PSP-1000 1000W Single Output with PFC Function series Features : Universal AC input / Full range AC input active surge current limiting Built-in active PFC function Protections: Short circuit / Overload / Over voltage / Over temperature Built-in constant current limiting circuit Current sharing up to 2 units or 2000W Built-in remote ON-OFF control Built-in remote sense function Built-in active current sharing and parallel function 3 years warranty SPECIFICATION MODEL PSP-1000-5 PSP-1000-12 PSP-1000-13.5 PSP-1000-15 PSP-1000-24 PSP-1000-27 PSP-1000-48 DC VOLTAGE 5V 12V 13.5V 15V 24V 27V 48V RATED CURRENT 145A 75A 67A 60A 37.6A 33.6A 19A CURRENT RANGE 0 ~ 145A 0 ~ 75A 0 ~ 67A 0 ~ 60A 0 ~ 37.6A 0 ~ 33.6A 0 ~ 19A 725W 900W 904.5W 900W 902.4W 907.2W 912W 1000W 1000W 1000W 1000W 1000W 1000W RIPPLE & NOISE (max.) Note.2 100mVp-p 150mVp-p 150mVp-p 150mVp-p 150mVp-p 150mVp-p 200mVp-p VOLTAGE ADJ. RANGE 10 ~ 13.2V 3.0% 12 ~ 15V 2.0% 13.5 ~ 18V 2.0% 20 ~ 26.4V 1.0% 24 ~ 30V 1.0% 41 ~ 56V 1.0% RATED POWER PEAK LOAD OUTPUT Note.4 800W VOLTAGE TOLERANCE Note.3 LINE REGULATION 0.5% 0.3% 0.3% 0.3% 0.2% 0.2% 0.2% LOAD REGULATION 2.0% 0.5% 0.5% 0.5% 0.5% 0.5% 0.5% 1500ms, 50ms/230VAC SETUP, RISE TIME 24ms/230VAC HOLD UP TIME (Typ.) VOLTAGE RANGE INPUT 47 ~ 63Hz POWER FACTOR (Typ.) 0.96/230VAC 0.96/115VAC at full load EFFICIENCY (Typ.) 77% 84% AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 11.2A/115AVC 32A/115VAC 5.6A/230VAC 63A/230VAC 86% OVERLOAD REMOTE CONTROL 5.75 ~ 6.75V 13.8 ~ 16.2V 15.5 ~ 18.2V 18 ~ 21V 27.6 ~ 32.4V 31 ~ 36.5V 86% 57.6 ~ 67.2V Protection type : Shut down o/p voltage, re-power on to recover 95 (TSW1) detect on the heatsink of PFC MOSFET 90 (TSW2) detect the winding of output choke Protection type : Shut down o/p voltage, recovers automatically after temperature goes down RC+/RC-: 0 ~ 0.8V=power on ; 4 ~ 10V=power off -10 ~ +60 (Refer to output load derating curve) sink current <20mA 20 ~ 90% RH non-condensing -20 ~ +85 0.03%/ , 10 ~ 95% RH (0 ~ 50 VIBRATION SAFETY STANDARDS 10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes UL60950-1, TUV EN60950-1 approved WITHSTAND VOLTAGE I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC ISOLATION RESISTANCE I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) Class B HARMONIC CURRENT EMS IMMUNITY MTBF NOTE 85% <2mA / 240VAC TEMP. COEFFICIENT OTHERS 84% 115 ~ 140% rated output power Protection type : Constant current limiting, recovers automatically after fault condition is removed WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY (Note 5) 84% LEAKAGE CURRENT WORKING TEMP. EMC 127 ~ 370VDC FREQUENCY RANGE OVER TEMPERATURE SAFETY & 1500ms, 50ms/115VAC at full load 24ms/115VAC at full load Note.6 90 ~ 264VAC PROTECTION OVER VOLTAGE FUNCTION 4.75 ~ 5.5V 6.0% DIMENSION PACKING Compliance to EN61000-3-2,-3 Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, light industry level, criteria A 59.6K hrs min. MIL-HDBK-217F (25 278*129*127mm (L*W*H) 5.2Kg; 3pcs/16.3Kg/1.42CUFT ) 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. 10% Duty cycle maximum within every 30 seconds(max.). Average output power should not exceed the rated power. 5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. 6. Derating may be needed under low input voltages. Please check the derating curve for more details. File Name:PSP-1000-SPEC 2008-06-30 PSP-1000 1000W Single Output with PFC Function Mechanical Specification Unit:mm 4-M4 31.75 63.5 Case No. 924A series 52 200 23 max. 18 max. CONTROL 8 7 6 5 2 4 1 3 8 38 4-M6 129 39 6-M3 Air flow direction O/P 4 3 2 1 47.5 113 83 ADJ LED 63.5 127 25.75 240 32 I/P 63.5 3 2 1 4-M4 31.75 127 7 10 185 52 AC Input Terminal Pin No. Assignment Pin No. 1 2 3 Control Pin No. Assignment : MOLEX 5559-NP uses 5558male crimp terminal DC Output Terminal Pin No. Assignment Assignment AC/L AC/N FG Pin No. 1,3 2,4 200 278 Assignment DC OUTPUT +V DC OUTPUT -V Pin No. Assignment Pin No. 1 5 P(Current share) -S 2 6 G 3 7 RC4 8 Block Diagram Assignment Mating connector Terminal NC MOLEX 5556 NC MOLEX 5557-NR Female crimp Terminal +S receptacle RC+ P +S G -S RC+ RC- AC/L +V AC/N PSP-500 FG PSP-500 -V Derating Curve Output Derating VS Input Voltage 100 12 ~ 48V 100 90 80 80 5V 70 LOAD(%) LOAD (%) 60 40 20 -10 0 10 20 30 40 50 AMBIENT TEMPERATURE ( ) 60 70 (HORIZONTAL) 60 50 40 90 115 135 180 230 264 INPUT VOLTAGE (V) 60Hz File Name:PSP-1000-SPEC 2008-06-30