UTC L1119L-50-TN3-G-R 1.5a low dropout regulator Datasheet

UNISONIC TECHNOLOGIES CO., LTD
L1119
CMOS IC
1.5A LOW DROPOUT
REGULATORS
1
1
DESCRIPTION
TO-252
SOT-223
The UTC L1119 is a fast ultra low-dropout linear regulator that
developed in CMOS process which allows low quiescent current
operation independent of output load current. This CMOS process
also allows the device to operate under extremely low dropout
conditions.
The UTC L1119 allows to operate from a 2.5V~7.0V input supply.
Wide range of preset output voltage options are available and
respond very fast to step changes in load which makes them
suitable for low voltage microprocessor applications.
FEATURES
1
SOT-89
*Pb-free plating product number: L1119L-xx
* Low ground current
* Load regulation of 0.04%
* Output current of 1.5A DC is guaranteed
* Accurate output voltage.(± 1.5%)
* Extremely low output capacitor requirements
* Over temperature/ Over current protection
ORDERING INFORMATION
Order Number
Normal
Lead Free Plating
L1119-xx-AA3-A-R
L1119L-xx-AA3-A-R
L1119-xx-AA3-C-R
L1119L-xx-AA3-C-R
L1119-xx-AB3-A-R
L1119L-xx-AB3-A-R
L1119-xx-AB3-B-R
L1119L-xx-AB3-B-R
L1119-xx-AB3-C-R
L1119L-xx-AB3-C-R
L1119-xx-AB3-D-R
L1119L-xx-AB3-D-R
L1119-xx-TN3-D-R
L1119L-xx-TN3-D-R
L1119-xx-TN3-D-T
L1119L-xx-TN3-D-T
Note: Pin assignment: I: VIN O: VOUT G:GND
L1119L-xx-AA3-A-R
(1)Packing Type
(2)Pin Assignment
(3)Package Type
(4)Output Voltage Code
(5)Lead Plating
www.unisonic.com.tw
Copyright © 2005 Unisonic Technologies Co., Ltd
Package
SOT-223
SOT-223
SOT-89
SOT-89
SOT-89
SOT-89
TO-252
TO-252
Pin Assignment
1
2
3
G
O
I
G
I
O
G
O
I
O
G
I
G
I
O
I
G
O
I
G
O
I
G
O
Packing
Tape Reel
Tape Reel
Tape Reel
Tape Reel
Tape Reel
Tape Reel
Tape Reel
Tube
(1) R: Tape Reel, T: Tube
(2) refer to Pin Assignment
(3) AA3: SOT-223, AB3: SOT-89, TN3: TO-252
(4) xx: refer to Marking Information
(5) L: Lead Free Plating, Blank: Pb/Sn
1 of 7
QW-R502-051,B
L1119
CMOS IC
MARKING INFORMATION
PACKAGE
VOLTAGE CODE
MARKING
L1119
SOT-223
VOLTAGE
CODE
DATE CODE
1
SOT-89
LEAD PLATING
PIN CODE
12
15
18
25
33
50
:1.2V
:1.5V
:1.8V
:2.5V
:3.3V
:5.0V
2
3
PIN CODE
VOLTAGE CODE
DATE CODE
L1119
1
2
LEAD PLATING
3
UTC
L1119
TO-252
LEAD PLATING
PIN CODE
VOLTAGE
CODE
DATE CODE
1
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
2
3
2 of 7
QW-R502-051,B
L1119
CMOS IC
BLOCK DIAGRAM
VIN
VOUT
-
+
GND
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
3 of 7
QW-R502-051,B
L1119
CMOS IC
ABSOLUTE MAXIMUM RATINGS
PARAMETER
SYMBOL
RATINGS
UNIT
Input Supply Voltage
VIN
-0.3 ~ +7.5
V
Output Voltage
VOUT
-0.3 ~ +7.5
V
Output Current
IOUT
Short Circuit Protected
Power Dissipation
PD
Internally Limited
℃
Operating Junction Temperature
TOPR
-40 ~ +125
Storage Temperature
TSTG
-65 ~ +150
℃
Note Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
RECOMMENDED OPERATING RATINGS
PARAMETER
SYMBOL
RATINGS
UNIT
Input Supply Voltage
VIN
2.5 ~ 7.0
V
Maximum Operating Current (DC)
IOPR(MAX)
1.5
A
Operating Junction Temperature
TJ
-40 ~ +125
℃
Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
ELECTRICAL CHARACTERISTICS
(TJ=25°C, VIN =VOUT+1V, IL=10mA, COUT=33µF, unless otherwise specified.)
