RECOM RP50

Features
●
●
●
●
●
●
●
●
●
●
Single Outputs up to 15A
Input/Output 1.6kVDC Isolation
Adjustable Output Voltage
No Minimum Load
Under -Voltage Lockout
Industry Standard Footprint
Fixed Operating Frequency
Halt Tested
Compact 61.0 x 57.91 x 12.7mm Package
High Efficiency to 91%
INNOLINE
DC/DC-Converter
RP50-S
Series
50 Watt
Single
Output
Selection Guide
Part
Number
Single Output
Input
Voltage
(VDC)
Output
Voltage
(VDC)
Output
Line
Load
Current Regulation Regulation
(A)
(mV)
(mV)
Input Efficiency
Current
(A)
%
RP50-241.8S
18 – 36
1.8
15
4
6
1.36
86
RP50-242.5S
18 – 36
2.5
15
5
8
1.86
87
RP50-243.3S
18 – 36
3.3
15
7
10
2.40
89
RP50-2405S
18 – 36
5
10
10
15
2.40
90
RP50-2415S
18 – 36
15
3.3
30
45
2.40
89
RP50-481.8S
36 – 75
1.8
15
4
6
1.36
87
RP50-482.5S
36 – 75
2.5
15
5
8
1.86
89
RP50-483.3S
36 – 75
3.3
15
7
10
2.40
90
RP50-4805S
36 – 75
5
10
10
15
2.40
91
RP50-4815S
36 – 75
15
3.3
30
45
2.40
90
Notes:
1. Maximum output deviation is 10% inclusive of remote sense. If remote sense is not being used,
the +Vsense should be connected to its corresponding +Vout
2. Measured with a 1uF M/C and a 10µF T/C.
3. An external filter capacitor is required for normal operation. The capacitor should be capable of handing 1A
ripple current for 48V/24V models. RECOM suggests: Nippon chemi-con KMF series, 220µF/100V, ESR 90mΩ.
4. The negative/ positive logic and pin length are optional ( see table ). The pin voltage is referenced to
negative input.
5. Heat sink is optional and P/N: 7G-0021, 7G-0022, 7G-0023, 7G-0024.
6. The RP50 meets level A and level B conducted emissions only with external components connected before
the input pin to the converter.
7. Maximum value at nominal input voltage and full load.
8. Typical value at nominal input voltage and full load.
9. BASEPLATE GROUNDING : Base-plate should be grounded at one of the four screw bolts prior to operation.
10. The converter is provided by basic insulation.
11. “N
N” for Negative remote ON/OFF.
12. “PP” for Positive remote ON/OFF.
178
July-2006
www.recom-international.com
RP50-S
Series
INNOLINE
DC/DC-Converter
Specifications (refer to the standard application circuit, Ta: 25°C)
Input Voltage Range
Unde-Voltage Lockout Start-up Voltage
Unde-Voltage Lockout Shuntdown Voltage
Input Filter (Note 3)
Input voltage variation
18 - 36, 36-75VDC
24V input
48V input
24V input
48V input
dv/dt
(24, 48V nom.)
17V typ.
34V typ.
15V typ.
32V typ.
L-C type
5V/ms max
(Complies with ETS300 132 part4.4)
50VDC
100VDC
Input Surge Voltage 100mS max
24V input
48V input
Start up time
Nominal Vin and constant resistive load
Input Reflected-Ripple Current
24V input
50mAp-p
(5Hz to 20Hz, 12µH Source inpedance)
Remote ON/OFF (Note 4)
(Positive logic)
48V input
20mAp-p
(Negative logic)
ON=Open or 3.0V < Vr < 15V,
OFF=Short or 0V < Vr < 1.2V,
ON=Short or 0V < Vr < 1.2V,
OFF=Open or 3.0V < Vr < 15V,
Continuous Output Power
25mS typ.
IIN=50µA max.
IIN=1mA max.
IIN=1mA max.
IIN=50µA max.
50W max.
