Oscilent Corporation RF SAW Filter | 863-RF433.92M-D Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 863-RF433.92M-D 3.8 x 3.8 SMD Remote Control Jan. 01, 2007 . TYPE : Remote Control, RF SAW Filter PART NUMBER : 863-RF433.92M-D .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Relative Attenuation: Condition Minimum Typical Maximum Units - - 433.92 - MHz 433.80~ 434.12 MHz - 2.0 4.5 dB 10.0 ~ 414.0 MHz 45 50 - 414.0~ 428.0 MHz 40 45 - 428.0 ~ 432.92MHz 15 20 - 434.92 ~ 442.0 MHz 10 15 - dB 442.0 ~ 550.0 MHz 35 40 - 550.0 ~ 1000.0 MHz 45 50 - Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm 433.76~ 434.16 MHz - 1.0 2.0 - Maximum DC Voltage - - - 10 V Maximum Input Power - - - 10 dBm Operating Temperature - -40 - +85 ºC Pass Band Ripple * With Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE 1 Out 2 Ground 3 Ground 4 Ground 5 Ground 6 In 7 Ground 8 Ground Oscilent Corporation RF SAW Filter | 863-RF433.92M-D Page 2 of 2 Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 863-RF433.92M-D