14 Pin SMD 5 Tap Low Profile TTL Compatible Active Delay Lines ELECTRONICS INC. EPA073HL-XX & EPA073HL-XX-RC Add “-RC” after part number for RoHS Compliant PCA Part Number EPA073HL-25(-RC) EPA073HL-30(-RC) EPA073HL-35(-RC) EPA073HL-40(-RC) EPA073HL-45(-RC) EPA073HL-50(-RC) EPA073HL-60(-RC) EPA073HL-75(-RC) EPA073HL-100(-RC) EPA073HL-125(-RC) EPA073HL-150(-RC) EPA073HL-175(-RC) Total Delay (†±5% or ± 2nS) Tap Delays (†±5% or ± 2nS) 5, 10, 15, 20 6, 12, 18, 24 7, 14, 21, 28 8, 16, 24, 32 9, 18, 27, 36 10, 20, 30, 40 12, 24, 36, 48 15, 30, 45, 60 20, 40, 60, 80 25, 50, 75, 100 30, 60, 90, 120 35, 70, 105, 140 PCA Part Number EPA073HL-200(-RC) EPA073HL-225(-RC) EPA073HL-250(-RC) EPA073HL-300(-RC) EPA073HL-350(-RC) EPA073HL-400(-RC) EPA073HL-420(-RC) EPA073HL-440(-RC) EPA073HL-450(-RC) EPA073HL-470(-RC) EPA073HL-500(-RC) 25 30 35 40 45 50 60 75 100 125 150 175 Tap Delays (†±5% or ± 2nS) Total Delay (†±5% or ± 2nS) 40, 80, 120, 160 45, 90, 135, 180 50, 100, 150, 200 60, 120, 180, 240 70, 140, 210, 280 80, 160, 240, 320 84, 168, 252, 336 88, 176, 264, 352 90, 180, 270, 360 94, 188, 282, 376 100, 200, 300, 400 200 225 250 300 350 400 420 440 450 470 500 †Whichever is greater. Delay times referenced from input to leading and trailing edges at 25°C, 5.0V, with no load. DC Electrical Characteristics Parameter VOH VOL VIK IIH Test Conditions Min. High-Level Output Voltage Low-Level Output Voltage Input Clamp Voltage High-Level Input Current V CC = min. V IL = max. I OH = max 2.7 V CC = min. V IH = min. I OL = max V CC = min. II = II K V CC = max. VIN = 2.7V V CC = max. VIN = 5.25V IIL Low-Level Input Current V CC = max. VIN = 0.5V IOS Short Circuit Output Current V CC = max. V OUT = 0. -40 (One output at a time) ICCH High-Level Supply Current V CC = max. VIN = OPEN ICCL Low-Level Supply Current V CC = max. VIN = 0 TRO Output Rise Time Td ≤ 500 nS (0.75 to 2.4 Volts) Td > 500 nS NH Fanout High-Level Output V CC = max. V OH = 2.7V NL Fanout Low-Level Output V CC = max. V OL = 0.5V Max. Unit 0.5 -1.2 50 1.0 -2 -100 V V V µA mA mA mA Schematic 14 12 VCC 4 10 6 8 OUTPUT INPUT 1 7 GROUND 75 mA 75 mA 4 nS 5 nS 20 TTL Load 10 TTL Load Package .055 (1.40) .200 (5.08) .400 Max. (10.16) Recommended Operating Conditions Min. VCC VIH VIL IIK IOH IOL PW* d* TA Supply Voltage High-Level Input Voltage Low-Level Input Voltage Input Clamp Current High-Level Output Current Low-Level Output Current Pulse Width of Total Delay Duty Cycle Operating Free-Air Temperature 4.75 2.0 Max. Unit 5.25 V V V mA mA mA % % °C 0.8 -18 -1.0 20 40 0 40 +70 PCA EPA073HL-XX(-RC) Date Code .300 (7.62) .200 (5.08) Suggested Solder Pad Layout .300 (7.62) .780 Max. (19.81) .410 (10.41) .030 (.762) .010 Typ. (.254) .165 Max. (4.19) .020 (.508) .280 Max. (7.11) .100 (2.54) .050 (1.27) .300 (7.62) *These two values are inter-dependent. Notes : Input Pulse Test Conditions @ 25° C EIN PW TRI PRR Pulse Input Voltage Pulse Width % of Total Delay Pulse Rise Time (0.75 - 2.4 Volts) Pulse Repetition Rate @ Td ≤ 200 nS Pulse Repetition Rate @ Td > 200 nS VCC Supply Voltage Unit 3.2 110 2.0 1.0 100 5.0 Volts % nS MHz KHz Volts EPA073HL-XX EPA073HL-XX-RC 1. Lead Finish SnPb Hot Dip Sn or SAC 2. Peak Temperature Rating 225°C 245°C 3. Moisture Sensitive Levels 3 (168 hourss, ≤30°C/60%RH) 4 (72 hours, ≤30°C/60%RH) 1.35 grams 1.35 grams 4. Weight 5. Packaging Information (Tube) (Tape & Reel) 27 pieces/tube 27 pieces/tube 600 pieces/13” reel 600 pieces/13” ree Unless Otherwise Specified Dimensions are in Inches /mm ± .010 /.25 PCA ELECTRONICS, INC. 16799 SCHOENBORN ST. NORTH HILLS, CA 91343 Product performance is limited to specified parameters. Data is subject to change without prior notice. CSA073HL & -RC Rev. 2 3/4/08 RR TEL: (818) 892-0761 FAX: (818) 894-5791 http://www.pca.com