Product Specification Device Part No:HUBG--5108L 5.9 Features： Tolerance is 0.1mm unless otherwise noted. z Lighting color：Bulish Green 1.0 2.54 5.0 z Lens Type：Water Clear 25.4 Min z Standard T-1 3/4PackageType z High Intensity, Viewing Angle:30° Application: z Used in Trafic Sign Light 8.6 1. 2. 3. 4. 5 1.5 All dimension are in millimeters. Tolerance is +0.20mm unless otherwise noted Producted resin under flanger is 1.5mm max Lead spacing is measured where the leads emerge from the package. Specification are subject to change without notice z Electronic Sign and Signals Absolute Maximum Ratings Series （Ta = 25℃） Symbol Testing Condition Power Dissipation Pd Reverse Voltage Characteristics Unit Max. Min. —— 120 —— mW VR IR = 50μA —— 5 V Ipeak Duty=0.1，1kHz 100 —— mA I/C —— 0.5 —— mA/℃ Operating Temperature Range Topr —— +80 -30 ℃ Storage Temperature Range Tstr —— +100 -40 ℃ Lead Soldering Temperature Tsol Peak Forward Current Derating Linear 260℃ for 5sec.（3.0mm from resin） Anti-static Voltage 1000 Electro-Optical Characteristics V （Ta = 25℃） Characteristics Testing Condition Max. Typ. Min. Series Symbol Forward Voltage VF IF = 20mA 4.0 3.5 ---- V Reverse Current IR VR = 5V 100 — — μA Peak Emission Wavelength λp IF = 10mA — 505 — nm Spectrum Width of Half Value Δλ IF = 10mA — 20 — nm Luminous Intensity Angle 2ф1/2 IF = 20mA — Luminous Intensity IV IF = 20mA ----- 30 ----- Unit degre e 2200 mcd Remarks： 1. Luminous Intensity is measured by JF-Ⅱtester. 2. All of the products are sensitive to static voltage. It is recommended that antistatic facilities like wrist band or antistatic gloves are used when handing the products. Bin Code of luminous Intensity: Iv Bin Code T U V Intensity Specification Iv (min) 1590 2225 3115 Iv(max) 2225 3115 4360 Cautions on LED usage: 1. Static Electricity and surge will damage the LEDs, It is recommended to use a wrist band or anti-electrostatic glove when handling the LEDs. 2. Use Grounded soldering iron and do not solder the LEDs at the conditions beyond the absolute maximum ratings specified in the data sheet. 3. HHEC will not be held responsible for any damage caused by the operation exceeds the absolute maximum ratings. 4. Use the LEDs as soon as possible once the bag was opened. Store and use where there is no corrosive gas . The leads of LEDs will be rusty when the LEDs were exposed to the air for longer than one month.