C2560 TCXO Typical Applications Features SONET/SDH Synthesizers Optimized for Semtech SONET / SDH Synchronization Sets Stratum 3 Compliant Tight Stability Low Aging Previous Vectron Model Numbers MC1200; TC-210 Frequency Range 10 MHz – 200 MHz Standard Frequencies 12.8, 16.384, 20, 30.15, 37.5, 76.8 MHz Frequency stabilities1 [ Stratum 3 TCXO] Parameter Min Typ Max. Units vs. operating temperature range (Referenced to +25°C) -0.8 -0.28 -0.8 -0.28 -0.28 Min - 1.5 - 0.1 - 0.1 - 2.5 -4.6 Typ +0.8 +0.28 +0.8 +0.28 +0.28 Max. +1.5 +0.1 +0.1 +2.5 -4.6 ppm ppm ppm ppm ppm Units ppm ppm ppm ppm ppm Parameter Supply voltage [Standard] Min 3.135 Typ 3.3 Max. 3.465 Units VDC Supply voltage [Option] 4.75 5 5.25 VDC 15 15 mA mA Max. Units Parameter Initial tolerance (w/ fixed frequency) vs. supply voltage change vs. load change vs aging /15 Years overall tolerance Operating temp Ordering Code range -40 … +85°C F807 -30 … +85°C G287 -20 … +70°C D807 -20 … +70°C D287 0 … +50°C B287 Condition at time of shipment, No EFC VS ± 5% Load ± 10% *Stratum 3 per GR-1244-CORE: <±4.6 ppm for all causes and 15 years aging, Holdover: <±0.37 ppm over 24 hours (Codes: D287 & B287) Supply voltage (Vs) Current consumption Condition Ordering Code SV033 SV050 steady state @ +25°C & 3.3VDC steady state @ +25°C & 5.0VDC RF output Parameter Signal [Standard] Load Rise and Fall time Duty cycle Signal [Standard] Load Output power Harmonics Sub harmonics Min Typ Condition Ordering Code RFH HCMOS 13.5 15 40 0 50 3 16.5 5 50 sinewave 6 -30 -30 pF ns % 10% - 90% @ (Voh-Vol)/2 RFS Ohm dBm dBc dBc If applicable Frequency Tuning (EFC) Parameter Tuning Range Tuning Range Linearity Tuning Slope Control Voltage Range (nominal frequency to occur at Typ ± 0.5V) Freq. control input impedance Min ± 8.0 0.3 0.5 10 Typ Max. Fixed (No EFC) ±12.0 ± 20.0 20 Positive 1.65 3.0 2.5 4.5 Units Condition ppm % Standard Version VDC VDC kΩ Vectron International · www.vectron.com Vectron International Headquarters 267 Lowell Road Hudson, New Hampshire 03051 +1-888-328-7661 tel +1-888-329-8328 fax Vectron International LLC. 100 Watts Street Mount Holly Springs, PA 17065 USA +1-717-486-3411 tel +1-717-486-5920 fax Ordering Code 0 1 with Vs=3.3VDC with Vs=5.0VDC v.2007-03-21 · page 1 of 4 Vectron international GmbH & Co. KG Landstrasse D-74924 Neckarbischofsheim Germany +49-07268-801-0 tel +49-07268-801-281 fax Vectron Asia Pacific Sales Office Unit 3119 31st Floor, Jin Mao Tower, 88 Century Boulevard, Shanghai, P.R. China 200120 +86 21 28909740 tel. +86 21 28909240 fax C2560 TCXO Additional parameters Parameter Phase Noise3 Min Typ -115 -130 -140 1x 10 -9 Allan Variance Weight Processing & Packing Max. 9 Handling & processing note Units dBc/Hz dBc/Hz dBc/Hz Condition 100 Hz Stratum 3 TCXO @ 1 kHz 12.8 MHz 10 kHz Tau= 1 sec g Enclosures Type A Package Codes: Code Height “H” A1 6.8 Pin Length “L” NA 1.150 R.024 1.000 .079 2 A 3 .098 1.00 DETAIL A SCALE 4 : 1 5 1 4 .400 .250 .797 .400 .268 (.39 MAX) Dimensions: inches Pin Connections 1 2 3 4 5 RF-Output Vs (supply voltage) GND N.C./EFC GND Outline Drawing: Marking C2560Ax-xxxx Frequency * C AYYWW Absolute Maximum Ratings Parameter Supply voltage (Vs) Control Voltage Maximum output load @ CMOS Operable temperature range Storage temperature range Min 0 -40 -55 Typ Max. 6.0 6.0 40 +85 +125 Units V V pF °C °C Vectron