74F11 Triple 3-Input AND Gate tm General Description This device contains three independent gates, each of which performs the logic AND function. Ordering Information Order Number Package Number Package Description 74F11SC M14A 14-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-012, 0.150" Narrow 74F11SJ M14D 14-Lead Small Outline Package (SOP), EIAJ TYPE II, 5.3mm Wide Devices also available in Tape and Reel. Specify by appending the suffix letter “X” to the ordering number. Connection Diagram Logic Symbol IEEE/IEC Unit Loading/Fan Out Pin Names An, Bn, Cn On ©1988 Fairchild Semiconductor Corporation 74F11 Rev. 1.3 Description U.L. HIGH/LOW Input IIH/IIL, Output IOH/IOL Inputs 1.0 / 1.0 20 µA / –0.6mA Outputs 50 / 33.3 –1 mA / 20 mA www.fairchildsemi.com 74F11 Triple 3-Input AND Gate May 2007 Stresses exceeding the absolute maximum ratings may damage the device. The device may not function or be operable above the recommended operating conditions and stressing the parts to these levels is not recommended. In addition, extended exposure to stresses above the recommended operating conditions may affect device reliability. The absolute maximum ratings are stress ratings only. Symbol TSTG Parameter Rating Storage Temperature –65°C to +150°C TA Ambient Temperature Under Bias –55°C to +125°C TJ Junction Temperature Under Bias –55°C to +150°C VCC VCC Pin Potential to Ground Pin –0.5V to +7.0V VIN Input Voltage(1) –0.5V to +7.0V IIN Input Current(1) –30mA to +5.0mA VO Voltage Applied to Output in HIGH State (with VCC = 0V) Standard Output –0.5V to VCC 3-STATE Output –0.5V to 5.5V Current Applied to Output in LOW State (Max.) twice the rated IOL (mA) Note: 1. Either voltage limit or current limit is sufficient to protect inputs. Recommended Operating Conditions The Recommended Operating Conditions table defines the conditions for actual device operation. Recommended operating conditions are specified to ensure optimal performance to the datasheet specifications. Fairchild does not recommend exceeding them or designing to absolute maximum ratings. Symbol TA VCC Parameter Rating Free Air Ambient Temperature 0°C to +70°C Supply Voltage ©1988 Fairchild Semiconductor Corporation 74F11 Rev. 1.3 +4.5V to +5.5V www.fairchildsemi.com 2 74F11 Triple 3-Input AND Gate Absolute Maximum Ratings Symbol Parameter VCC Conditions Min. Typ. Max. 2.0 Units V VIH Input HIGH Voltage Recognized as a HIGH Signal VIL Input LOW Voltage Recognized as a LOW Signal 0.8 V VCD Input Clamp Diode Voltage Min. IIN = –18mA –1.2 V VOH Output HIGH Voltage Min. IOH = –1mA 2.5 IOH = –1mA 2.7 VOL Output LOW Voltage IIH 10% VCC 5% VCC V Min. IOL = 20mA 0.5 V Input HIGH Current Max. VIN = 2.7V 5.0 µA IBVI Input HIGH Current Breakdown Test Max. VIN = 7.0V 7.0 µA ICEX Output HIGH Leakage Current Max. VOUT = VCC 50 µA VID Input Leakage Test 0.0 IID = 1.9µA, All other pins grounded IOD Output Leakage Circuit Current 0.0 VIOD = 150mV, All other pins grounded 3.75 µA IIL Input LOW Current VIN = 0.5V –0.6 mA 10% VCC Max. 4.75 V IOS Output Short-Circuit Current Max. VOUT = 0V –150 mA ICCH Power Supply Current Max. VO = HIGH 4.1 6.2 mA ICCL Power Supply Current Max. VO = LOW 6.5 9.7 mA –60 AC Electrical Characteristics TA = +25°C, VCC = +5.0V, CL = 50pF Symbol tPLH tPHL Parameter Propagation Delay, An, Bn, Cn to On ©1988 Fairchild Semiconductor Corporation 74F11 Rev. 1.3 TA –55°C to +125°C, VCC = +5.0V, CL = 50pF Min. Typ. Max. Min. Max. TA = 0°C to +70°C, VCC = +5.0V, CL = 50pF Min. Max. Units ns 3.0 4.2 5.6 2.5 7.5 3.0 6.6 2.5 4.1 5.5 2.0 7.5 2.5 6.5 www.fairchildsemi.com 3 74F11 Triple 3-Input AND Gate DC Electrical Characteristics 74F11 Triple 3-Input AND Gate Physical Dimensions Dimensions are in millimeters unless otherwise noted. Figure 1. 