SF101 THRU SF106 Ｒ SUPER FAST RECTIFIER S E M I C O N D U C T O R SILICON RECTIFIER Reverse Voltage: 50 to 400 Volts Forward Current:1.0Ampere DO-41 FEATURES Low forward voltage drop High current capability High reliability High surge current capability Super fast recovery time Good for use in switching mode circuits Plastic package has Underwriters Laboratory Flammability Classification 94V-0 JF １．０（２５．４） ＭＩＮ ０．１０７（２．７） ０．０８０（２．０） ＤＩＡ ０．２０５（５．２０） ０．１８０（４．１０） MECHANICAL DATA Case: JEDEC DO-41 molded plastic body Terminals: Plated axial leads, solderable per MIL-STD-750,method 2026 １．０（２５．４） ＭＩＮ Polarity: Color band denotes cathode end ０．０３４（０．８５） ０．０２８（０．７１） ＤＩＡ Mounting Position: Any Weight: 0.012ounce, 0.34 gram Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (Rating at 25 C ambient temperature unless otherwise specified ,Single phase ,half wave ,60HZ,resistive or inductive load. For capacitive load,derate current by 20%.) Symbols SF 101 SF 102 SF 103 SF 104 SF 105 SF 106 50 100 150 200 300 400 35 70 105 140 210 280 50 100 150 200 300 400 Units Maximum DC Blocking Voltage VRRM VRMS VDC Maximum Average Forward Rectified Current 0.375"(9.5mm)lead Length at Ta=55 C I(AV) 1.0 Amp Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load (JEDEC method) IFSM 30.0 Amps Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum Instantaneous Forward Voltage at 1.0 A Maximum DC Reverse Current At Rated DC Blocking Voltage TA=25 C VF 0.95 Typical Junction Capacitance(Note2) Operating Junction and Storage Temperature Range Volts 5.0 IR A 50 TA=100 C Maximum Reverse Recovery Time(Note1) 1.25 Volts Volts Volts Trr CJ 35 50 TJ TSTG ns 25 -65 to+125 -65 to+150 PF C Note: 1.Test conditions: IF=0.5A,IR=1.0A,IRR=0.25A. 2.Measured at 1MHZ and applied reverse voltage of 4.0 Volts. 8-2 JINAN JINGHENG CO., LTD. ＮＯ．５１ ＨＥＰＩＮＧ ＲＯＡＤ ＰＲ ＣＨＩＮＡ ＴＥＬ：８６－５３１－６９４３６５７ ＦＡＸ：８６－５３１－６９４７０９６ WWW.JIFUSEMICON.COM FIG.2-TYPICAL FORWARD CURRENT DERATING CURVE （＋） 50Vdc (APPROX) 10 NON INDUCTIVE ＋０．５Ａ PULSE GENERATOR (NOTE2) D.U.T. （－） 1 NON INDUCTIVE AVERAGE FORWARD CURRENT (A) FIG.1-TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTIC 50 NON INDUCTIVE Ｔｒｒ ０ －０．２５Ａ OSCILLOSCOPE (NOTE1) －１．０Ａ NOTES:1.Rise Time=7ns max. input impedance=1 megohm 22pF 2.Rise Time=10ns max. source impedance =50 ohms SF106 TA=25 C Pulse Width=300 s 1% Duty Cycle ０．６ ０．８ １．０ ５０ ７５ １００ １２５ １５０ １７５ １００ １．２ TJ=100 C １０ １．０ TJ=25 C ０．１ ０．０１ ０．０１ ０．４ ２５ FIG.4-TYPICAL REVERSE CHARACTERISTICS １ ０．２ ０ AMBIENT TEMPERATURE ( C) INSTANTANEOUS REVERSE CURRENT ,(mA) INSTANTANEOUS FORWARD CURRENT( AMPERES) ０．５ ０ SF101-SF105 ０ Single Phase Half Wave 60hz Resistive or Inductive Load 0.375"(9.5mm) Lead Length １．０ １ｃｍ １００ ０．１ １．５ SET TIME BASE FOR 5/10 ns/cm FIG.3-TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS １０ SILICON RECTIFIER RATINGS AND CHARACTERISTIC CURVES SF101 THRU SF106 ０ ２０ １．４ ４０ ６０ ８０ １００ １２０ １４０ PERCENT OF RATED PEAK REVERSE VOLTAGE(%) INSTANTANEOUS FORWARD VOLTAGE (VOLTS) FIG.5-MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT FIG.6-TYPICAL JUNCTION CAPACITANCE ３５ PEAK FORWARD SURGE CURRENT(AMPERES) JUNCTION CAPACITANCE(pF) １７５ ３０ TA=25 C 8.3ms SINGLE HALF SINE-WAVE (JEDEC Method) ２５ ２０ １５ １０ ５ ０ １ ５ １０ ５０ １５０ １２５ １００ SF101-SF105 ７５ TJ=25 C ５０ SF106 ２５ １ １００ ０．１ NUMBER OF CYCLES AT 60Hz ０．５ １ ２ ５ １０ ２０ ５０ １００ ２００ ５００ １０００ REVERSE VOLTAGE. (V) 8-3 JINAN JINGHENG CO., LTD. ＮＯ．５１ ＨＥＰＩＮＧ ＲＯＡＤ ＰＲ ＣＨＩＮＡ ＴＥＬ：８６－５３１－６９４３６５７ ＦＡＸ：８６－５３１－６９４７０９６ WWW.JIFUSEMICON.COM