MOTOROLA MCR100-4 Silicon controlled rectifiers(reverse blocking triode thyristors) Datasheet

Order this document
by MCR100/D
SEMICONDUCTOR TECHNICAL DATA
Reverse Blocking Triode Thyristors
*Motorola preferred devices
PNPN devices designed for high volume, line-powered consumer applications such
as relay and lamp drivers, small motor controls, gate drivers for larger thyristors, and
sensing and detection circuits. Supplied in an inexpensive plastic TO-226AA package
which is readily adaptable for use in automatic insertion equipment.
•
•
•
•
SCRs
0.8 AMPERE RMS
100 thru 600 VOLTS
Sensitive Gate Trigger Current — 200 µA Maximum
Low Reverse and Forward Blocking Current — 100 µA Maximum, TC = 125°C
Low Holding Current — 5 mA Maximum
Glass-Passivated Surface for Reliability and Uniformity
G
A
K
K
G
A
CASE 29-04
(TO-226AA)
STYLE 10
MAXIMUM RATINGS (TJ = 25°C unless otherwise noted.)
Rating
Peak Repetitive Forward and Reverse Blocking Voltage(1)
(TJ = 25 to 125°C, RGK = 1 kΩ
MCR100-3
MCR100-4
MCR100-6
MCR100-8
Forward Current RMS (See Figures 1 & 2)
(All Conduction Angles)
Symbol
VDRM
and
VRRM
Value
Unit
Volts
100
200
400
600
IT(RMS)
0.8
Amps
ITSM
10
Amps
I2t
0.415
A2s
PGM
0.1
Watts
PGF(AV)
0.01
Watt
Peak Gate Current — Forward, TA = 25°C
(300 µs, 120 PPS)
IGFM
1
Amp
Peak Gate Voltage — Reverse
VGRM
5
Volts
TJ
–40 to +125
°C
Tstg
–40 to +150
°C
—
+230
°C
Peak Forward Surge Current, TA = 25°C
(1/2 Cycle, Sine Wave, 60 Hz)
Circuit Fusing Considerations
(t = 8.3 ms)
Peak Gate Power — Forward, TA = 25°C
Average Gate Power — Forward, TA = 25°C
Operating Junction Temperature Range @ Rated VRRM and VDRM
Storage Temperature Range
Lead Solder Temperature
( 1/16I from case, 10 s max)
t
1. VDRM and VRRM for all types can be applied on a continuous basis. Ratings apply for zero or negative gate voltage; however, positive gate
voltage shall not be applied concurrent with negative potential on the anode. Blocking voltages shall not be tested with a constant current
source such that the voltage ratings of the devices are exceeded.
Preferred devices are Motorola recommended choices for future use and best overall value.
Motorola Thyristor Device Data
 Motorola, Inc. 1995
1
THERMAL CHARACTERISTICS
Symbol
Max
Unit
Thermal Resistance, Junction to Case
Characteristic
RθJC
75
°C/W
Thermal Resistance, Junction to Ambient
RθJA
200
°C/W
ELECTRICAL CHARACTERISTICS (TC = 25°C, RGK = 1 kΩ unless otherwise noted.)
Characteristic
Symbol
Peak Forward or Reverse Blocking Current
(VAK = Rated VDRM or VRRM)
Max
Unit
—
—
10
100
µA
µA
VTM
—
1.7
Volts
IDRM, IRRM
TC = 25°C
TC = 125°C
Forward “On” Voltage(1)
(ITM = 1 A Peak @ TA = 25°C)
Gate Trigger Current (Continuous dc)(2)
(Anode Voltage = 7 Vdc, RL = 100 Ohms)
TC = 25°C
IGT
—
200
µA
Gate Trigger Voltage (Continuous dc)
(Anode Voltage = 7 Vdc, RL = 100 Ohms)
(Anode Voltage = Rated VDRM, RL = 100 Ohms)
TC = 25°C
TC = –40°C
TC = 125°C
VGT
—
—
0.1
0.8
1.2
—
Volts
Holding Current
(Anode Voltage = 7 Vdc, initiating current = 20 mA)
TC = 25°C
TC = –40°C
IH
—
—
5
10
mA
1. Forward current applied for 1 ms maximum duration, duty cycle
2. RGK current is not included in measurement.
p 1%.
