RF SAW Filter Part Number Package Application Last Modified 801-RF1575.42M-G 2.5 x 2.0 SMD GPS Mar. 2, 2007 . TYPE : GPS, RF SAW Filter PART NUMBER : 801-RF1575.42M-G .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Attenuation: Condition Minimum Typical Maximum Units - - 1575.42 - MHz 1574.42~ 1576.42 MHz - 1.7 2.2 dB DC~ 1400.0 MHz 35 37 - 1400.0~ 1475.0 MHz 30 34 - 1475.0~ 1525.0MHz 25 32 - 1625.0~ 1640.0 MHz 30 41 - 1640.0~ 2000.0 MHz 30 34 - 2000.0~ 3000.0 MHz 20 25 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm VSWR 1574.42~ 1576.42 MHz - 1.2 2.0 - Amplitude Ripple 1574.42~ 1576.42 MHz - 0.3 1.0 dBp-p Maximum DC Voltage - - - 7.5 V Maximum Input Power - - - 20 dBm Operating Temperature - -40 - +85 ºC * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Out D Ground dB Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 801-RF1575.42M-G