) Ta = 25°C TPS615(F) Using sample : IL = 50.4μA at VCE = 3V E = 0.1mW/cm2 5 IC 3 tr (RL=100Ω) 3V d TLN119(F) 1 0.02 1.5 0.5 100 TPS615(F) 1 0.05 0.1 0.3 0.5 Collector current IC 1 3 5 1 3 5 10 Distance (mA) 4 30 50 100 200 d (mm) 2007-10-01 TPS615(F) Spectral Response 120 (typ.) Ta = 25°C (%) 100 Relative sensitivity 80 60 40 20 0 0 200 400 600 800 1000 1200 Wavelength λ (nm) 5 2007-10-01 TPS615(F) RESTRICTIONS ON PRODUCT USE 20070701-EN GENERAL • The information contained herein is subject to change without notice. • TOSHIBA is continually working to improve the quality and reliability of its products. Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical sensitivity and vulnerability to physical stress. It is the responsibility of the buyer, when utilizing TOSHIBA products, to comply with the standards of safety in making a safe design for the entire system, and to avoid situations in which a malfunction or failure of such TOSHIBA products could cause loss of human life, bodily injury or damage to property. In developing your designs, please ensure that TOSHIBA products are used within specified operating ranges as set forth in the most recent TOSHIBA products specifications. Also, please keep in mind the precautions and conditions set forth in the “Handling Guide for Semiconductor Devices,” or “TOSHIBA Semiconductor Reliability Handbook” etc. • The TOSHIBA products listed in this document are intended for usage in general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.).These TOSHIBA products are neither intended nor warranted for usage in equipment that requires extraordinarily high quality and/or reliability or a malfunction or failure of which may cause loss of human life or bodily injury (“Unintended Usage”). Unintended Usage include atomic energy control instruments, airplane or spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, all types of safety devices, etc.. Unintended Usage of TOSHIBA products listed in his document shall be made at the customer’s own risk. • The products described in this document shall not be used or embedded to any downstream products of which manufacture, use and/or sale are prohibited under any applicable laws and regulations. • The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by TOSHIBA for any infringements of patents or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patents or other rights of TOSHIBA or the third parties. • Please contact your sales representative for product-by-product details in this document regarding RoHS compatibility. Please use these products in this document in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances. Toshiba assumes no liability for damage or losses occurring as a result of noncompliance with applicable laws and regulations. 6 2007-10-01