ALLEGRO STR

STR-W6756
Data Sheet
28103.33*
ih ng rs
tc lato
i
Sw egu
R
Universal-Input/140 W Off-Line QuasiResonant Flyback Switching Regulator
ABSOLUTE MAXIMUM RATINGS
at TA = +25°C
Control Supply Voltage, VCC . . . . 35 V
Drain-Source Voltage, VDSS . . . . . . 650 V
Drain Switching Current, ID . . . . . 15 A*
Peak Drain Switching Current,
IDM . . . . . . . . . . . . . . . . . . . . . . 15 A
Single-Pulse Avalanche Energy,
EAS . . . . . . . . . . . . . . . . . . . 400 mJ
OCP/BD Voltage Range,
VOCP . . . . . . . . . . . . –1.5 V to +5 V
FB Input Current, IFB . . . . . . . . 10 mA
FB Voltage Range, VFP –0.5 V to +9 V
Package Power Dissipation, PD
control (VCC × ICC(ON)) . . . . . . 0.8 W
MOSFET (VDSS × ID) . . . See Graph
MOSFET Channel Temp., TJ . +150°C
Internal Frame Temp., TF . . . . +115°C
Operating Temperature Range,
TA . . . . . . . . . . . -20°C to +115°C†
Storage Temperature Range,
TS . . . . . . . . . . . . -40°C to +125°C
* Drain switching current is limited by temperature (page 2) and safe operating area
(page 5).
†For the availability of parts meeting -40°C
requirements, contact Allegro’s Sales Representative.
The STR-W6756 is a quasi-resonant regulator specifically designed
to satisfy the requirements for increased integration and reliability in
switch-mode power supplies. It incorporates a primary control and drive
circuit with an avalanche-rated power MOSFET. The regulator exhibits
only low-level high-frequency EMI noise because of soft switching of
the MOSFET close to ground (bottom point). A bottom-skip function
minimizes an increase of operational frequency during light loads to
improve system efficiency over the entire load range.
Covering the power range from below 240 watts for a 230 VAC
input, or 140 watts for a universal input (85 to 264 VAC), this device
can be used in a range of applications, from DVD and VCR players to
ac adapters for cellular phones and digital cameras. An auto-standby
function, which is internally triggered by sensing on time, reduces
power consumption at light load. An externally triggered standby mode
reduces the input power further. Multiple protections, including the
avalanche-energy-guaranteed MOSFET, provide high reliability of
system design.
Cycle-by-cycle current limiting, undervoltage lockout with hysteresis, and overvoltage protection protect the power supply during the
normal overload and fault conditions. Overvoltage protection is latched
after a short delay. The latch may be reset by cycling the input supply.
Low start-up current and a low-power standby mode selected from the
secondary circuit completes a comprehensive suite of features. The
STR-W6756 is provided in a fully molded TO-220-style flangemounted, high power, isolated plastic package.
FEATURES AND BENEFITS
■ Rugged 650 V Avalanche-Rated MOSFET
Simplified Surge Absorption
No VDSS Derating Required
■ 0.73 Ω Maximum rDS(on)
■ Two Operational Modes by Automatic Switching:
Quasi-Resonant Mode for Normal Operation
Burst Mode for Standby Operation or Light Loads
■ Automatic or Manually Triggered Burst Standby
Input Power <0.1 W at No Load
■ Low Operating Current (6 mA typ)
— continued
Always order by complete part number, e.g., STR-W6756 .
