Rohm DTC115EE 100ma / 50v digital transistors (with built-in resistors) Datasheet

100mA / 50V Digital transistors
(with built-in resistors)
DTC115EM / DTC115EE / DTC115EUA / DTC115EKA
zInner circuit
zApplications
Inverter, Interface, Driver
R1
IN
zFeatures
1) Built-in bias resistors enable the configuration of an inverter circuit
without connecting external input resistors (see the equivalent circuit).
2) The bias resistors consist of thin-film resistors with
complete isolation to allow negative biasing of the input,
and parasitic effects are almost completely eliminated.
3) Only the on/off conditions need to be set for operation,
making the device design easy.
4) Higher mounting densities can be achieved.
OUT
R2
GND
IN
OUT
GND
R1=R2=100kΩ
zStructure
NPN epitaxial planar silicon transistor (Resistor built-in type)
zDimensions (Unit : mm)
DTC115EM
DTC115EE
0.7
1.6
0.55
0.3
0.2
(3)
0.8
DTC115EUA
ROHM : EMT3
2.9
0.8
(3)
1.6
2.8
2.1
1.25
0.1Min.
(1)
0.65 0.65
ROHM : UMT3
EIAJ : SC-70
1.1
0.4
0.7
(3)
(2)
(1) GND
(2) IN
(3) OUT
Abbreviated symbol : 29
DTC115EKA
0.9
0.2
0.15
1.0
Abbreviated symbol : 29
0.3
0.2
0.5 0.5
(1) IN
(2) GND
(3) OUT
2.0
(1)
0.2
1.3
0.15
(2)
(1) GND
(2) IN
(3) OUT
Each lead has same dimensions
Abbreviated symbol : 29
(1)
0.95 0.95
0.15
ROHM : SMT3
EIAJ : SC-59
1.9
0.3Min.
ROHM : VMT3
(2)
0.13
0.5
0.1Min.
(1)(2)
0.4 0.4
0.2
0.22
0.8
0.8
1.2
(3)
1.6
1.2
0.32
(1) GND
(2) IN
(3) OUT
Each lead has same dimensions
Abbreviated symbol : 29
zPackaging specifications
Package
Packaging type
Part No.
Code
Basic ordering unit (pieces)
VMT3
Taping
T2L
8000
EMT3
Taping
TL
3000
UMT3
Taping
T106
3000
SMT3
Taping
T146
3000
−
−
−
−
−
DTC115EM
DTC115EE
−
DTC115EUA
−
−
DTC115EKA
−
−
www.rohm.com
c 2009 ROHM Co., Ltd. All rights reserved.
○
−
−
1/2
2009.05 - Rev.B
DTC115EM / DTC115EE / DTC115EUA / DTC115EKA
Data Sheet
zAbsolute maximum ratings (Ta=25°C)
Parameter
Symbol
Limits
Unit
VCC
VIN
50
−10 to +40
V
V
Supply voltage
Input voltage
Output current
IO
20
IC(Max.)
100
150
DTC115EM / DTC115EE
Power
DTC115EUA / DTC115EKA
dissipation
Junction temperature
Storage temperature
PD
mA
mW
Tj
200
150
Tstg
−55 to +150
°C
°C
zElectrical characteristics (Ta=25°C)
Parameter
Input voltage
Output voltage
Input current
Output current
DC current gain
Symbol
VI(off)
Min.
Typ.
Max.
