Oscilent Corporation RF SAW Filter | 802-RF976.0M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF976.0M-A 3.0 x 3.0 SMD Wireless Jan. 01, 2007 . TYPE : Wireless, RF SAW Filter PART NUMBER : 802-RF976.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Condition Minimum Typical Maximum Units - - 976.0 - MHz 960.0~ 992.0 MHz - 3.0 4.0 dB D.C.~ 900.0 MHz 40 47 - 900.0~930.0 MHz 35 45 - 1030.0~ 2000.0MHz 25 38 - 960.0~ 992.0MHz - 0.9 1.8 dBp-p Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm 960.0~ 992.0 MHz - 1.7 2.5 - Maximum DC Voltage - - - 0 V Maximum Input Power - - - 10 dBm Operating Temperature - 0 - +50 ºC Stop Band Attenuation: Amplitude Ripple VSWR * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground dB Oscilent Corporation RF SAW Filter | 802-RF976.0M-A Page 2 of 3 Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: 802-RF976.0M-A Oscilent Corporation RF SAW Filter | 802-RF976.0M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map Page 3 of 3