OptoSupply OSI3XNE1E1E Xeon 1 power infrared emitter led Datasheet

Xeon 1 Power Infrared Emitter
LED
OSI3XNE1E1E
VER C.2
■Features
■Outline
●
Highest luminous flux
●
Super energy efficiency
●
Very long operating life
●
Superior ESD protection
Dimension
■Applications
●
Night Vision
●
Camera
Anode
●
Outdoor./Indoor applications
Unit:mm
Tolerance:±0.30mm
Maximum Rating
Item
■Directivity
(Ta=25℃)
Symbol
Value
Unit
DC Forward Current
IF
1000
mA
Pulse Forward Current*
IFP
2000
mA
Reverse Voltage
VR
5
V
Power Dissipation
PD
1700
mW
Operating Temperature
Topr
-30 ~ +85
℃
Storage Temperature
Tstg
-40~ +100
℃
Lead Soldering Temperature
Tsol
260℃/5sec
-
*Pulse width Max.10ms
■Electrical
0
Duty ratio max 1/10
-Optical Characteristics
■Forward
(Ta=25℃)
Item
Symbol
Condition
Min.
Typ.
Max.
Unit
DC Forward Voltage
VF
IF=350mA
-
1.5
1.7
V
DC Reverse Current
0
IR
VR=5V
-
-
10
µA
Peak Wavelength
λP
IF=350mA
-
850
-
nm
Radiant Power
PO
IF=350mA
110
-
-
mW
1000
Rth(J-a)=20℃/W
800
600
2θ1/2
IF=350mA
-
140
-
Note: Advises please attach heat sink to use if Power Dissipation is more than 0.5W.
LED & Application Technologies
deg
Rth(J-a)=30℃/W
Rth(J-a)=40℃/W
400
200
0
0
50% Power Angle
Operating Current (DC)
1200
Forward Current, IF (mA)
■Absolute
Cathode
20
40
60
Ambient Temperature, TA (
80
)
100
Xeon 1 Power Infrared Emitter
LED
OSI3XNE1E1E
VER C.2
■ Soldering Heat Reliability :
Reflow soldering Profile
· Reflow soldering should not be done more than two times.
· When soldering, do not put stress on the LEDs during heating.
· After soldering, do not warp the circuit board.
· Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable,
a double-head soldering iron should be used. It should be confirmed beforehand whether the
characteristics of the LEDs will or will not be damaged by repairing.
Solder
Average ramp-up rate = 3ºC/sec. max.
Preheat temperature: 150º~180ºC
Preheat time = 120 sec. max.
Ramp-down rate = 6ºC/sec. max.
Peak temperature = 220ºC max.
Time within 3ºC of actual
peak temperature = 25 sec. max.
Duration above 200ºC is 40 sec. max.
LED & Application Technologies
Similar pages