International · www.vectron.com Vectron International Headquarters 267 Lowell Road Hudson, New Hampshire 03051 +1-888-328-7661 tel +1-888-329-8328 fax Vectron International LLC. 100 Watts Street Mount Holly Springs, PA 17065 USA +1-717-486-3411 tel +1-717-486-5920 fax Condition v.2007-03-21 · page 2 of 4 Vectron international GmbH & Co. KG Landstrasse D-74924 Neckarbischofsheim Germany +49-07268-801-0 tel +49-07268-801-281 fax Vectron Asia Pacific Sales Office Unit 3119 31st Floor, Jin Mao Tower, 88 Century Boulevard, Shanghai, P.R. China 200120 +86 21 28909740 tel. +86 21 28909240 fax C2560 TCXO Standard Shipping Method Lage im Gurt Position in tape Pin 1 A Abwickelrichtung Unwinding direction X B P Gurtunterseite Tape buttom side K Gurtoberseite Tape upper side *bei W ≤ 24 mm nur untere Lochreihe ∗by W ≤ 24 mm only lower hole line Production tolerance complying DIN IEC 286-3 Enclosure Type Tape width W [mm] Quantity per meter Quantity per reel Dimension P Recommended Reflow Profile 30 - 60 SEC REFLOW 225 - 240º C 183º C 130º C 110º C 25º C 40 - 90 SEC WARM-UP 90 - 120 SEC DWELL 55 - 110 SEC RAMP 110 - 215 SEC COOL-DOWN SMD oscillators must be on the top side of the PCB during the reflow process. Vectron International · www.vectron.com Vectron International Headquarters 267 Lowell Road Hudson, New Hampshire 03051 +1-888-328-7661 tel +1-888-329-8328 fax Vectron International LLC. 100 Watts Street Mount Holly Springs, PA 17065 USA +1-717-486-3411 tel +1-717-486-5920 fax v.2007-03-21 · page 3 of 4 Vectron international GmbH & Co. KG Landstrasse D-74924 Neckarbischofsheim Germany +49-07268-801-0 tel +49-07268-801-281 fax Vectron Asia Pacific Sales Office Unit 3119 31st Floor, Jin Mao Tower, 88 Century Boulevard, Shanghai, P.R. China 200120 +86 21 28909740 tel. +86 21 28909240 fax C2560 TCXO How to Order this Product: Step 1 Use this worksheet to forward the following information to your factory representative: Model Stability Code Supply Voltage Code RF Output Code EFC Code Package Code Frequency RFH 1 A1 12.800 MHz C2560 Example: Step 2 C2560 D206 SV033 The factory representative will then respond with a Vectron Model Number in the following Configuration: Model Package Code Dash Dash Number C2560 [Customer Specified Package Code] - [Factory Generated 4 digit number] Typical P/N = C2560A1-0001 Notes: 1 Contact factory for improved stabilities or additional product options. Not all options and codes are available at all frequencies. 2 Unless otherwise stated all values are valid after warm-up time and refer to typical conditions for supply voltage, frequency control voltage, load, temperature (25°C) 3 Phase noise degrades with increasing output frequency. 4 Subject to technical modification. 5 Contact factory for availability. Vectron International · www.vectron.com Vectron International Headquarters 267 Lowell Road Hudson, New Hampshire 03051 +1-888-328-7661 tel +1-888-329-8328 fax Vectron International LLC. 100 Watts Street Mount Holly Springs, PA 17065 USA +1-717-486-3411 tel +1-717-486-5920 fax v.2007-03-21 · page 4 of 4 Vectron international GmbH & Co. KG Landstrasse D-74924 Neckarbischofsheim Germany +49-07268-801-0 tel +49-07268-801-281 fax Vectron Asia Pacific Sales Office Unit 3119 31st Floor, Jin Mao Tower, 88 Century Boulevard, Shanghai, P.R. China 200120 +86 21 28909740 tel. +86 21 28909240 fax