AZETTLER AZ848-48 Microminiature surface mount polarized relay Datasheet

AZ848
MICROMINIATURE SURFACE
MOUNT POLARIZED RELAY
FEATURES
• High dielectric and surge voltage: 1.5 kV surge
(per FCC Part 68) 750 VRMS open contacts
• Low power consumption: 56 mW set
• Non-latching and latching versions
• Single coil and dual coil versions
• Stable contact resistance for low level signal switching
• Epoxy sealed for automatic wave soldering and cleaning
• UL file E43203, CSA 73363
• All plastics meet UL94 V-0, 30 min. oxygen index
CONTACTS
GENERAL DATA
Life Expectancy
Mechanical
Electrical
Minimum operations
1 x 108 operations at 3 Hz
2 x 105 operations at 0.5 A,
125 VAC, resistive
5 x 105 operations at 1.0 A,
30 VDC, resistive
Arrangement
DPDT (2 Form C)
Bifurcated crossbar contacts
Ratings
Non-inductive load:
Operate Time (typical)
2 ms at nominal coil voltage
Max. switched power: 60 W or 62.5 VA
Max. switched current: 2 A
Max. switched voltage: 220 VDC or 250 VAC
Release Time (typical)
1 ms at nominal coil voltage
(with no coil suppression)
Bounce (typical)
1 ms (at nominal coil voltage)
Capacitance
< 0.5 pF open and adjacent contacts
< 1.0 pF contact to coil
Dielectric Strength
(at sea level)
See table
Insulation Resistance
109 ohms min. at 500 VDC
Dropout
Greater than 10% of nominal coil voltage
Ambient Temperature
Operating
Storage
At nominal coil voltage
-40°C (-40°F) to 85°C (185°F)
-40°C (-40°F) to 85°C (185°F)
Vibration
Operational, 3.3 mm DA, 10 - 55 Hz
Non-Destructive, 5.5 mm DA, 10 -55 Hz
Shock
Operational, 50g min., 11 ms
Non-Destructive, 100 g min., 6 ms
Enclosure
LCP
Terminals
Tinned copper alloy, P.C.
Max. Solder Temp.
See charts
Max. Solder Time
See charts
Max. Solvent Temp.
80°C (176°F)
Max. Immersion Time
30 seconds
Weight
1.5 grams
Rated Load
UL/CSA
0.5 A at 125 VAC res.
2.0 A at 30 VDC res.
0.3 A at 110 VDC res.
Material
Silver palladium; gold clad
Resistance
< 50 milliohms initially at 6 V, 0.1 A
COIL
Power
At Pickup Voltage
(typical)
AZ848: 79 mW to 169 mW
AZ848P1: 57 mW to 85 mW
AZ848P2: 110 mW to 170 mW
Max. Continuous
Dissipation
826 mW at 20°C (68°F) ambient
652 mW at 40°C (104°F) ambient
Temperature Rise
At nominal coil voltage
18°C (32°F) (3 - 12 VDC coils)
25°C (45°F) (18, 24 VDC coils)
34°C (61°F) (48 VDC coils)
Temperature
Max. 115°C (239°F)
NOTES
1.
2.
3.
4.
All values at 20°C (68°F).
Relay has fixed coil polarity.
Relay may pull in with less than “Must Operate” value.
Relay adjustment may be affected if undue pressure is exerted
on relay case.
5. For complete isolation between the relay’s magnetic fields, it is
recommended that a .197" (5.0 mm) space be provided between
adjacent relays.
6. Specifications subject to change without notice.
11/3/99W
AZ848
RELAY ORDERING DATA
SINGLE SIDE STABLE (Standard, Non-Latching)
COIL SPECIFICATIONS
Nominal Coil
VDC
1.5
Max. Continuous
VDC
3.7
3
7.3
Coil Resistance
± 10%
16.1
Must Operate
VDC
1.13
64.3
ORDER NUMBER
AZ848–1.5
2.25
AZ848–3
4.5
10.9
145
3.38
AZ848–4.5
5
12.1
178
3.75
AZ848–5
6
9
14.6
21.9
257
579
4.5
6.75
AZ848–6
AZ848–9
12
29.1
1,028
9.0
AZ848–12
18
36.6
1,620
13.5
AZ848–18
24
48.7
2,880
18.0
AZ848–24
48
79.6
7,680
36.0
AZ848–48
RELAY ORDERING DATA
SINGLE COIL (Latching)
COIL SPECIFICATIONS
Nominal Coil
VDC
1.5
Max. Continuous
VDC
4.3
3
8.6
Coil Resistance
± 10%
22.5
Set (+)/Reset (-)
VDC
1.13
90
2.25
ORDER NUMBER
AZ848P1–1.5
AZ848P1–3
4.5
12.9
203
3.38
AZ848P1–4.5
5
14.4
250
3.75
AZ848P1–5
6
9
17.2
25.8
360
810
4.5
6.75
AZ848P1–6
AZ848P1–9
12
34.5
1,440
9.0
AZ848P1–12
18
42.2
2,160
13.5
AZ848P1–18
24
56.3
3,840
18.0
AZ848P1–24
RELAY ORDERING DATA
DUAL COIL (Latching)
COIL SPECIFICATIONS
Nominal Coil
VDC
1.5
Max. Continuous
VDC
3.0
3
4.5
6.1
Coil Resistance
(each coil) ± 10%
11.25
Set/Reset
VDC
1.13
45
2.25
ORDER NUMBER
AZ848P2–1.5
AZ848P2–3
9.1
101
3.38
AZ848P2–4.5
5
10.2
125
3.75
AZ848P2–5
6
9
12.2
25.8
180
405
4.5
6.75
AZ848P2–6
AZ848P2–9
12
24.4
720
9.0
AZ848P2–12
18
29.9
1,080
13.5
AZ848P2–18
24
39.8
1,920
18.0
AZ848P2–24
INITIAL DIELECTRIC AND SURGE STRENGTH (minimum)
Between Open Contacts
VRMS, 1 min.
