AH288 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER General Description Features • • • • • • • • AH288 is a monolithic fan motor controller with Hall sensor’s capability. It contains two complementary open-drain transistors as motor coil drivers, automatic lock current shutdown, and recovery protections. Additional, frequency generator (FG) output is for speed detection relatively. On chip Hall sensor Rotor-locked shutdown Automatically restart Frequency generator (FG) output Built-in Zener protection for output driver Operating voltage: 3.8V~28V Output current: IO(AVE) = 400mA Lead Free Finish/RoHS Compliant for Lead Free products (Note 1) Lead Free Packages: SIP-5L and SOT89-5L • Rotor-lock shutdown detection circuit turns off the output driver when the rotor is blocked to avoid coil overheat. Then, the automatic recovery circuit will restart the motor. These protected actions are repeated and periodic during the blocked period. Until the blocking is removed, the motor recovers and runs normally. Ordering Information AH288 - X X X Package P: SIP-5L Y: SOT89-5L Note: 1. Packing Lead L : Lead Free -B : -13 : Bulk Taping RoHS revision 13.2.2003. Glass and High Temperature Solder Exemptions Applied, see EU Directive Annex Notes 5 and 7. Device Lead-free AH288-P AH288-Y Package Code P Y Packaging (Note 2) SIP-5 SOT89-5 Quantity 1000 NA Tube/Bulk Part Number Suffix -B NA 7” Tape and Reel Quantity Part Number Suffix NA NA 2500/Tape & Reel -13 Lead-free Note: 2. Pad layout as shown on Diodes Inc. suggested pad layout document AP02001, which can be found on our website at http://www.diodes.com/datasheets/ap02001.pdf. AH288 Rev. 4 1 of 10 www.diodes.com JANUARY 2007 © Diodes Incorporated AH288 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Pin Assignments 288 ( Front View ) VCC 1 5 FG 1 : FG 2 : VCC 288 GND 2 3 : DO 4 : DOB 47 DOB DO 3 5 : GND 1 2 3 4 5 SOT89-5L SIP-5L Pin Descriptions Name Description FG Frequency generation VCC Input power DO Output pin DOB Output pin GND Ground Block Diagram Vdd 2 Lock shutdown and Automatic recovery Regulator Hall Plate AH288 Rev. 4 3 DO 4 DOB Control Logic Amp. 5 1 GND FG 2 of 10 www.diodes.com JANUARY 2007 © Diodes Incorporated AH288 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Typical Application Circuit D2 24V R pu 288 Coil 1 Coil 2 D1 1 2 3 4 5 GND FG 48V C1=1uF 48V 24V DC Brush-less Fan with FG output function Characteristics Symbol Supply Voltage Rating VCC IO(AVE) Output Current SIP5/SOT89-5 IO(PEAK) Power Dissipation SIP5 SOT89-5 PD Operating Temperature Storage Temperature Maximum Junction Temperature Topr Tstg Tj SIP5 SOT89-5 θJA Thermal Resistance Absolute Maximum Ratings Unit 30 400 700 550 800 -40 ~ 100 -55 ~ 150 150 227 156 V mA mW °C °C °C °C/W °C/W ( TA = 25°C ) TA TJ Tc θ JA θ JC Note: θ JA should be confirmed with what heat sink thermal resistance. If no heat sink contacting, AH288 Rev. 4 3 of 10 www.diodes.com θ JA is almost the same as θ JC . JANUARY 2007 © Diodes Incorporated AH288 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Electrical Characteristics ( TA = 25 °C, Vdd = 24V, unless otherwise specified ) Characteristics Symbol Conditions Min. Typ. Max. Unit Supply Voltage Vdd 3.8 - 28* V Supply current Output Leakage Current Locked Protection On Locked Protection Off Icc Ioff Operating Operating VOUT = 24V Tlrp-on Tlrp-off VOUT( sat ) 2 < 0.1 0.46 2.76 450 680 2.25 0.3 55 4 10 0.6 3.6 700 800 3.5 0.5 65 mA µA Sec Sec Output saturation voltage 0.4 2.4 42 Output On resistance FG output Vds Output Zener-breakdown Voltage *Note: IO = 200mA IO = 300mA IO = 200mA IO = 10mA