Wideband Amplifier RFC1G18H4-24-S Product Features Application GaN MMIC Very Low Distortion Guaranteed Broadband Power Gain Heat Sink 99.9% Copper, Ag or Gold Plate Excellent Thermal Conductivity Single Supply Voltage @ 24V No External Circuit needed Drive Amplifier Package Type: SOT-115J Description The RFC1G18H4- 24 is specifically designed for up to 1GHz in frequency as amplifiers. This hybrid dynamic range amplifier module operates with a single voltage supply of 24V(DC). The RFC 1G18H4- 24-S is equipped with over-voltage suppressor. Absolute Maximum Ratings No Parameter Min Max Unit 22 28 VDC 30 dBm 1 VDD / VRFOUT 2 RFIN (CW 1-Tone) 3 Storage Temperature -40 100 ℃ 4 Operating Ambient Temperature -20 +60 ℃ 5 Operating Flange Temperature +85 ℃ Electrical Specifications No (TA= +25℃, VDD = 24V) Parameter Min Typ Max Unit 1000 MHz 1 Bandwidth (MHz) 20 2 Gain @1000MHz 18 3 Gain Flatness @20-1000MHz 4 Input / Output VSWR 5 OIP3 @20-1000MHz 43 44 dBm 6 Power Output 3dB Comp. @20-1000MHz (dBm) 35 36 dBm 7 IMD3 @CW 2-Tone, Po=20dBm, 1000MHz 46 48 dBc 8 Supply Current 500 550 19 dB 1.5 2 2.0 : 1 2.5 : 1 600 dBpp mA ▪ Tel : 82-31-250-5011 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 6.0 Wideband Amplifier RFC1G18H4-24-S RFC1G18H4-24-S Typical Performance @ 25℃ No Parameter Typical Units 1 Frequency 20 500 1000 MHz 2 S21 - Gain 19 19 20 dB 3 S11 - Input Return Loss -10 -13 -20 dB 4 S22 - Output Return Loss -12 -10 -14 dB 5 P3dB 36 37 35 dBm 6 OIP3 45 45 44 dBm 7 Supply Voltage 24 V 8 Current 550 mA Power Output 3dB Compression S-Parameters 40 30 20 38 S21 36 0 dBm Magnitude(dB) 10 S11 -10 34 -20 32 S22 -30 -40 30 200 400 50 600 800 1000 1200 1400 1600 1800 2000 Frequency(MHz) 20 100 200 300 400 500 600 700 800 900 1000 Frequency(MHz) OIP3 50 49 48 OIP3(dBm) 47 46 45 44 43 42 41 40 20 100 200 300 400 500 600 700 800 900 1000 Frequency(MHz) ▪ Tel : 82-31-250-5011 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 6.0 Wideband Amplifier RFC1G18H4-24-S APPLICATIONS 1. 2. 3. 47㎌ +24V + 4. 5. 6. 7. On the power input port (Pin#5), use 47uF/35V capacitor GND is recommends Heat sink should be placed as tight as possible to the metal case. Suitable for safely handling electrostatic-sensitive devices. Person at a workbench should be earthed via a wrist strap and a resistor. All mains-powered equipment should be connected to the mains via an earth-leakage switch. Equipment cases should be grounded. Relative humidity should be maintained between 40% and 50%. An ionizer is recommended. Keep static materials, such as plastic envelopes and plastic trays etc., away from the workbench. One must put the power off, before adjusting the in/output matching of the system. Pay close attention to the input voltage not to over power the hybrid. The space between bottom of socket and the tip of the lead is recommended to have space of 2mm+ to protect the pin. Do not open the Plastic cover to change the matching inside the hybrid. Once opened, RFHIC will not be responsible for the hybrid. Package Dimensions (Type: SOT-115J) Pin No. Function 1 2,3,7,8 5 9 RF Input Ground Vcc RF Output RFHIC Corporation (RFHIC) reserves the right to make changes to any products herein or to discontinue any product at any time without notice. RFHIC do not assume any liability for the suitability of its products for any particular purpose, and disclaims any and all liability, including without limitation consequential or incidental damages. The product specifications herein expressed have been carefully checked and are assumed to be reliable. However, RFHIC disclaims liability for inaccuracies and strongly recommends buyers to verify that the information they are using is current before placing purchase orders. RFHIC products are not intended for use in life support equipment or application where malfunction of the product can be expected to result in personal injury or death. Buyer uses or sells such products for any such unintended or unauthorized application, buyer shall indemnify, protect and hold RFHIC and its directors, officers, stockholders, employees, representatives and distributors harmless against any and all claims arising out of such use. RFHIC’s liability under or arising out of damages, claims of whatsoever kind and nature which RFHIC products could cause shall be limited in amount to the net purchase price of the products sold to buyer by RFHIC. ▪ Tel : 82-31-250-5011 ▪ All specifications may change without notice. ▪ [email protected] ▪ Version 6.0