750
Peak (V)
1500
Between Contact Sets
750
1500
Between Coil and Contacts
1000
1500
SURGE
Rise Time
10 µs
Decay Time
160 µs
10 µs
160 µs
10 µs
160 µs
Decay time measured from beginning of surge.
11/3/99W
AZ848
SOLDERING DATA
VPS (Vapor Phase Soldering)
SOLDERING
T3
TEMPERATURE (˚C)
TEMPERATURE (˚C)
IRS (Infrared Reflow Soldering)
T2
PREHEATING
COOLING
T1
SOLDERING
215˚ C MAX
T3
COOLING
T2
PREHEATING
T1
60 SEC MAX
30 SEC
MAX
120 SEC MAX
60 SEC MAX
90 SEC MAX
T3= 200°C MAX
T2= 165°C MAX
T1= 100°C MAX
T3= 245°C MAX
T2= 200°C MAX
T1= 165°C MAX
MECHANICAL DATA
.551
[14.0]
WIRING DIAGRAMS
PC BOARD LAYOUT
VIEWED TOWARDS TERMINALS
VIEWED TOWARDS TERMINALS
.354
[9.0]
1
3
4
3˚
TYP
5
(-)
10
.300
[7.62]
.020 TYP
[0.5]
.453
[11.5]
9
8
7
6
Stripe on top of relay indicates location of pins 1 and 10.
DEENERGIZED OR RESET CONDITION
.100
[2.54]
.100
[2.54]
.100
[2.54]
.354
[9.0]
WIRING DIAGRAMS
PC BOARD LAYOUT
VIEWED TOWARDS TERMINALS
VIEWED TOWARDS TERMINALS
Stripe on top of relay
indicates location of
pins 1 and 10.
ORIENTATION MARK
1
.256
[6.5]
.100
[2.54]
.100
[2.54]
.100
[2.54]
.076
[1.92]
.100
[2.54]
.100
[2.54]
.551
[14.0]
.076
[1.92]
10 X .116
[2.94]
.261
[6.62]
.008
[0.2]
.030
[0.75]
.100
[2.54]
.100
[2.54]
.100
[2.54]
2
10 X .040
[1.0]
(+)
.256
[6.5]
.076
[1.92]
Stripe on top of relay
indicates location of
pins 1 and 10.
ORIENTATION MARK
.030
[0.75]
.020 TYP
[0.5]
SET
COIL
.008
[0.2]
3˚
TYP
.300
[7.62]
.453
[11.5]
2
3
4
10 X .116
[2.94]
5
(+)
(-)
RESET (+)
COIL
.261
[6.62]
(-)
10
9
8
7
6
Stripe on top of relay indicates location of pins 1 and 10.
.100
[2.54]
10 X .040
[1.0]
RESET CONDITION
.076
[1.92]
.100
[2.54]
.100
[2.54]
.100
[2.54]
.100
[2.54]
Dimensions in inches with metric equivalents in parentheses. Tolerance: ±0.010"
11/3/99W
AZ848
PACKING
(1) Packing Method (only tape packing is available)
• Taping Standards: JIS C 0806 and
RC - 1009B (EIAJ)
• Tape type: TB2416 or TE2416
FEEDING
ORIENTATION
MARK SIDE
• Reel type: R24D
• Quantity on 1 reel: 500 relays
• Packing orientation code: B
REEL DIMENSIONS
1.2
[30.4]
TOP
COVER TAPE
ø13.0
[ø330]
EMBOSSED
CARRIER TAPE
ø.512
[ø13.0]
TAPE DIMENSIONS
.059 DIA.
[1.5 DIA.]
.015
[0.38]
.079
[2.0]
.059
[1.5 DIA]
.158
[4.0]
.069
[1.75]
.453
[11.5]
.571
[14.5]
.272
[6.9]
.480
[12.2]
.945
[24.0]
.630
[16.0]
11/3/99W
Similar pages