IRC TT CGH5-100-2205-G-LF Precision high-voltage thick film resistor Datasheet

Precision High-Voltage
Thick Film Resistors
$IAMOND SPIRALED
THICK FILM ELEMENT
CGH Series
(EAT CONDUCTING
CERAMIC SUBSTRATE
• 1/4 watt to 5 watt
• TCR of ±50 or ±100 ppm/°C
%POXY COATED BODY
(IGH CONDUCTIVITY • 100K ohm to 2000 megohm range
• ±0.5%, ±1%, ±2% or ±5% tolerance
!LL WELDED CAP AND LEAD CONSTRUCTION
4IN ,EAD ELECTROPLATED LEADS
Electrical Data
Power Rating
at 70°C (watts)¹
Voltage Rating
(volts)²
Resistance
Range (ohms)³
CGH - 1/4
1/4
750
100K - 100M
CGH - 1/2
1/2
1,500
100K - 500M
CGH - 1
1
3,000
50K - 750M
CGH - 2
2
5,000
100K - 1500M
CGH - 3
3
10,000
200K - 2000M
CGH - 5
5
20,000
300K - 2000M
IRC Type
Tolerance
(±%)4
Maximum TCR
(±ppm/°C)4
VCR (ppm/V)5
.5, 1, 2, 5
50, 100
0 - -5
Notes:
1. For power rating above 70°C, see derating curve.
2. Voltage rating shown is the rated DC continuous working voltage or the sine-wave RMS absolute maximum voltage at commercial line frequency. For DC applications the absolute maximum permissible voltage is 1.5 times the value shown for low repetition short-time-overload or
pulse conditions of 10 seconds or less duration.
3. Contact factory for higher resistance values.
4. For CGH-1 and 2 above 500 meg and CGH-3 and 5 above 1000M only 2 and 5% tolerance and 100 ppm/°C TCR available.
5. Typical voltage coefficient of resistance is -1 to -2 ppm/V measured at fulll rated voltage and 10% rated voltage.
Power Derating Curve
Temperature Rise Chart
100
100
CGH 1/4
90
80
% of Rated Power
% of Rated Power
90
70
60
50
40
30
20
CGH 2-3
80
CGH 1/2
70
CGH 5
60
CGH 1
50
40
30
20
10
10
0
80
100
120
140
160
180
Ambient Temperature (°C)
0
0
10
20
30
40
50
60
70
80
90
Temperature Rise (°C)
General Note
IRC reserves the right to make changes in product specification without notice or liability.
All information is subject to IRC’s own data and is considered accurate at time of going to print.
Wire and Film Technologies Division • 4222 South Staples Street • Corpus Christi Texas 78411 USA
Telephone: 361 992 7900 • Facsimile: 361 992 3377 • Website: www.irctt.com
A subsidiary of
TT electronics plc
CGH Series Issue June 2009 Sheet 1 of 3
Precision High-Voltage
Thick Film Resistors
Environmental Data
Maximum ΔR
(±3σ)
Typical² ΔR
Temperature Shock
±0.25%
±0.10%
Short-Time Overload (1.5 times rated V for 10 sec)
±0.20%
±0.10%
Solder Effect
±0.015%
±0.05%
Terminal Strength
±0.20%
±0.05%
Moisture Resistance (no load or polar)
±0.50%
±0.20%
Load Life (1000 hours at 70°C)
±1.00%
±0.25%
Shelf Life (1 year at 25°C)
±0.10%
±0.03%
High-Temperature Exposure (150°C for 2000 hours)
±0.75%
±0.30%
(175°C for 2000 hours)
±0.01%
±0.40%
Test Condition¹
Dielectric Breakdown³ (1/4 and 1/2 watt size)
2000 VDC, 1500 VAC
(1 watt through 5 watt size)
3500 VDC, 2500 VAC
Dielectric Strength4
Insulation Resistance at 500 VDC
±0.15%
±0.05%
109 ohms typ.
1011 ohms typ.
Notes:
1. Test method per MIL-STD-202 unless otherwise indicated.
2. Typical defined as that percent change which will include a minimum of 50% of the measured changes in resistance from a variety of lots
representing various unit sizes and ranges.
3. Values shown are the maximum safe dielectric voltage applied from a V block or foil wrapping which extends the complete body length of the
resistor under test.
4. Percent change after the maximum safe dielectric voltage is applied for 1 minute.
Wire and Film Technologies Division • 4222 South Staples Street • Corpus Christi Texas 78411 USA
Telephone: 361 992 7900 • Facsimile: 361 992 3377 • Website: www.irctt.com
CGH Series Issue June 2009 Sheet 2 of 3
Precision High-Voltage
Thick Film Resistors
Physical Data
1.50 ± 0.125
(38.1 ± 3.2)
BL
0.032 (0.81) DIA.
BD
CL
Dimensions (Inches and (mm))
IRC Type
Body Length - BL
Body Diameter - BD
Clean Lead to Clean Lead - CL
CGH - 1/4
0.275 ± 0.031 (6.98 ± 0.79)
0.088 ± 0.010 (2.22 ± 0.25)
0.400 (10.16)
CGH - 1/2
0.400 ± 0.031 (10.16 ± 0.79)
0.138 ± 0.016 (3.51 ± 0.41)
0.525 (13.34)
CGH - 1
0.690 ± 0.062 (17.53 ± 1.57)
0.297 ± 0.031 (7.54 ± 0.79)
0.900 (22.86)
CGH - 2
1.062 ± 0.062 (26.97 ± 1.57)
0.297 ± 0.031 (7.54 ± 0.79)
1.250 (31.75)
CGH - 3
2.062 ± 0.062 (52.37 ± 1.57)
0.297 ± 0.031 (7.54 ± 0.79)
2.250 (57.15)
CGH - 5
3.062 ± 0.062 (77.77 ± 1.57)
0.297 ± 0.031 (7.54 ± 0.79)
3.250 (82.55)
Ordering Data
Sample Part No.
CGH 3 - 100 - 2205 - F - LF
IRC Type
CGH 1/4, CGH 1/2, CGH 1, CGH 2, CGH 3, CGH 5
Temperature Coefficient
(±100 ppm/°C, ±50 ppm/°C)
Resistance
Tolerance
D = ±0.5%
F = ±1%
G = ±2%
J = ±5%
RoHS Indicator
LF indicates RoHS compliance
Wire and Film Technologies Division • 4222 South Staples Street • Corpus Christi Texas 78411 USA
Telephone: 361 992 7900 • Facsimile: 361 992 3377 • Website: www.irctt.com
CGH Series Issue June 2009 Sheet 3 of 3
Similar pages