Sanken Power Devices
from Allegro MicroSystems
ih ng rs
tc lato
i
Sw egu
R
STR-W6756
Universal-Input/140 W Off-Line QuasiResonant Flyback Switching Regulator
FUNCTIONAL BLOCK DIAGRAM
FEATURES
AND
BENEFITS (cont’d)
■ Auto-Bias Function
Stable Burst Operation Without Generating Interference
■ Internal Off-Timer Circuit
■ Built-In Constant-Voltage Drive
■ Multiple Protections:
Pulse-by-Pulse Overcurrent Protection
Overload Protection with Auto Recovery
Latching Overvoltage Protection
Undervoltage Lockout with Hysteresis
■ RoHS Compliant
2
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036
Copyright © 2005 Allegro MicroSystems, Inc.
ih ng rs
tc lato
i
Sw egu
R
STR-W6756
Universal-Input/140 W Off-Line QuasiResonant Flyback Switching Regulator
ELECTRICAL CHARACTERISTICS at TA = +25°C, VCC = 20 V, voltage measurements are referenced to S/GND terminal
(unless otherwise specified).
Limits
Characteristic
Symbol
Test Conditions
Min.
Typ.
Max.
Units
Operation Start Voltage
VCC(ON)
Turn-on, VCC = 0 19.9 V
16.3
18.2
19.9
V
Soft-Start Operation Stop Voltage
VSS/OLP
1.1
1.2
1.4
V
Soft-Start Oper. Charging Current
ISS/OLP
-390
-550
-710
µA
8.8
9.7
10.6
V
Start-Up Operation
Operation Stop Voltage
VCC(OFF)
Turn-off, VCC = 19.9 8.8 V
Circuit Current in Non-Operation
ICC(OFF)
VCC = 15 V
–
–
100
µA
V(BR)DSS
ID = 300 µA
650
–
–
V
IDSS
VDS = 650 V
–
–
300
µA
ID = 2.2 A, TJ = +25°C
–
–
0.73
Ω
Normal Operation
Drain-Source Breakdown Voltage
Drain Leakage Current
On-State Resistance
rDS(on)
Switching Time
tf
–
–
400
ns
Circuit Current
ICC(ON)
–
–
6.0
mA
fosc
19
22
25
kHz
VOCPBD(BS1)
-605
-665
-720
mV
VOCPBD(BS2)
-385
-435
-485
mV
VOCPBD(TH1)
280
400
520
mV
VOCPBD(TH2)
670
800
930
mV
VFB(OFF)
1.32
1.45
1.58
V
IFB(ON)
600
1000
1400
µA
10.3
11.1
12.1
V
1.10
1.35
1.65
V
Oscillation Frequency
Bottom-Skip Oper. Threshold Volt.
Quasi-Resonant Oper. Threshold
Feedback-Pin Threshold Voltage
Feedback-Pin Current
Standby Operation
VCC = 0 12.2 V
Standby Operation Start Voltage
VCC(S)
Standby Oper. Start Volt. Interval
VCC
Standby Non-Operation Current
ICC(S)
VCC = 10.2 V
–
20
56
µA
Feedback-Pin Current
IFB(ON)
VCC = 10.2 V
–
4.0
14
µA
Feedback-Pin Threshold Voltage
VFB(S)
VCC = 12.2 V
0.55
1.10
1.50
V
Minimum ON Time
ton(min)
0.5
0.8
1.2
µs
continued next page ...
www.allegromicro.com
3
ih ng rs
tc lato
i
Sw egu
R
STR-W6756
Universal-Input/140 W Off-Line QuasiResonant Flyback Switching Regulator
ELECTRICAL CHARACTERISTICS at TA = +25°C, VCC = 20 V, voltage measurements are referenced to S/GND terminal
(unless otherwise specified).
Limits
Characteristic
Symbol
Test Conditions
Min.
Typ.
Max.
Units
VCC(OVP)
Turn-off, VCC = 0 29.9 V
25.5
27.7
29.9
V
Protection Operation
OVP Operation Voltage
Maximum ON Time
ton(max)
27.5
32.5
39.0
µs
OLP Operation Voltage
VSSOLP
4.0
4.9
5.8
V
OLP Operation Current
ISSOLP
-6.0
-11
-16
µA
Overcurrent Detect. Threshold Volt.