14-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-012, 0.150" Narrow Package Number M14A ©1988 Fairchild Semiconductor Corporation 74F11 Rev. 1.3 www.fairchildsemi.com 4 74F11 Triple 3-Input AND Gate Physical Dimensions (Continued) Dimensions are in millimeters unless otherwise noted. Figure 2. 14-Lead Small Outline Package (SOP), EIAJ TYPE II, 5.3mm Wide Package Number M14D ©1988 Fairchild Semiconductor Corporation 74F11 Rev. 1.3 www.fairchildsemi.com 5 ® ACEx Across the board. Around the world.™ ActiveArray™ Bottomless™ Build it Now™ CoolFET™ CROSSVOLT™ CTL™ Current Transfer Logic™ DOME™ 2 E CMOS™ ® EcoSPARK EnSigna™ FACT Quiet Series™ ® FACT ® FAST FASTr™ FPS™ ® FRFET GlobalOptoisolator™ GTO™ HiSeC™ i-Lo™ ImpliedDisconnect™ IntelliMAX™ ISOPLANAR™ MICROCOUPLER™ MicroPak™ MICROWIRE™ Motion-SPM™ MSX™ MSXPro™ OCX™ OCXPro™ ® OPTOLOGIC ® OPTOPLANAR PACMAN™ PDP-SPM™ POP™ ® Power220 ® Power247 PowerEdge™ PowerSaver™ Power-SPM™ ® PowerTrench Programmable Active Droop™ ® QFET QS™ QT Optoelectronics™ Quiet Series™ RapidConfigure™ RapidConnect™ ScalarPump™ SMART START™ ® SPM STEALTH™ SuperFET™ SuperSOT™-3 SuperSOT™-6 SuperSOT™-8 SyncFET™ TCM™ ® The Power Franchise TinyBoost™ TinyBuck™ ® TinyLogic TINYOPTO™ TinyPower™ TinyWire™ TruTranslation™ µSerDes™ ® UHC UniFET™ VCX™ Wire™ ™ DISCLAIMER FAIRCHILD SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. FAIRCHILD DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS. THESE SPECIFICATIONS DO NOT EXPAND THE TERMS OF FAIRCHILD’S WORLDWIDE TERMS AND CONDITIONS, SPECIFICALLY THE WARRANTY THEREIN, WHICH COVERS THESE PRODUCTS. LIFE SUPPORT POLICY FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF FAIRCHILD SEMICONDUCTOR CORPORATION. As used herein: 1. Life support devices or systems are devices or systems which, (a) are intended for surgical implant into the body or (b) support or sustain life, and (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in a significant injury of the user. 2. A critical component in any component of a life support, device, or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness. PRODUCT STATUS DEFINITIONS Definition of Terms Datasheet Identification Product Status Advance Information Formative or In Design This datasheet contains the design specifications for product development. Specifications may change in any manner without notice. Definition Preliminary First Production This datasheet contains preliminary data; supplementary data will be published at a later date. Fairchild Semiconductor reserves the right to make changes at any time without notice to improve design. No Identification Needed Full Production This datasheet contains final specifications. Fairchild Semiconductor reserves the right to make changes at any time without notice to improve design. Obsolete Not In Production This datasheet contains specifications on a product that has been discontinued by Fairchild Semiconductor. The datasheet is printed for reference information only. Rev. I26 ©1988 Fairchild Semiconductor Corporation 74F11 Rev. 1.3 www.fairchildsemi.com 6 74F11 Triple 3-Input AND Gate TRADEMARKS The following are registered and unregistered trademarks Fairchild Semiconductor owns or is authorized to use and is not intended to be an exhaustive list of all such trademarks.