RF SAW Filter Part Number Package Application Last Modified 803-RF311.0M-A 3.8 x 3.8 SMD Wireless Mar. 10, 2007 . TYPE : Wireless RF SAW Filter PART NUMBER : 803-RF311.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Insertion Loss Condition Minimum Typical Maximum Units - - 311.0 - MHz 309.35 ~ 312.65 MHz - 1.6 3.0 dB DC ~ Fo-42.8 MHz 50 55 - Fo+4.00 ~ Fo+200.0 MHz 50 55 - Source Impedence (single ended)* - - 150 - ohm Load Impendance (single ended)* - - 150 - ohm Attenuation: dB 309.35 ~ 312.65 MHz - 0.6 2.0 dBp-p Maximum Input Power - - - 0 dBm Maximum DC Voltage - - - 10 V Operating Temperature - -30 - +65 ºC Amplitude Ripple * With Matching Network(ref. Testing Enviroment Circut as Shown below) * Thoseimpedances could be modified with different impedance values and/or structures, if necessary . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground Source/ Load Impedance = 150 ohms FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 803-RF311.0M-A