MODEL 22 3 mm Single Turn Sealed Surface Mount Cermet Trimming Potentiometer MODELS AVAILABLE J Hook 22A Side Mount 22S ELECTRICAL1 Resistance Range 10 Ohm to 2 Megohms Standard Resistance Tolerance ± 20% Input Voltage, Maximum 200 Vdc or rms, not to exceed power rating Power rating, Watts 0.125 @ 70°C, derating to 0 @ 125°C End Resistance, Maximum 1% or 3 Ohms, whichever is greater Actual Electrical Travel, Nominal 220° Dielectric Strength 500 V rms Insulation Resistance, Minimum 100 Megohms Resolution Essentially infinite Contact Resistance Variation, Maximum 3% or 3 Ohms, whichever is greater Temperature Coefficient of Resistance ±100 ppm/°C (less than 100 ohms: ±150 ppm/°C) MECHANICAL Mechanical Stop Solid Static Stop Strength 1.3 in. oz. Torque, Maximum 0.65 in. oz. Weight, Nominal 0.002 oz. Wiper Position 1 Approx. 50% Specifications subject to change without notice. BI Technologies Corporation 4200 Bonita Place, Fullerton, CA 92835 USA Phone: 714 447 2345 May 7, 2007 Website: www.bitechnologies.com page 1 of 3 BI technologies MODEL 22 ENVIRONMENTAL Seal 85°C Fluorinert® Operating Temperature Range -55°C to +125°C 2% ∆R, 1% ∆V Ratio max. Thermal Shock, 5 cycles, -55°C to +125°C Moisture Resistance, Ten 24 Hour Cycles 3% ∆R Shock, 6 ms Sawtooth 100G’s 1% ∆R, 1% ∆V Ratio max. Vibration, 20G’s to 2000 Hz 1% ∆R, 1% ∆V Ratio max. High Temperature Exposure, 250 Hours @ 125°C 2% ∆R, 2% ∆V Ratio max. Rotational Life, 100 Cycles 3% ∆R 3% ∆R, 2% ∆V Ratio max. Load Life, 0.125W, 100 Hours, 70°C Resistance to Solder Heat 260°C for 5 sec. ORDERING INFORMATION2 22 A R10K LF TR Packaging (Tape & Reel) - optional Model Series RoHS Compliant Product Code - optional Pin Style Resistance Value PACKAGING – TAPE & RE REEL Model 22A Model 22S 12 mm 16 mm Sprocket Pitch 4 mm 4 mm Reel Diameter 7 inches 7 inches 1000 units 200 units Tape Width Quantity per Reel STANDARD RESISTANCE VALUES, OHMS 2 10 100 1K 10K 100K 1 Meg 20 200 2K 20K 200K 2 Meg 50 500 5K 50K 500K Contact our customer service for custom designs and features. BI Technologies Corporation 4200 Bonita Place, Fullerton, CA 92835 USA Phone: 714 447 2345 May 7, 2007 Website: www.bitechnologies.com page 2 of 3 BI technologies MODEL 22 OUTLINE DRAWING3 Model 22A Model 22S CIRCUIT DIAGRAM 3 Dimensions are Inches (mm), Tolerances are ±.01 inch (±.025 mm) unless otherwise stated. BI Technologies Corporation 4200 Bonita Place, Fullerton, CA 92835 USA Phone: 714 447 2345 May 7, 2007 Website: www.bitechnologies.com page 3 of 3 BI technologies