FIGURE 1 – MCR100-7, MCR100-8 CURRENT DERATING
(REFERENCE: CASE TEMPERATURE)
FIGURE 2 – MCR100-7, MCR100-8 CURRENT DERATING
(REFERENCE: AMBIENT TEMPERATURE)
120
120
α
α = CONDUCTION ANGLE
110
CASE MEASUREMENT
POINT — CENTER OF
FLAT PORTION
100
90
dc
80
70
α = 30°
60
60°
90°
120°
180°
50
α
α = CONDUCTION ANGLE
100
TYPICAL PRINTED
CIRCUIT BOARD
MOUNTING
80
60
dc
40
α = 30°
60° 90°
120°
180°
20
40
0
0.1
0.2
0.3
0.4
IT(AV), AVERAGE ON-STATE CURRENT (AMP)
2
TA , MAXIMUM ALLOWABLE AMBIENT
TEMPERATURE ( °C)
TC, MAXIMUM ALLOWABLE CASE TEMPERATURE (° C)
Min
0.5
0
0.1
0.2
0.3
0.4
IT(AV), AVERAGE ON-STATE CURRENT (AMP)
Motorola Thyristor Device Data
PACKAGE DIMENSIONS
A
B
R
STYLE 10:
PIN 1. CATHODE
2. GATE
3. ANODE
P
L
F
SEATING
PLANE
K
D
X X
G
J
H
V
C
SECTION X–X
1
NOTES:
1. DIMENSIONING AND TOLERANCING PER ANSI
Y14.5M, 1982.
2. CONTROLLING DIMENSION: INCH.
3. CONTOUR OF PACKAGE BEYOND DIMENSION R
IS UNCONTROLLED.
4. DIMENSION F APPLIES BETWEEN P AND L.
DIMENSION D AND J APPLY BETWEEN L AND K
MINIMUM. LEAD DIMENSION IS UNCONTROLLED
IN P AND BEYOND DIMENSION K MINIMUM.
N
N
DIM
A
B
C
D
F
G
H
J
K
L
N
P
R
V
INCHES
MIN
MAX
0.175
0.205
0.170
0.210
0.125
0.165
0.016
0.022
0.016
0.019
0.045
0.055
0.095
0.105
0.015
0.020
0.500
–––
0.250
–––
0.080
0.105
–––
0.100
0.115
–––
0.135
–––
MILLIMETERS
MIN
MAX
4.45
5.20
4.32
5.33
3.18
4.19
0.41
0.55
0.41
0.48
1.15
1.39
2.42
2.66
0.39
0.50
12.70
–––
6.35
–––
2.04
2.66
–––
2.54
2.93
–––
3.43
–––
CASE 29-04
(TO–226AA)
Motorola Thyristor Device Data
3
Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding
the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and
specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters can and do vary in different
applications. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. Motorola does
not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in
systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of
the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such
unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless
against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death
associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part.
Motorola and
are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer.
Literature Distribution Centers:
USA: Motorola Literature Distribution; P.O. Box 20912; Phoenix, Arizona 85036.
EUROPE: Motorola Ltd.; European Literature Centre; 88 Tanners Drive, Blakelands, Milton Keynes, MK14 5BP, England.
JAPAN: Nippon Motorola Ltd.; 4-32-1, Nishi-Gotanda, Shinagawa-ku, Tokyo 141, Japan.
ASIA PACIFIC: Motorola Semiconductors H.K. Ltd.; Silicon Harbour Center, No. 2 Dai King Street, Tai Po Industrial Estate, Tai Po, N.T., Hong Kong.
4
◊
Motorola Thyristor Device Data
*MCR100/D*
MCR100/D
Similar pages