PCA EPA3507G-440 Fast logic ttl compatible active delay line Datasheet

14 Pin DIP and SMD 5 Tap Both Edges Controlled
Fast Logic TTL Compatible Active Delay Lines
Compatible with standard auto-insertable equipment and can be used in either infrared or vapor phase process.
Input to Tap ± 5% or ± 2nS†
Tap to Tap ± 7% or ± 2nS†
Tap
Total
5, 10, 15, 20
6, 12, 18, 24
7, 14, 21, 28
8, 16, 24, 32
9, 18, 27, 36
10, 20, 30, 40
12, 24, 36, 48
15, 30, 45, 60
20, 40, 60, 80
25, 50, 75, 100
30, 60, 90, 120
35, 70, 105, 140
25
30
35
40
45
50
60
75
100
125
150
175
DIP Part
Number
SMD Part
Number
EPA3507-25
EPA3507-30
EPA3507-35
EPA3507-40
EPA3507-45
EPA3507-50
EPA3507-60
EPA3507-75
EPA3507-100
EPA3507-125
EPA3507-150
EPA3507-175
EPA3507G-25
EPA3507G-30
EPA3507G-35
EPA3507G-40
EPA3507G-45
EPA3507G-50
EPA3507G-60
EPA3507G-75
EPA3507G-100
EPA3507G-125
EPA3507G-150
EPA3507G-175
Input to Tap ± 5% or ± 2nS†
Tap to Tap ± 7% or ± 2nS†
Tap
Total
40, 80, 120, 160
45, 90, 135, 180
50, 100, 150, 200
60, 120, 180, 240
70, 140, 210, 280
80, 160, 240, 320
84, 168, 252, 336
88, 176, 264, 352
90, 180, 270, 360
84, 188, 282, 376
100, 200, 300, 400
200
225
250
300
350
400
420
440
450
470
500
DIP Part
Number
SMD Part
Number
EPA3507-200
EPA3507-225
EPA3507-250
EPA3507-300
EPA3507-350
EPA3507-400
EPA3507-420
EPA3507-440
EPA3507-450
EPA3507-470
EPA3507-500
EPA3507G-200
EPA3507G-225
EPA3507G-250
EPA3507G-300
EPA3507G-350
EPA3507G-400
EPA3507G-420
EPA3507G-440
EPA3507G-450
EPA3507G-470
EPA3507G-500
Delay measured @ 1.5V levels on leading and trailing edge w/ 15pF load on taps.
Rise and Fall Time measured from 0.75 to 2.4V level.
Electrical Characteristics
Schematic
Parameter
Test Conditions
Min. Max. Unit
†Whichever is greater.
VOH
VOL
VIK
IIH
IIL
IOS
High-Level Output Voltage
Low-Level Output Voltage
Input Clamp Voltage
High-Level Input Current
Low-Level Input Current
Short Circuit Output Current
VCC = Min. V IL = Max. I OH = Max. 2.7
V
VCC = Min. VIH = Min. I OL= Max.
0.5
V
VCC = Min. II = IIK
-1.2
V
VCC = Max. V IN = 2.7V
20
µA
VCC = Max. V IN = 0.5V
-0.6
mA
VCC = Max. V OUT = 0.
-60 -150
mA
(One output at a time)
I CCH High-Level Supply Current VCC = Max. V IN = OPEN
25
mA
ICCL Low-Level Supply Current
VCC = Max. V IN = 0
40
mA
TRO Output Rise Time
Td ≤ 500 nS (0.75 to 2.4 Volts)
4
nS
Td > 500 nS
5
nS
NH
Fanout High-Level Output
VCC = Max. V OH = 2.7V
20 TTL LOAD
NL
Fanout Low-Level Output
VCC = Max. V OL = 0.5V
10 TTL LOAD
TC
Temp. Coeff. of Total Delay 100 + (25000/TD) PPM/°C
TSTG Storage Temp. Range
-20 °C to +100 °C
Input Pulse Test Conditions @ 25° C
EIN
PW
TRI
PRR
VCC
Pulse Input Voltage
Pulse Width 1.2X Total Delay
Pulse Rise Time (10 - 90%)
Pulse Repetition Rate 4X P W
Supply Voltage
3.2
--3.0
--5.0
Volts
nS
nS
MHz
Volts
4
10
6
8
OUTPUT
INPUT 1
7 GROUND
Recommended
Operating Conditions
VCC
VIH
VIL
IIK
IOH
IOL
PW*
d*
TA
Min. Max. Unit
Supply Voltage
4.75 5.25
High-Level Input Voltage
2.0
Low-Level Input Voltage
0.8
Input Clamp Current
-18
High-Level Output Current
-1.0
Low-Level Output Current
20
Input Pulse Width of Total Delay 40
Duty Cycle
50
Operating Free-Air Temperature 0
+70
V
V
V
mA
mA
mA
%
%
°C
DIP Package
.085
Typ.
PCA
EPA3507G-XX
Date Code
.300
Typ.
.200
.270
Suggested Solder
Pad Layout
.200
.055
PCA
EPA3507-XX
Date Code
Pin 1
I.D.
.420
.200
Typ.
.300
.300
.030
.010
± .005
.215
.010
Typ.
0°-8°
.035
.380
.100
Typ.
DSA3507G-XX & DSA3507-XX
.280
Max.
.100
.780 Max.
.770
.019
± .002
12
VCC
*These two values are inter-dependent.
SMD Package
Pin 1
I.D.
Unit
14
.020
Min.
.250
Max.
.020
Typ.
.125 ± .010
Rev. - 7/22/98
Unless Otherwise Noted Dimensions in Inches
Tolerances:
Fractional = ± 1/32
.XX = ± .030
.XXX = ± .010
.365
Max.
.010
Typ.
QAF-CSO1 Rev. B 8/25/94
ELECTRONICS
INC.
16799 SCHOENBORN ST.
NORTH HILLS, CA 91343
TEL: (818) 892-0761
FAX: (818) 894-5791
Similar pages