PS-05 5W Single Output Switching Power Supply series Features : Universal AC input / Full range Low leakage current <0.5mA Protections: Short circuit/Over load /Over voltage/Over temperature Cooling by free air convection 100% full load burn-in test Fix switching frequency at 67KHz Low cost High reliability 2 years warranty SPECIFICATION MODEL OUTPUT INPUT PS-05-5 PS-05-12 PS-05-15 PS-05-24 DC VOLTAGE 5V 12V 15V 24V 48V RATED CURRENT 1A 0.45A 0.35A 0.22A 0.11A CURRENT RANGE 0 ~ 1.2A 0 ~ 0.5A 0 ~ 0.4A 0 ~ 0.25A 0 ~ 0.125A RATED POWER 5W 5.4W 5.25W 5.28W 5.28W 120mVp-p 120mVp-p 200mVp-p 200mVp-p RIPPLE & NOISE (max.) Note.2 100mVp-p VOLTAGE TOLERANCE Note.3 2.0% 2.0% 2.0% 2.0% 1.0% LINE REGULATION 1.0% 1.0% 1.0% 0.5% 0.5% LOAD REGULATION 1.0% 1.0% 1.0% 0.5% 0.5% SETUP, RISE TIME 1000ms, 20ms HOLD UP TIME(Typ.) 100ms at full load VOLTAGE RANGE 85 ~ 264VAC FREQUENCY RANGE 47 ~ 63Hz EFFICIENCY(Typ.) 70% AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 0.15A/115VAC LEAKAGE CURRENT OVER LOAD PROTECTION OVER VOLTAGE OVER TEMPERATURE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS WITHSTAND VOLTAGE SAFETY & ISOLATION RESISTANCE EMC EMI CONDUCTION & RADIATION (Note 4) HARMONIC CURRENT OTHERS NOTE PS-05-48 120 ~ 370VDC 75% 75% 76% COLD START 30A/230VAC <0.5mA / 240VAC Above 105% rated output power Protection type : Hiccup mode, recovery automatically after fault condition is removed 5.75 ~ 6.75V 13.8 ~ 16.2V 17.2 ~ 20.2V 27.6 ~ 32.4V Tj 140 typically (U1) Detect on main control IC 55.2 ~ 64.8V Protection type : Hiccup mode, recovery automatically after fault condition is removed -10 ~ +60 (Refer to output load derating curve) 20 ~ 90% RH non-condensing -20 ~ +85 , 10 ~ 95% RH 0.05%/ (0 ~ 50 10 ~ 500Hz, 2G 10min./1cycle, Period for 60min.each along X, Y, Z axes EN60950-1 CB Approved by TUV I/P-O/P:3KVAC I/P-O/P:100M Ohms/500VDC Compliance to EN55022 (CISPR22) Class B Compliance to EN61000-3-2,-3 EMS IMMUNITY Compliance to EN61000-4-2,3,4,5,6,8,11 Light industry level, criteria A DIMENSION 75*40*20mm (L*W*H) 0.05Kg; 120pcs/6.25Kg/1CUFT PACKING 76% 0.07A/230VAC 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. File Name:PS-05-SPEC 2006-04-13 PS-05 5W Single Output Switching Power Supply Mechanical Specification series Unit:mm 75 67 To chassis Grounding 32 40 1 2 CN1 3 1 2 CN2 3.5 20 4- AC Input Connector (CN2) : Molex 5285-03 or equivalent Assignment FG AC/N AC/L Pin No. 1 2 3 Mating Housing Terminal Molex 5058 or equivalent Molex 2478 or equivalent DC Output Connector (CN1) : Molex 5273-02 or equivalent Pin No. 1 2 Assignment +V -V Mating Housing Molex 5195 or equivalent Terminal Molex 5194 or equivalent Block Diagram fosc : 67KHz RECTIFIERS & FILTER EMI FILTER I/P RECTIFIERS & FILTER POWER SWITCHING +V -V PWM CONTROL FG DETECTION CIRCUIT Output Derating Static Characteristics 100 100 90 80 80 70 LOAD (%) LOAD (%) 60 40 20 60 50 40 -10 -10 0 10 20 30 40 50 AMBIENT TEMPERATURE ( ) 60 (HORIZONTAL) 85 90 95 100 105 264 INPUT VOLTAGE (V) 60Hz File Name:PS-05-SPEC 2006-04-13