Oscilent Corporation IF SAW Filter | 813-IF99.84M-A Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-IF99.84M-A 13.3 x 6.5 SMD IF SAW Filter Jan. 01, 2007 TYPE : 99.84MHz IF SAW Filter PART NUMBER : 813-IF99.84M-A OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency (Fo) - 99.84 - MHz Insertion Loss at Fo - 9 12 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Temperature Coefficient - -0.03 - ppm/C - - 1.0 dBp-p 1.2dB Bandwidth 260 375 - KHz 5.0dB Bandwidth - 770 930 KHz 30dB Bandwidth - 1.58 1.69 MHz Amplitude Ripple - Relative Attenuation: 10MHz~ 98.1 MHz 45 52 - dB 101.2MHz~ 150 MHz 45 50 - dB Operating Temperature - - - C Absolute Delay at Fo - 1.68 - us Group Delay Variation - - 200 ns *With Matching Network (Ref. Testing Environment Circuit as Shown Below). Those impedances could be modified with different impedance values and/or structures, if necessary PACKAGE OUTLINE TEST CIRCUIT (mm) Oscilent Corporation IF SAW Filter | 813-IF99.84M-A Page 2 of 2 TEST FIXTURE AND VALUES/SOURCE AND LOAD IMPEDANCE 50 ohm INPUT: L1: 180 nH Q>40; C1: 47 pF OUTPUT: L2: 180 nH Q>40; C2: 62 pF FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 813-IF99.84M-A