GP1001 - GP1007 10.0 AMPS. Glass Passivated Rectifiers TO-220AB Features Glass passivated chip junction. High efficiency, Low VF High current capability High reliability High surge current capability Low power loss Mechanical Data Cases: TO-220AB molded plastic Epoxy: UL 94V-0 rate flame retardant Terminals: Pure tin plated, lead free. solderable per MIL-STD-202, Method 208 guaranteed Polarity: As marked High temperature soldering guaranteed: o 260 C /10 seconds .16”,(4.06mm) from case. Weight: 2.24 grams Dimensions in inches and (millimeters) Maximum Ratings and Electrical Characteristics Rating at 25 oC ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20% GP GP GP GP GP GP Units Symbol GP 1001 1002 1003 1004 1005 1006 1007 Maximum Recurrent Peak Reverse Voltage VRRM 50 100 200 400 600 800 1000 V Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 V Maximum DC Blocking Voltage VDC 50 100 200 400 600 800 1000 V Type Number Maximum Average Forward Rectified Current .375”(9.5mm) Lead Length @TC = 100 oC Peak Forward Surge Current, 8.3 ms Single Half Sine-wave Superimposed on Rated Load (JEDEC method ) Maximum Instantaneous Forward Voltage @5.0A I(AV) 10.0 A IFSM 125 A VF 1.1 V 5.0 200 30 3.0 - 65 to + 150 uA uA pF o C/W o C Maximum DC Reverse Current @ TC=25 oC at Rated DC Blocking Voltage @ TC=125 oC IR Typical Junction Capacitance ( Note 1) Cj RθJC Operating and Storage Temperature Range TJ ,TSTG 1. Measured at 1 MHz and Applied Reverse Voltage of 4.0 Volts D.C. Notes: 2. Thermal Resistance from Junction to Case Mounted on Heatsink size 2” x 3” x 0.25” Al-Plate. Typical Thermal Resistance ( Note 2 ) Version: A06 RATINGS AND CHARACTERISTIC CURVES (GP1001 THRU GP1007) FIG.1- MAXIMUM FORWARD CURRENT DERATING CURVE 100 10 40 8 6 Single Phase Half Wave 60Hz Resistive of Inductive Load 4 2 0 50 100 150 o CASE TEMPERATURE. ( C) INSTANTANEOUS REVERSE CURRENT. ( A) AVERAGE FORWARD CURRENT. (A) 12 FIG.2- TYPICAL REVERSE CHARACTERISTICS PER LEG FIG.3- MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT 10 Tj=125 0C 4 2 1.0 Tj=25 0C .4 .2 PEAK FORWARD SURGE CURRENT. (A) 175 .1 150 0 20 40 60 80 100 120 140 PERCENT OF RATED PEAK REVERSE VOLTAGE. (%) 125 100 8.3ms Single Half Sine Wave JEDEC Method 75 50 FIG.5- TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 25 400 0 1 2 5 10 20 50 100 200 NUMBER OF CYCLES AT 60Hz INSTANTANEOUS FORWARD CURRENT. (A) 100 FIG.4- TYPICAL JUNCTION CAPACITANCE JUNCTION CAPACITANCE.(pF) 120 100 80 60 40 f=10 MHz Vsig 50Mvp-p Tj=25 0C 40 20 10 4 Tj=25oC Pulse Width=300 s 1% Duty Cycle 2 1 0.4 20 0.2 0 0.1 0.5 1.0 4 10 40 REVERSE VOLTAGE. (V) 100 400 1000 0.1 .6 .8 1.0 1.2 1.4 1.6 1.8 2.0 FORWARD VOLTAGE. (V) Version: A06