VECTRON TFS110D

Version 1.0
tfs110D.doc
VI TELEFILTER
Filter Specification
15.03.2001
TFS 110D
1/5
Measurement condition
Ambient temperature :
Input power level :
Terminating impedances :
23° C
0 dBm
for input:
for output:
890 Ω || - 5,6 pF
680 Ω || - 5,9 pF
Characteristics
Remark: Reference level for the relative attenuation arel of the TFS 110 D is the minimum of the pass band attenuation amin. The minimum of the
pass band attenuation amin is defined as the insertion loss ae. The centre (reference) frequency fc is the arithmetic mean value of the upper and
lower frequencies at the 3 dB filter attenuation level relative to the insertion loss ae.
Data
typ. value
Insertion loss (Reference level)
Centre frequency
11,9 dB
max.
fc at ambient temperature TA (fCAT)
Pass band shape
Bandwidth
ae
tolerance / limit
13 dB
110,592 ± 0,035 MHz
(3 dB-BW)
Gaussian
at ambient temperature:
3
10
dB bandwidth
dB bandwidth
965
1695
kHz
kHz
min.
min.
900
1600
kHz
kHz
20
30
40
dB bandwidth
dB bandwidth
dB bandwidth
2255
2600
2840
kHz
kHz
kHz
max. 2420
max. 2700
max. 3070
kHz
kHz
kHz
max.
max.
3
10
dB
dB
min.
min.
min.
min.
min.
20
30
40
38
40
dB
dB
dB
dB
dB
Relative attenuation
fc ±
fc
fc
fc
fc
fc
±
±
±
+
-
arel
fc ......... fc ±
450 kHz … fc ±
1210 kHz … fc ±
1395 kHz … fc ±
1535 kHz … fc ±
5,5 kHz … fc +
10,0 MHz … fc -
450 kHz
800 kHz
1395
1535
5,50
10,0
5,5
2,5 dB
8
dB
kHz
kHz
MHz
MHz
MHz
Group delay ( mean value ) :
Group delay ripple (p-p) :
Deviation from linear phase (p-p):
fc … fc ± 800 kHz
fc … fc ± 800 kHz
Frequency inversion temperature ( To )
Temperature coefficient ( Tc1f ) 1st order *)
Temperature coefficient ( Tc2f ) 2nd order **)
22
32
45
40...42
55...45
dB
dB
dB
dB
dB
<
1,2 µs
160 ns
3°
max. 300 ns
20
°C
0
ppm/K
- 0,036 ppm/K²
Operating temperature range
Storage temperature range
Input power level
Permissible DC voltage
Permissible AC voltage
VDC
Vpp
max. ± 7,5 ppm/K
- 20 °C ... + 85 °C
- 25 °C ... + 90 °C
-
max.
10
12
10
dBm
V
V
*)
∆fc(Hz) = Tc1f(ppm/K) x (T - To) x fTo (MHz)
** )
∆fc(Hz) = Tc2f(ppm/K) x (T - To)² x fTo (MHz)
fTo is reference frequency fc at frequency inversion temperature (To )
Generated:
Dunzow W.
Checked/Approved:
Dr. Bert Wall
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
e-mail: [email protected]
Vectron International, Inc.
267 Lowell Road
Hudson, NH 03051 / USA
Tel: (603) 598-0070 Fax: (603) 598-0075
e-mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as
a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Version 1.0
tfs110D.doc
VI TELEFILTER
3. Package :
Filter Specification
TFS 110D
15.03.2001
2/5
(All dimensions in mm)
TFS 110 D
tft
N12
6,4 ±0,2
1
Datecode:
L
M
N
.......
13,20 ±0,20
Year+month
1999
2000
2001
.........
3,0 Max.
1
2
10,16
5,08
3
4
5
6
3
10
9
8
7
12,0
6
4. 50 Ω - matching network ( Principal schemes ) :
10
9
8
7
6
Scheme 1.
TFS
tft
L1
50 Ω
C1
110 D
N3
L4
1
2
3
4
5
10
9
8
7
6
50 Ω
C2
L3
L2
TFS
tft
C1
50 Ω
L1
1
2
Scheme 2.
110 D
N12
3
Balanced ( scheme 1, 2)
1 - Input
5 - Output
2 - Input
4 - Output
3 - Package Ground.
7, 8, 9 - Not Connected Ground.
