GMT G691L263T71 Microprocessor reset ic Datasheet

G690/G691
Global Mixed-mode Technology
Microprocessor Reset IC
Features
General Description
„ Precision Monitoring of +3V, +3.3V, and +5V
The G690/G691 are microprocessor (µP) supervisory
circuits used to monitor the power supplies in µP and
digital systems. They provide excellent circuit reliability
and low cost by eliminating external components and
adjustments when used with +5V, +3.3V, +3.0V- powered circuits.
Power-Supply Voltages
„ Fully Specified Over Temperature
„ Available in Three Output Configurations
„
„
„
„
„
„
Push-Pull RESET Output (G690L)
Push-Pull RESET Output (G690H)
Open-Drain RESET Output (G691L)
140ms min Power-On Reset Pulse Width
10µA Supply Current
Guaranteed Reset Valid to VCC = +1V
Power Supply Transient Immunity
No External Components
3-Pin SOT-23 and SC-70-3(SOT-323) Packages
These circuits perform a single function: they assert a
reset signal whenever the VCC supply voltage declines
below a preset threshold, keeping it asserted for at
least 140ms after VCC has risen above the reset
threshold. Reset thresholds suitable for operation with
a variety of supply voltages are available.
The G691L has an open-drain output stage, while the
G690 have push-pull outputs. The G691L’s open-drain
RESET output requires a pull-up resistor that can be
connected to a voltage higher than VCC. The G690L
have an active-low RESET output, while the G690H
has an active-high RESET output. The reset comparator is designed to ignore fast transients on VCC,
and the outputs are guaranteed to be in the correct
logic state for VCC down to 1V.
Applications
„ Computers
„ Controllers
„ Intelligent Instruments
„ Critical µP and µC Power Monitoring
„ Portable / Battery-Powered Equipment
„ Automotive
Low supply current makes the G690/G691 ideal for use
in portable equipment. The G690/G691 are available in
3-pin SOT-23 and SC-70-3(SOT-323) packages.
Pin Configuration
Typical Application Circuit
VCC
3
VCC
VCC
RPULL-UP*
G690/G691
RESET
(RESET)
1
GND
2
µP
RESET
INPUT
GND
SOT-23/SC-70-3(SOT-323)
*G691 ONLY
ICC may increased at high TA, Therefore, can not connect
Resistors to VCC to prevent Icc abnormal behavior at high TA.
TEL: 886-3-5788833
http://www.gmt.com.tw
Ver: 2.7
Oct 11, 2013
1
Similar pages