JFW Industries, Inc. Phone: 317-887-1340 [email protected] www.jfwindustries.com SPECIFICATION SHEET JFW MODEL 50S-1841 1P2T SOLID STATE RF SWITCH Frequency Range 500-3000 MHz Configuration 1P2T Impedance 50 Ohms nominal VSWR 1.3:1 typical 1.5:1 maximum Insertion Loss 0.50 0.75 0.60 0.90 0.90 1.25 Isolation 75 65 65 55 Switching Speed 10 microseconds maximum 6 microseconds typical (50% TTL to 10% or 90% RF) Switching Transients < 1.0 Vpk-pk typical < 2.0 Vpk-pk maximum (for any rep rate) RF Input Power 30 Watts average (Hot Switched) Spurious Noise (Out-of-band) This switch shall produce: < -73dBm (100-500MHz) < -50dBm (1-100MHz) dB dB dB dB dB dB dB dB dB dB typical maximum typical maximum typical maximum typical minimum typical minimum 500-1000 MHz 500-1000 MHz 1000-2000 MHz 1000-2000 MHz 2000-3000 MHz 2000-3000 MHz 500-2000 MHz 800-2000 MHz 2000-3000 MHz 2000-3000 MHz This is to be tested on the common port with J1 and J2 terminated into 50 Ohms. Control (1 line) TTL "Low" Common to J1 TTL "High" Common to J2 DC Supply +15 Vdc @ 80 mA nominal and +5 Vdc @ 40 mA nominal RF Connector BNC, SMA, TNC or N female --CONTINUED-Page 1 of 2 JFW FORM E-7-F REV F JFW Industries, Inc. Phone: 317-887-1340 [email protected] www.jfwindustries.com SPECIFICATION SHEET JFW MODEL 50S-1841 1P2T SOLID STATE RF SWITCH Operating Temperature Range -20ºC to +70ºC Storage Temperature Range -55ºC to +85ºC Physical Size See outline drawing 092-5197 ECR/ECN # DATE 08/14/2009 Page 2 of 2 REV APPR / DATE ECR/ECN # BAC 08/14/2009 JFW FORM E-7-F REV F DATE REV APPR / DATE