SN54/74LS540 SN54/74LS541 OCTAL BUFFER/LINE DRIVER WITH 3-STATE OUTPUTS The SN54/ 74LS540 and SN54 / 74LS541 are octal buffers and line drivers with the same functions as the LS240 and LS241, but with pinouts on the opposite side of the package. These device types are designed to be used as memory address drivers, clock drivers and bus-oriented transmitters / receivers. These devices are especially useful as output ports for the microprocessors, allowing ease of layout and greater PC board density. OCTAL BUFFER/ LINE DRIVER WITH 3-STATE OUTPUTS LOW POWER SCHOTTKY • • • • Hysteresis at Inputs to Improve Noise Margin PNP Inputs Reduce Loading 3-State Outputs Drive Bus Lines Inputs and Outputs Opposite Side of Package, Allowing Easier Interface to Microprocessors • Input Clamp Diodes Limit High-Speed Termination Effects 20 LOGIC AND CONNECTION DIAGRAMS DIP (TOP VIEW) VCC 20 19 J SUFFIX CERAMIC CASE 732-03 1 SN54 / 74LS540 18 17 16 15 14 13 12 N SUFFIX PLASTIC CASE 738-03 11 20 1 1 2 VCC 20 19 3 4 5 6 7 8 9 10 GND 1 SN54 / 74LS541 18 17 16 15 14 DW SUFFIX SOIC CASE 751D-03 20 13 12 11 ORDERING INFORMATION SN54LSXXXJ Ceramic SN74LSXXXN Plastic SN74LSXXXDW SOIC 1 2 3 4 5 6 7 8 9 10 GND GUARANTEED OPERATING RANGES Symbol Parameter Min Typ Max Unit VCC Supply Voltage 54 74 4.5 4.75 5.0 5.0 5.5 5.25 V TA Operating Ambient Temperature Range 54 74 – 55 0 25 25 125 70 °C IOH Output Current — High 54 74 – 12 – 15 mA IOL Output Current — Low 54 74 12 24 mA FAST AND LS TTL DATA 5-568 SN54/74LS540 • SN54/74LS541 BLOCK DIAGRAM LS540 LS541 (1) E1 (1) E1 (19) E2 (2) (18) D1 (3) INPUTS (2) Y1 D1 Y2 D2 (17) D2 (4) (16) D3 D4 (19) E2 (5) Y3 D3 Y4 D4 (15) (6) (14) (7) (13) (8) (12) (9) (11) Y5 D5 D6 (3) (17) (4) (16) Y2 Y3 (5) (15) (6) (14) (7) (13) (8) (12) (9) (11) Y4 E2 D LS540 LS541 L H X L L X H L H X X L L Z Z H H Z Z L L = LOW Voltage Level H = HIGH Voltage Level X = Immaterial Z = High Impedance Y6 D7 Y8 E1 Y5 D6 Y7 D8 Y1 D5 Y6 D7 (18) OUTPUTS Y7 D8 Y8 DC CHARACTERISTICS OVER OPERATING TEMPERATURE RANGE (unless otherwise specified) Limits Symbol VIH Input HIGH Voltage VIL Input LOW Voltage VIK Input Clamp Diode Voltage VOH Output HIGH Voltage VOL Output LOW Voltage VT+–VT– Hysteresis IOZH Output Off Current HIGH IOZL Output Off Current LOW IIH Input HIGH Current IIL Input LOW Current IOS Short Circuit Current (Note 1) Power Supply Current Total, Output HIGH ICC Min Parameter Total, Output LOW Total Output 3-State Typ Max Unit 2.0 54 0.7 74 0.8 – 0.65 54, 74 2.4 54, 74 2.0 – 1.5 3.4 Test Conditions V Guaranteed Input HIGH Voltage for All Inputs V Guaranteed Input LOW Voltage for All Inputs V VCC = MIN, IIN = – 18 mA V VCC = MIN, IOH = – 3.0 mA V VCC = MIN, IOH = MAX, VIL = 0.5 V VCC = VCC MIN, VIN = VIL or VIH per Truth Table 54, 74 0.25 0.4 V IOL = 12 mA 74 0.35 0.5 V IOL = 24 mA V VCC = MIN 20 µA VCC = MAX, VOUT = 2.7 V – 20 µA VCC = MAX, VOUT = 0.4 V 20 µA VCC = MAX, VIN = 2.7 V 0.2 0.4 – 40 0.1 mA VCC = MAX, VIN = 7.0 V – 0.2 mA VCC = MAX, VIN = 0.4 V – 225 mA VCC = MAX mA LS540 25 LS541 32 mA LS540 45 mA LS541 52 mA LS540 52 mA LS541 55 mA Note 1: Not more than one output should be shorted at a time, nor for more than 1 second. FAST AND LS TTL DATA 5-569 VCC = MAX SN54/74LS540 • SN54/74LS541 AC CHARACTERISTICS (TA = 25°C) Limits Symbol Parameter tPLH tPLH tPHL Propagation Delay, Data to Output tPHL Typ Max LS540 Min 9.0 15 LS541 12 15 LS540 12 15 LS541 12 18 Unit Test Conditions ns Output Enable Time to HIGH Level LS540 15 25 tPZH LS541 15 32 Output Enable Time to LOW Level LS540 20 38 tPZL LS541 20 38 Output Disable Time to HIGH Level LS540 10 18 tPHZ LS541 10 18 LS540 15 25 tPLZ Output Disable Time to LOW Level LS541 15 29 VCC = 5.0 V CL = 45 pF RL = 667 Ω ns ns ns CL = 5.0 pF ns AC WAVEFORMS Figure 1 Ω Figure 2 ≈ SWITCH POSITIONS Figure 3 ≥ SYMBOL SW1 SW2 tPZH Open Closed tPZL Closed Open tPLZ Closed Closed tPHZ Closed Closed ≈ Figure 4 Figure 5 FAST AND LS TTL DATA 5-570 Case 751D-03 DW Suffix 20-Pin Plastic SO-20 (WIDE) "! ! " -A11 1 10 ! " # P C -T- " #! D J F K ! #! * * !" $ !" M * R X 45° " " %# G ! " ! -B- ! " 20 & ! ! ° ° ° ° ) ) ) ! Case 732-03 J Suffix 20-Pin Ceramic Dual In-Line "! ! $" '' " # !" " !" " %# 20 " 11 1 10 B L C F N H G D J M K Case 738-03 N Suffix 20-Pin Plastic ! ! ° ° ° ° ! " " ! ( " " B ! ! $ ! ( ! " # ! C -T- L K G ! & 11 E ! 10 1 #! !#! "! -A20 ! $ A " " " N M F J D " " FAST AND LS TTL DATA 5-571 * !" $ !" * ! ! ! ! ! ° ° ! ° ° Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters can and do vary in different applications. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. Motorola does not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer. SYMBOL SW1 SW2 tPLZ Closed Closed tPHZ Closed Closed Literature Distribution Centers: USA: Motorola Literature Distribution; P.O. Box 20912; Phoenix, Arizona 85036. tPZH Open Closed EUROPE: Motorola Ltd.; European Literature Centre; 88 Tanners Drive, Blakelands, Milton Keynes, MK14 5BP, England. JAPAN: Nippon Motorola Ltd.; 4-32-1, Nishi-Gotanda, Shinagawa-ku, Tokyo 141, Japan. tPZL Closed Open ASIA PACIFIC: Motorola Semiconductors H.K. Ltd.; Silicon Harbour Center, No. 2 Dai King Street, Tai Po Industrial Estate, Tai Po, N.T., Hong Kong. ◊ FAST AND LS TTL DATA 5-572