Output Voltage Accuracy (full load and nominal Vin)
±1.5%
Output Voltage Adjustment (Note 1)
+10%, -20%
Minimum Load
0%
Line Regulation
low line to high line at full load
See table
Load Regulation
0% to 100% full load
See table
Remote Sense (Note 1)
10% of Vout
Ripple and Noise 20MHz bandwidth (Note 2)
100mVp-p
Temperature Coefficient
±0.02%/ºC
Transient Response Recovery Time (25% load step change)
200µs
Over Voltage Protection threshold (Hiccup)
115% ~ 130% of Vout
Over Current Protection threshold
110% ~ 140% of Iout Rated
Short Circuit Protection
Efficiency (at nominal input voltage, full load)
Isolation Voltage
Hiccup, Automatic recovery
Input to Output
Input to Case
Output to Case
up to 91%.
1600VDC min.
1000VDC min.
1000VDC min.
7
Isolation Resistance
10
Ω
min.
Isolation Capacitance
2500pF max.
Operating Frequency
300KHz typ.
Operating Temperature Range
-40ºC to +100ºC (base plate)
Over Temperature Protection
110°C
Storage Temperature Range
-55°C to +125°C
Humidity max., Non-condensing
95%
Thermal Shock
MIL-STD-810D
Continued next page
www.recom-international.com
July-2006
179
RP50-S
Series
INNOLINE
DC/DC-Converter
Specifications (refer to the standard application circuit, Ta: 25°C)
Vibration
10 ~ 55Hz 2G, 3minutes period, 30minutes analog
Conducted Emissions
X, Y and Z
EN55022 (Note 7)
Level A
EN55022 (Note 7)
Level B
Radiated Emisssions
EN55022
Level A
ESD
EN61000-4-2
Perf. Criteria2
Radiated Immunity
EN61000-4-3
Perf. Criteria2
Fast Transient
EN61000-4-4
Perf. Criteria2
Surge
EN61000-4-5
Perf. Criteria2
Conducted Immunity
EN61000-4-6
Perf. Criteria2
Case Material
Open with Aluminium base plate
Weight
50g
3
MTBF Bellcore TR-NWT-000332, Tc=40°C, Io=80% max.
3000 x10 hours
Characteristics
Efficiency vs Output Load
for 5V only
100
90
Efficiency (%)
80
70
60
50
10
20
30
40
50
70
60
80 90 100
Output Power (%) Ta=25°C
48V Input Without Heatsink
48V Input With Heatsink (7G-0022)
110
110
1.) LFM590
2.) LFM400
3.) LFM200
Output Power (%)
70
50
4.) LFM20
30
10
-40
-20
0
20
40
60
90
1 2 34
80
50
4.) LFM20
30
10
-40
100
Ambient Temperature (°C)
180
1.) LFM590
2.) LFM400
3.) LFM200
70
Output Power (%)
90
-20
0
20
40
60
80
1 2 34
100
Ambient Temperature (°C)
July-2006
www.recom-international.com
RP50-S
Series
INNOLINE
DC/DC-Converter
Package Style and Pinning (mm)
3rd angle
projection
60.96
57.91
12.70
Side View
5.08
50.80
48.26
4xM3 x 0.5 ( Note 10)
Pin Connections
5
1
2
35.56
6
Bottom View
15.24
25.40
7
3
8
4
9
17.78
10.16
External Output Trimming
7
6
8
Trim Down
RD
RU
7
Pin Ø
1.016 mm
1.016 mm
1.016 mm
1.016 mm
2.032 mm
1.016 mm
1.016 mm
1.016 mm
2.032 mm
Product Options Table
Output can be externally trimmed by using the method
shown below.
Trim Up
Pin #
Function
1
–Vin
2
Case
3
Remote ON/OFF
4
+Vin
5
–Vout
6
–Vsense
7
Trim
8
+Vsense
9
+Vout
XX.X ± 0.5 mm
XX.XX ± 0.25 mm
Pin pitch tolerance 0.35mm
Option
Suffix
Negative remote ON/OFF logic, 0.20” pin length (standard)
Negative remote ON/OFF logic, 0.145” pin length
L
Negative remote ON/OFF logic, 0.11” pin length
K
Positive remote ON/OFF logic, 0.20” pin length
P
Positive remote ON/OFF logic, 0.145” pin length
S
Positive remote ON/OFF logic, 0.11” pin length
M
Example: RP50-483.3S/P
www.recom-international.com
July-2006
181