PARAMETER
Dropout Voltage (Note)
Peak Output Current
SYMBOL
VD
IPEAK
Ground Pin Current
IGND
Output Voltage Tolerance
VOUT
Line Regulation
Load Regulation
SHORT CIRCUIT PROTECTION
Short Circuit Current
AC PARAMETERS
Output Noise Density
TEST CONDITIONS
IL = 150 mA
IL = 1.5 A
∆VOUT
∆VOUT
2.0
IL = 150 mA
IL = 1.5 A
10 mA ≤ IL ≤ 1.5A
VOUT +1 ≤ VIN≤ 7.0V
VOUT+1V<VIN<7.0V
10 mA < IL < 1.5 A
ISC
ρN(l/f)
Output Noise Voltage
eN
Ripple Rejection
RR
MIN
f = 120Hz
BW = 10Hz – 100kHz
BW = 300Hz – 300kHz
VIN = VOUT + 1.5V
COUT =100uF, VOUT = 3.3V
VIN = VOUT + 0.3V
COUT =100uF, VOUT = 3.3V
-1.5
TYP
38
870
2.5
4
5
MAX
45
UNIT
9
14
mA
0
+1.5
%
mV
A
0.1
1.5
%
%
4.5
A
0.8
150
100
µV
µV(rms)
60
dB
40
OVER TEMPERATURE PROTECTION
Shutdown Threshold
TSHDN
165
°C
Thermal Shutdown Hysteresis
THYS
10
°C
Note: Dropout voltage is defined as the minimum input to output differential voltage at which the output drops 2%
below the nominal value. Dropout voltage specification applies only to output voltages of 2.5V and above. For
output voltages below 2.5V, the drop-out voltage is nothing but the input to output differential, since the
minimum input voltage is 2.5V.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
4 of 7
QW-R502-051,B
L1119
CMOS IC
TYPICAL CHARACTERISTICS
(VIN=VOUT+1V, VOUT=2.5V, COUT=33µF, IOUT =10mA, CIN=68µF, Ta=25°C.)
Drop-Out Voltage vs Temperature (IL)
Drop-Out Voltage vs Temperature (VOUT)
0.25
0.225
IOUT=800mA
IL =800mA
0.2
VOUT=3.3V
0.2
Drop-Out (V)
Drop-Out (V)
VOUT=2.5V
0.15
0.1
0.175
VOUT=5V
0.15
0.05
IL =100mA
0
-40 -20
0
20
40
60
0.125
-40 -20
80 100 120 140
0
20
40
60
80 100 120 140
Temperature (℃)
Temperature (℃)
△VOUT vs Temperature
Noise Density
0.00
10
VIN=3.5V, VOUT=2.5V, I L=10mA
-0.10
-0.30
Noise (μV/ Hz )
Delta VOUT (%)
-0.20
-0.40
-0.50
-0.60
1.000
0.100
-0.70
-0.80
0.010
-0.90
-75
-50
-25
0
25
50
75
100 125
10
100
1000
10000
100000
Frequency (Hz)
Temperature (℃)
Input Voltage vs Output Voltage
3
2.5
VOUT (V)
2
IL=100mA
1.5
1
I L=800mA
0.5
0
0
1
2
3
4
VIN (V)
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
5 of 7
QW-R502-051,B
L1119
CMOS IC
TYPICAL CHARACTERISTICS(Cont.)
Output Noise Density
10
Output Noise Density
10
VOUT=2.5V
VOUT=5V
1
0.1
1
Noise (μV/ Hz)
Noise (μV/ Hz)
COUT=33μF
COUT=33μF
0.1
COUT=68μF
0.01
COUT=68μF
0.01
100
1000
10000
100
100000
1000
10000
100000
Frequency (Hz)
Frequency (Hz)
Ripple Rejection vs Frequency
Load Transient Response
90
Ripple Rejection (dB)
VOUT (V)
COUT=100μF
I L=800mA
70
3.5
3.4
3.3
3.2
2
I OUT (A)
COUT=100μF
IL =10mA
80
3.6
60
COUT=68μF
IL =10mA
50
40
30
20
10
0
-10
0
10
20μs/DIV
100
1K
10K
100K
1M
Frequency (Hz)
3.5
3.4
3.3
3.3
3.2
3.2
5.4
5.3
VIN (V)
VIN (V)
Line Transient Response
VOUT (V)
VOUT (V)
Line Transient Response
4.4
10μs/DIV
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
4.3
10μs/DIV
6 of 7
QW-R502-051,B
L1119
CMOS IC
TYPICAL CHARACTERISTICS(Cont.)
Line Transient Response
Line Transient Response
3.45
I OUT=1.5A
IOUT=1.5A
3.4
3.35
VOUT (V)
VOUT (V)
3.35
3.3
3.25
3.3
3.25
3.2
VIN (V)
VIN (V)
3.15
5.3
5.3
4.3
4.3
10μs/DIV
10μs/DIV
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
7 of 7
QW-R502-051,B
Similar pages