Oscilent Corporation IF SAW Filter | 835-IF70.0M-SA Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 835-IF70.0M-SA 35 x 12.8 Thru Hole 70.0MHz Bandpass Filter Jan. 01, 2007 . TYPE : 70.0 MHz Bandpass Filter 1.26 MHz Bandwidth PART NUMBER : 835-IF70.0M-SA . FREQUENCY CHARACTERISTICS Horizontal : 0.5 MHz/Div Veritical : 10 dB/Div Horizontal : 0.2 MHz/Div Veritical : 1.0 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 69.97 70.0 70.03 MHz - 20.0 22.0 dB 1 dB Bandwidth 1.26 1.29 - MHz 40 dB Bandwidth 1.8 1.78 - MHz Attenuation at Fo+/-0.9MHz 40 43 - dB Attenuation at Fo+/-1.25MHz 40 45 - dB Attenuation at Fo+/-1.7MHz 40 45 - dB Passband Ripple @ Fo+/-0.55MHz - 0.7 1.0 dB Phase Linearity - 4.2 5.0 rms Center Frequency Insertion Loss - 3.45 - µsec Ultimate Rejection 40 50 - dB Substrate Material - Qz - - Ambient Temperature - 25 - C Absolute Delay * Custom SAW IF Filters available. Contact Oscilent for assistance. . Oscilent Corporation IF SAW Filter | 835-IF70.0M-SA PACKAGE OUTLINE (mm) Page 2 of 2 TEST FIXTURE L1=220 nH L2=220 nH C1=51 pF C2=56 pF Source Impedance = 50 ohms Load Impedance = 50 ohms Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 835-IF70.0M-SA