C4
4
5
50 Ω
L2
C2
C3
10
9
8
7
6
Scheme 3.
TFS
tft
L1
50 Ω
C1
1
2
110 D
N12
3
L4
4
5
50 Ω
C2
Unbalanced ( scheme 3, 4)
1 - Input
5 - Output
2 - Input
4 - Output
3 - Package Ground.
7, 8, 9 - Not Connected Ground.
L3
L2
10
TFS
tft
C1
50 Ω
9
L1
1
2
8
7
6
Scheme 4.
110 D
N12
3
4
C2
C4
5
50 Ω
L2
C3
For final test we use scheme 1.
About matching element values see Application Note.
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
e-mail: [email protected]
Vectron International, Inc.
267 Lowell Road
Hudson, NH 03051 / USA
Tel: (603) 598-0070 Fax: (603) 598-0075
e-mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as
a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Version 1.0
tfs110D.doc
VI TELEFILTER
Filter Specification
15.03.2001
TFS 110D
3/5
5. Stability Characteristics :
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 18 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Resistance to
solder heat (reflow):
max. 2 times reflow process;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
6. Packing :
Tape & Reel:
DIN IEC 286 - 3, with exception of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters per reel:
reel of empty components at start:
reel of empty components at start including leader:
Trailer
1700
min 300 mm
min 500 mm
min 300 mm
EMBOSSED CARRIER TAPE
Tape (all dimensions in mm)
W
Po
Do
E
F
G (min)
P2
P1
D1(min)
Ao
Bo
CT
:
:
:
:
:
:
:
:
:
:
:
:
24
± 0,3
4
± 0,1
1,5
+ 0,1
1,75 ± 0,1
11,5 ± 0,1
0,6
2
± 0,1
12
± 0,1
1,5
7,1
± 0,2
13,9 ± 0,2
21,5 ± 0,1
Po
Do
P
2
E
A
o
F
D
CT
B
1
W
o
G
P1
COVER TAPE
W2
Reel (all dimensions in mm):
A
W1
W2 (max)
N (min)
C
:
:
:
:
:
330
24,4 + 2/0
30,4
60
13 ± 0,2
C
A
W1
The minimum bending radius is 45 mm. The mounting surface of the filters faces the bottom side of the embossed carrier tape.
The marking of the filters is able to read if the view is directed on the upper side of the carrier tape with the sprocket holes on
the right side of the tape.
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
e-mail: [email protected]
Vectron International, Inc.
267 Lowell Road
Hudson, NH 03051 / USA
Tel: (603) 598-0070 Fax: (603) 598-0075
e-mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as
a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Version 1.0
tfs110D.doc
VI TELEFILTER
Filter Specification
15.03.2001
TFS 110D
4/5
7. Air reflow temperature conditions :
1st and 2nd air reflow profile
Name:
Temperature:
Time:
pre-heating periods main-heating periods
150 °C - 170 °C
over 200 °C
60 sec. - 90 sec.
20 sec. - 25 sec.
peak temperature
255 °C ± 5 °C
Air reflow profile
260
240
220
200
temperature / °C
180
160
140
120
100
80
60
40
20
0
0
20
40
60
80
100
120
140
160
180
200
220
240
time / sec.
Table for temperature vs. time during the air reflow process
Tolerance of temperatures: ± 5 °C
time / sec.
0
10
20
30
40
50
60
70
80
90
100
110
120
130
temperature / °C
23
34
46
60
80
103
121
134
143
150
154
156
158
159
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
e-mail: [email protected]lter.com
time / sec.
140
150
160
170
180
190
195
200
205
210
215
220
230
240
temperature / °C
160
161
164
170
180
205
230
255
230
205
180
165
140
120
Vectron International, Inc.
267 Lowell Road
Hudson, NH 03051 / USA
Tel: (603) 598-0070 Fax: (603) 598-0075
e-mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as
a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Version 1.0
tfs110D.doc
VI TELEFILTER
Filter Specification
15.03.2001
TFS 110D
5/5
8. History :
Version
Reason of Changes
Name
Date
1.0
Generate filter specification according to customer requirements.
Dunzow W.
15.03.2001
VI TELEFILTER
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
e-mail: [email protected]
Vectron International, Inc.
267 Lowell Road
Hudson, NH 03051 / USA
Tel: (603) 598-0070 Fax: (603) 598-0075
e-mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is assumed as
a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.