UNISONIC TECHNOLOGIES CO., LTD 3510 CMOS IC PC POWER SUPPLY SUPERVISORS DESCRIPTION The UTC 3510 is designed to provide protection circuits, power good output (PGO) indicator, fault protection output (FPO) and a PSON control for PC switching power supply systems. The protection circuits include over voltage protection (OVP) monitoring for 3.3V, 5V and 12V (12V via VDD pin) and under voltage protection(UVP) monitoring for 3.3V and 5V. When an OV or UV event arose and is detected, the power good output (PGO) goes low and the FPO will be set to high. The protection latch can be reset by setting PSON to high. UVP function is enabled 75ms after PSON is set low and de-bounced. Besides, there is a 2.3ms delay with 38ms de-bounce at turn off but no delay during turn on. When OVP and UVP detected the right voltage level, a PGO signal will be issued. FEATURES * Over Voltage Protection and Lock Out for 3V, 5V and 12V. * Under Voltage Protection and Lock Out for 3.3V and 5V. * Open Drain Output for PGO and FPO pin. * 300ms delay for PGO. * 75ms delay for 3.3V and 5V short-circuit turn-on protection. * 2.3ms PSON control to FPO turn-off delay. * 38ms PSON control de-bounce. * 73us width noise deglitches. * Wide supply voltage range from 4V ~15V. ORDERING INFORMATION Ordering Number Lead Free 3510L-D08-T 3510L-S08-R 3510L-S08-T Halogen Free 3510G-D08-T 3510G-S08-R 3510G-S08-T www.unisonic.com.tw Copyright © 2012 Unisonic Technologies Co., Ltd Package Packing DIP-8 SOP-8 SOP-8 Tube Tape Reel Tube 1 of 8 QW-R502-408.D 3510 CMOS IC PIN CONFIGURATION PIN DESCRIPTION PIN No. 1 2 3 4 5 6 7 8 PIN NAME PGI GND FPO PSON VS33 VS5 VDD PGO TYPE I O I I I I O DESCRIPTION Power good input Ground Fault protection output(invert), open drain output stage ON/OFF control 3.3V over/under-voltage protection 5V over/under-voltage protection Supply voltage/12V over-voltage protection input pin Power good output, open drain output stage UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 8 QW-R502-048.D 3510 CMOS IC BLOCK DIAGRAM UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 8 QW-R502-048.D 3510 CMOS IC ABSOLUTE MAXIMUM RATINGS PARAMETER SYMBOL VDD RATINGS UNIT 16 V FPO 16 Output Voltage VOUT V PGO 8 All Other Pins -0.3 ~ 16 V DIP-8 1092 Power Dissipation (TA≤25°C) PD mW SOP-8 730 ℃ Operating Temperature TOPR -20 ~ +85 ℃ Storage Temperature TSTG -40 ~ +150 Note: 1. Absolute maximum ratings are stress ratings only and functional device operation is not implied. The device could be damaged beyond Absolute maximum ratings. 2. The device is guaranteed to meet performance specifications within 0℃~+70℃ operating temperature range and assured by design from -20℃~+85℃. Supply Voltage RECOMMENDED OPERATING CONDITIONS PARAMETER SYMBOL VDD Supply Voltage MIN 4 PSON, VS5, VS33 VIN PGI FPO Output Voltage VOUT PGO FPO Output Sink Current IO(SINK) PGO Supply Voltage Rising Time (See Note) Note: VDD rising and falling slew rate must be less than 14V/ms. Input Voltage TYP VDD+0.3V MAX 15 7 7 15 7 20 10 UNIT V V V mA 1 ms ELECTRICAL CHARACTERISTICS (TA=25°C ,unless otherwise specified.) PARAMETER OVER-VOLTAGE PROTECTION SYMBOL VS33 VS5 VDD VOL ILEAK Over Voltage Threshold Low-level Output Voltage (FPO) Leakage Current (FPO) Noise Deglitch Time OVP PGI AND PGO Input threshold Voltage PGI VPGI VPG2 Under Voltage Threshold VS33 VS5 VIT Low-level Output Voltage (PGO) Leakage Current (PGO) Short-Circuit Protection Delay Transient Delay time Noise Deglitch Time VOL ILEAK 3.3V, 5V PGI to PGO PGI to FPO PGI to PGO PGI to FPO UVP to FPO tDLY1 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw TEST CONDITIONS VDD =5V, IO(SINK) =20mA V(FPO) =5V VDD =5V MIN TYP MAX 3.7 5.7 13.0 3.9 6.1 13.8 4.1 6.5 14.4 0.7 5 110 35 73 1.1 0.9 2 3.3 1.15 0.95 2.2 3.5 VDD =4V, IO(SINK) =10mA PGO = 5 V VDD = 5 V VDD = 5 V 49 200 3.2 88 180 82 75 300 4.8 150 296 146 1.2 1 2.4 3.7 0.4 5 114 450 7.2 225 445 220 UNIT V V μA μS V V V μA ms ms μs 4 of 8 QW-R502-048.D 3510 CMOS IC ELECTRICAL CHARACTERISTICS(Cont.) PARAMETER PSON CONTROL Input Voltage SYMBOL High-level Low-level Input Pullup Current Debounce Time (PSON) Transient Delay Time (PSON to FPO) TOTAL DEVICE Supply Current VIH VIL IIN tB MIN TYP MAX UNIT 2.4 57 tB+4 V V μA ms ms 1 mA 1.2 tDLY2 PSON = 0 V VDD = 5 V VDD = 5 V IDD PSON =5V UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw TEST CONDITIONS 120 24 38 tB+1.1 tB+2.3 5 of 8 QW-R502-048.D 3510 CMOS IC TIMING DIAGRAM TYPICAL APPLICATION 5 VSB PGI PGO 12V 1 2 3 PSON (From Motherboard) 4 PGI PGO GND FPO VDD VS5 PSON VS33 UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 8 7 6 5 0.5 V Drop VSB 5V 3.3V 6 of 8 QW-R502-048.D 3510 CMOS IC TYPICAL CHARACTERISTICS LOW-LEVEL OUTPUT VOLTAGE (FPO) vs LOW-LEVEL OUTPUT CURRENT (FPO) 4 LOW-LEVEL OUTPUT VOLTAGE (FPO) vs LOW-LEVEL OUTPUT CURRENT (FPO) 800 VDD=4V 700 PSON=GND Exploded View VDD=4V PSON=GND 600 3 500 2 400 300 0 200 Ta = 85°C Ta = 25°C Ta = -20°C 1 100 0 0 20 40 60 80 100 Low-Level Output Current, IOL (mA) UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw Ta = 85°C Ta = 25°C Ta = -20°C 0 5 10 15 20 25 Low-Level Output Current, IOL (mA) 7 of 8 QW-R502-048.D 3510 CMOS IC UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 8 of 8 QW-R502-048.D