Oscilent Corporation IF SAW Filter | 820-IF70.0M-FA Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 820-IF70.0M-FA 20.2 x 12.6 Thru Hole Base Station & Repeater May 24 2003 . TYPE : 70.0 MHz Bandpass Filter 9.45 MHz Bandwidth PART NUMBER : 820-IF70.0M-FA .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 69.95 70.00 70.05 MHz Insertion Loss - 20.5 22.0 dB 1dB Bandwidth 9.10 9.15 - MHz 3dB Bandwidth 9.40 9.45 - MHz 40dB Bandwidth - 10.77 10.85 MHz 50dB Bandwidth - 10.90 11.00 MHz Passband Ripple - 0.60 1.0 dB Group Delay Variation - 70 150 nsec Center Frequency - 2.330 - µsec Ultimate Rejection 50 55 - dB Substrate Material - LN - - Absolute Delay * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE No Matching Required Source/Load Impedance = 50 ohms Part No.: http://www.oscilent.com/spec_pages/if_sawfilter/if_820_if70_0fa.htm 820-IF70.0M-FA 12/28/2005 Oscilent Corporation IF SAW Filter | 820-IF70.0M-FA Page 2 of 2 Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_820_if70_0fa.htm 12/28/2005