Rds(on) Vol Vz mV ohm V V Please watch out the current limit issue when the operation voltage is over 26.4V, because of the different efficiency in the coil. Truth Table INH L - IN+ L H - CT L L H OUT1 H L off OUT2 L H off FG H L - Mode Rotating Rotating Lockup protection activated Magnetic Characteristics ( TA = 25 °C, VCC = 24V, unless otherwise specified ) ( 1Mt = 10 Gauss ) Characteristics Operate Point Release Point Hysteresis AH288 Rev. 4 Symbol Min. Typ. Max. Unit Bop Brp Bhy 10 -60 - 30 -30 60 60 -10 - Gauss Gauss Gauss 4 of 10 www.diodes.com JANUARY 2007 © Diodes Incorporated AH288 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Operating Characteristics DO 24 RP OFF 20 16 12 8 4 ON OP Output Voltage in Volts Output Voltage in Volts DOB Vsat Brp 0 OP 20 16 12 8 4 RP ON Vsat Bop Brp Magnetic Flux Density in Gauss 0 Bop Magnetic Flux Density in Gauss S S Marking side Marking side AH288 Rev. 4 24 OFF N N ( SIP5 ) ( SOT89-5 ) 5 of 10 www.diodes.com JANUARY 2007 © Diodes Incorporated AH288 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Performance Characteristics ( SIP-5L ) 25 550 105 198 TA (°C) PD (mW) TA (°C) PD (mW) 50 440 110 176 60 396 115 154 70 352 120 132 80 308 125 110 85 286 130 88 90 264 135 66 95 242 140 44 100 220 150 0 Power Dissipation Curve Pd (mW ) 600 500 400 300 200 100 0 0 15 30 45 60 75 90 105 100 120 135 150 Ta (。C) Performance Characteristics ( SOT89-5L ) TA (°C) 25 50 60 70 75 80 85 90 95 100 PD (mW) 800 640 576 512 480 448 416 384 352 320 TA (°C) 105 110 115 120 125 130 135 140 145 150 PD (mW) 288 256 224 192 160 128 96 64 32 0 P D (m W ) P ow er D issipation C urve 900 800 700 600 500 400 300 200 100 0 0 25 50 75 100 125 150 T A (。 C ) AH288 Rev. 4 6 of 10 www.diodes.com JANUARY 2007 © Diodes Incorporated AH288 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Marking Information (1) SIP-5L ( Front View ) Part Number 288 L : Lead Free Package Y WW X X Y :Year: "1" = 2001 "2" = 2002 WW : Nth week 01~52 X : Internal Code: A ~ Z (2) SOT89-5L 4 7 5 Y : Year: 0-9 M : Month: A~L 288 Y M X 1 AH288 Rev. 4 2 X : Internal code a~z : Lead Free 3 7 of 10 www.diodes.com JANUARY 2007 © Diodes Incorporated AH288 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Package Information (unit: mm) (1) Package type: SIP-5L Location of Sensing Point 2.006 mm [0.079 inch] ( Top View) 1.016 mm [0.04 inch] 1 AH288 Rev. 4 2 3 8 of 10 www.diodes.com 4 5 JANUARY 2007 © Diodes Incorporated AH288 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER Package Information ( Continued ) (2) Package type: SOT89-5L Sensor Location AH288 Rev. 4 9 of 10 www.diodes.com JANUARY 2007 © Diodes Incorporated AH288 HIGH VOLTAGE HALL-EFFECT SMART FAN MOTOR CONTROLLER IMPORTANT NOTICE Diodes Incorporated and its subsidiaries reserve the right to make modifications, enhancements, improvements, corrections or other changes without further notice to any product herein. Diodes Incorporated does not assume any liability arising out of the application or use of any product described herein; neither does it convey any license under its patent rights, nor the rights of others. The user of products in such applications shall assume all risks of such use and will agree to hold Diodes Incorporated and all the companies whose products are represented on our website, harmless against all damages. LIFE SUPPORT Diodes Incorporated products are not authorized for use as critical components in life support devices or systems without the expressed written approval of the President of Diodes Incorporated. AH288 Rev. 4 10 of 10 www.diodes.com JANUARY 2007 © Diodes Incorporated