VOCPBD(LIM)
-0.895 -0.940 -0.995
OCP/BD-Pin Current
IOCPBD
Latch Holding Current
ICC(H)
VCC = 29.9 VCC(OFF) – 0.3 V
Latch Release Voltage
VCC(L)
VCC = 29.9 6 V
V
-40
-100
-250
µA
–
45
140
mA
6.0
7.2
8.5
V
–
–
1.5
°C/W
Other
Thermal Resistance
RθJF
Output junction-to-frame
NOTES: 1. Typical Data is for design information only.
2. Negative current is defined as coming out of (sourcing) the specified device termninal.
4
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036
ih ng rs
tc lato
i
Sw egu
R
STR-W6756
Universal-Input/140 W Off-Line QuasiResonant Flyback Switching Regulator
MOSFET TYPICAL CHARACTERISTICS
Avalanche energy is measured at VDD = 99 V,
L = 20 mH, IL = 6.05 A.
www.allegromicro.com
5
STR-W6756
Universal-Input/140 W Off-Line QuasiResonant Flyback Switching Regulator
ih ng rs
tc lato
i
Sw egu
R
MOSFET TYPICAL CHARACTERISTICS (cont’d)
WARNING — These devices are designed to be operated at lethal voltages and energy levels. Circuit designs
that embody these components must conform with applicable safety requirements. Precautions must
be taken to prevent accidental contact with power-line potentials. Do not connect grounded test
equipment.
The use of an isolation transformer is recommended during circuit development and breadboarding.
6
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036
ih ng rs
tc lato
i
Sw egu
R
STR-W6756
Universal-Input/140 W Off-Line QuasiResonant Flyback Switching Regulator
APPLICATIONS INFORMATION
Typical Application
Complete product description and applications information
is provided in Application Note 28103.30, Series STRW6750 Off-Line Quasi-Resonant Flyback Switching
Regulators.
The products described herein are manufactured in Japan by Sanken
Electric Co., Ltd. for sale by Allegro MicroSystems, Inc.
Sanken products listed in this publication are designed and intended
for use as components in general-purpose electronic equipment or
apparatus (home appliances, office equipment, telecommunication
equipment, measuring equipment, etc.). Their use in any application
requiring radiation hardness assurance (e.g., aerospace equipment) is
not supported.
Sanken and Allegro reserve the right to make, from time to time, such
departures from the detail specifications as may be required to permit
improvements in the performance, reliability, or manufacturability of its
products. Therefore, the user is cautioned to verify that the information
in this publication is current before placing any order.
When using the products described herein, the applicability and
suitability of such products for the intended purpose shall be reviewed at
the users responsibility.
Although Sanken undertakes to enhance the quality and reliability of
its products, the occurrence of failure and defect of semiconductor
products at a certain rate is inevitable.
Users of Sanken products are requested to take, at their own risk,
preventative measures including safety design of the equipment or
systems against any possible injury, death, fires or damages to society
due to device failure or malfunction.
When considering the use of Sanken products in applications where
higher reliability is required (transportation equipment and its control
systems or equipment, fire- or burglar-alarm systems, various safety
devices, etc.), contact a company sales representative to discuss and
obtain written confirmation of your specifications.
The use of Sanken products without the written consent of Sanken in
applications where extremely high reliability is required (aerospace
equipment, nuclear power-control stations, life-support systems, etc.) is
strictly prohibited.
The information included herein is believed to be accurate and
reliable. Application and operation examples described in this publication are given for reference only and Sanken and Allegro assume no
responsibility for any infringement of industrial property rights,
intellectual property rights, or any other rights of Sanken or Allegro or
any third party that may result from its use.
EI16EI
www.allegromicro.com
7
STR-W6756
Universal-Input/140 W Off-Line QuasiResonant Flyback Switching Regulator
PACKAGE DIMENSIONS
in Millimeters
Product weight: approx. 2.3 g.
Recommended mounting hardware torque: 0.588 ~ 0.785 Nm, 6 ~ 8 kgf × cm.
Recommended silicon grease: Dow Corning SC102, Toshiba YG6260, Shin-Etsu G746, or equivalent.
8
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036
ih ng rs
tc lato
i
Sw egu
R