RF SAW Filter Part Number Package Application Last Modified 805-RF246.0M-A 5.0 x 5.0 SMD IF SAW Filter Mar. 10, 2007 . TYPE : Low Loss IF SAW Filter PART NUMBER : 805-RF246.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 246.0 - MHz Insertion Loss 245.5~ 246.5 MHz - 1.5 2.5 dB Amplitude Ripple 245.5~ 246.5 MHz- - 0.2 0.4 dB 100.0~ 226.0 40 60 - 226.0~ 236.0 7 48 - 256.0~ 266.0 7 25 - 266.0~ 268.0 25 40 - 268.0~ 500.0 35 40 - Source Impedance (balanced ended) - - 200 - ohms Load Impedance (single ended) - - 50 - ohms Center Frequency (Fo) Stop Band Attenuation 48 - -25 - +80 C Group Delay Ripple 245.5~ 246.5 MHz - 15 50 ns Maxium Input Power - - - 0 dBm Operating Tempature *No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A In B In C Ground D Ground E Ground F Out G Ground H Ground , PIN Descriptions: IN- A,B, OUT- F GROUND- C,D,E,G,H FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 805-RF246.0M-A