3 POSITION SELECTOR SWITCH CONTACT BLOCK OPERATION GUIDE revision for dwg # rev ch.no. - - CONTACT BLOCK GUIDE × 1 NO (left) × 2 NC in series (side × side) × × × 1 NC (right) × × 1 NC (left) × × 2 NO in parallel (side × side) 1PB-2AS2-x date description original design revised by Philipp E. 11/01/07 2 1 NO (right) 1 3 28.5 mm [1.1 in] (Left or right as seen from front of operator) Up tp six switch contacts can be installed. 5 4 27 mm [1.1 in] ITEM max. 6 mm [.25 in] 43 mm [1.7 in] 67 mm [2.6 in] 91 mm [3.6 in] * = Selector Switch is supplied with mounting bracket (ITEM 1,2 and 3) ** = Switch Contacts must be ordered separatly unless otherwise specified: all dimensions are in millimeters third angle projection tolerance XX XX.X XX.XX ALL = = = = ±1mm ±0.5mm ±0.2mm −mm This Drawing is the property of R M E T R I C 35 Royal Road Flemington, NJ 08822-6000 (908) 806-9400 Fax (908) 806-9490 and is a confidential disclosurelent without consideration other than the borrower’s agreement that it shall not be reproduced, copied, lent or disposed of directly or indirectly nor used for any purpose other than that for which it is specifically furnished. DESCRIPTION CAT. NO. 2AS2-1 2AS2-2 2AS2-3 1* Selector Switch 2AS2-4 2AS2-5 2AS2-6 2* Mounting Bracket 2BRK 3 Mounting Bracket Screws incl. in 2BRK 4 Panel S1 S2 5** Switch Contacts S3 S4 titel DESCRIPTION Maintained Spring Return Maintained Spring Return Spring Return Spring Return - MIN. MAX. QTY. QTY. Black 1 1 Black 1 1 Black 1 1 Black 1 1 Black 1 1 Black 1 1 1 1 2 2 Green 1 6 Red 1 6 Green/Black 1 6 Red/Black 1 6 Color 22mm Non-Illuminated Selector Switch 2AS2-x (x=type) drawn by: Philipp Ernstberger checked by: Laszlo Gyorgypal released by: Laszlo Gyorgypal 11/01/07 drawing no.: rev.: - 1PB-2AS2-x 11/01/07 11/01/07 scale: - sheet: 1 of: 1