GOOD-ARK GBU8M Glass passivated single-phase bridge rectifiers reverse voltage 50 to 1000 volts forward current 8.0 ampere Datasheet

GBU8A thru GBU8M
Glass Passivated Single-Phase Bridge Rectifiers
Reverse Voltage 50 to 1000 Volts Forward Current 8.0 Amperes
Features
Ideal for printed circuit boards
High surge current capability
High case dielectric strength of 1500 VRMS
Solder Dip 260 °C, 40 seconds
Mechanical Data
Case: GBU
Epoxy meets UL-94V-0 Flammability rating
Terminals: Matte tin plated (E3 Suffix) leads, solderable per
J-STD-002B and JESD22-B102D
Polarity: As marked on body
Mounting Torque: 10 cm-kg (8.8 inches-lbs) max.
Recommended Torque: 5.7 cm-kg (5 inches-lbs)
Typical Applications
General purpose use in ac-to-dc bridge full wave rectification for
Monitor, TV, Printer, Switching Mode Power Supply, Adapter, Audio
equipment, and Home Appliances applications.
Package outline dimensions in inches (millimeters)
Maximum Ratings and Electrical Characteristics
TA = 25 oC, unless otherwise specified.
Parameter
Symbols
GBU8A
GBU8B
GBU8D
GBU8G
GBU8J
GBU8K
GBU8M
Units
Maximum repetitive peak reverse voltage
VRRM
50
100
200
400
600
800
1000
Volts
Maximum RMS voltage
VRMS
35
70
140
280
420
560
700
Volts
Maximum DC blocking voltage
V DC
50
100
200
400
600
800
1000
Volts
Maximum average forward
rectified output current at
TC=60oC (1)
TA=25oC (2)
Peak forward surge current, 8.3ms single half sine-wave
superimposed on rated load (JEDEC Method)
Rating for fusing (t<8.3ms)
Maximum instantaneous forward voltage drop per leg at 4.0A
Maximum DC reverse current
at rated DC blocking voltage per leg
TA=25oC
TA=125oC
Typical junction capacitance per leg at 4.0V, 1MHz
IF(AV)
8.0
3.0
Amps
IFSM
200.0
Amps
I2t
166
A 2 se c
VF
1.0
Volt
IR
5.0
500.0
CJ
211
94
Typical thermal resistance per leg
RθJA (2)
RθJC (1, 3)
20
4.0
Operating junction and storage temperature range
TJ, TSTG
-55 to +150
Notes:
uA
1. Units case mounted on 14x14x0.15cm thick Al plate heatsink
2. Units mounted in free air, no heatsink on P.C.B., 0.5 x 0.5" (13 x 13 mm) copper pads, 0.375" (9.5 mm) lead length
3. Recommended mounting position is to bolt down on heatsink with silicone thermal compound for maximum heat transfer with #6 screws
444
pF
o
C/W
o
C
RATINGS AND CHARACTERISTIC CURVES
(TA = 25oC unless otherwise noted)
445
Similar pages