−
−
VI(on)
VO(on)
3
−
−
0.1
0.5
−
0.3
II
−
−
IO(off)
−
82
−
GI
−
Unit
Conditions
VCC=5V, IO=100µA
V
VO=0.3V, IO=1mA
V
IO=5mA, II=0.25mA
VI=5V
0.15
0.5
−
mA
µA
−
VCC=50V, VI=0V
IO=5mA, VO=5V
−
Input resistance
R1
70
kΩ
R2/R1
fT ∗
0.8
100
1
130
Resistance ratio
1.2
−
250
−
−
MHz
Transition frequency
−
VCE=10V, IE=−5mA, f=100MHz
∗ Characteristics of built-in transistor
zElectrical characteristics curves
10
10
25℃
85℃
OUTPUT CURRENT : I O (mA)
INPUT VOLTAGE : V I (on) (V)
Ta= -40℃
125℃
1
0.1
0.01
V0 = 0.3V
0.1
1
10
VCC = 5V
1
Ta=125℃
85℃
0.1
25℃
-40℃
0.01
0
100
1000
Ta=125℃
OUTPUT VOLTAGE : VO(on) (V)
DC CURENT GAIN : G I
25℃
-40℃
10
1
0.01
0.1
1
10
OUTPUT CURENT : IO (mA)
2
1
VO= 5V
85℃
100
1
3
INPUT VOLTAGE : VI(off) (V)
OUTPUT CURRENT : IO (mA)
100
www.rohm.com
c 2009 ROHM Co., Ltd. All rights reserved.
○
IC /II=20
Ta=125℃
85℃
25℃
0.1
0.01
0.1
-40℃
1
10
100
OUOPUT CURRENT : IO (mA)
2/2
2009.05 - Rev.B
Notice
Notes
No copying or reproduction of this document, in part or in whole, is permitted without the
consent of ROHM Co.,Ltd.
The content specified herein is subject to change for improvement without notice.
The content specified herein is for the purpose of introducing ROHM's products (hereinafter
"Products"). If you wish to use any such Product, please be sure to refer to the specifications,
which can be obtained from ROHM upon request.
Examples of application circuits, circuit constants and any other information contained herein
illustrate the standard usage and operations of the Products. The peripheral conditions must
be taken into account when designing circuits for mass production.
Great care was taken in ensuring the accuracy of the information specified in this document.
However, should you incur any damage arising from any inaccuracy or misprint of such
information, ROHM shall bear no responsibility for such damage.
The technical information specified herein is intended only to show the typical functions of and
examples of application circuits for the Products. ROHM does not grant you, explicitly or
implicitly, any license to use or exercise intellectual property or other rights held by ROHM and
other parties. ROHM shall bear no responsibility whatsoever for any dispute arising from the
use of such technical information.
The Products specified in this document are intended to be used with general-use electronic
equipment or devices (such as audio visual equipment, office-automation equipment, communication devices, electronic appliances and amusement devices).
The Products specified in this document are not designed to be radiation tolerant.
While ROHM always makes efforts to enhance the quality and reliability of its Products, a
Product may fail or malfunction for a variety of reasons.
Please be sure to implement in your equipment using the Products safety measures to guard
against the possibility of physical injury, fire or any other damage caused in the event of the
failure of any Product, such as derating, redundancy, fire control and fail-safe designs. ROHM
shall bear no responsibility whatsoever for your use of any Product outside of the prescribed
scope or not in accordance with the instruction manual.
The Products are not designed or manufactured to be used with any equipment, device or
system which requires an extremely high level of reliability the failure or malfunction of which
may result in a direct threat to human life or create a risk of human injury (such as a medical
instrument, transportation equipment, aerospace machinery, nuclear-reactor controller,
fuel-controller or other safety device). ROHM shall bear no responsibility in any way for use of
any of the Products for the above special purposes. If a Product is intended to be used for any
such special purpose, please contact a ROHM sales representative before purchasing.
If you intend to export or ship overseas any Product or technology specified herein that may
be controlled under the Foreign Exchange and the Foreign Trade Law, you will be required to
obtain a license or permit under the Law.
Thank you for your accessing to ROHM product informations.
More detail product informations and catalogs are available, please contact us.
ROHM Customer Support System
http://www.rohm.com/contact/
www.rohm.com
© 2009 ROHM Co., Ltd. All rights reserved.
R0039A
Similar pages