Oscilent Corporation RF SAW Filter | 803-RF325.3M-A Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 803-RF325.3M-A 3.8 x 3.8 SMD Wireless Jan. 01, 2007 . TYPE : Wireless RF SAW Filter PART NUMBER : 803-RF325.3M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Condition Minimum Typical Maximum Units - - 325.3 - MHz 322.0 ~ 328.6 MHz - 2.5 3.5 dB Fo-100.0 ~ Fo-39.5 MHz 40 50 - Fo+39.5 ~ Fo+100.0 MHz 50 60 - Source Impedence (single ended)* - - 150 - ohm Load Impendance (single ended)* - - 150 - ohm Attenuation: dB 322.0 ~ 328.6 MHz - 0.8 1.5 dBp-p Maximum Input Power - - - 0 dBm Maximum DC Voltage - - - 10 V Operating Temperature - -30 - +65 ºC Amplitude Ripple * No Matching Network (Ref. Testing Environment Circuit as shown) Impedance Values can be be modifed if needed. . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground Oscilent Corporation RF SAW Filter | 803-RF325.3M-A Page 2 of 2 Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 803-RF325.3M-A