RSG RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany Tel. +49 69 984047-0 Fax +49 69 984047-77 [email protected] www.rsg-electronic.de ■ ■ ELECTRONIC COMPONENTS ■ ■ ■ ■ Änderungen vorbehalten / subject to change without notice 150 WATT SWITCHING POWER SUPPLIES DESCRIPTION PU150 SERIES (LVD) The PU150 series comprises single and multiple output models for 150 watts of continuous output power. Auto-ranging input allows them to operate from any line voltage throughout the world without a selector strap. All auxiliary outputs are with magnetic amplifier to keep regulation. The units are constructed on a printed circuit board with a U-bracket for mechanical support and heat sinking, in 1U height. F E AT U R E S Auto-ranging input Overvoltage protection Short-circuit protection with auto-recovery Power Fail Detect（ PFD） signal on models With 5V output • 100﹪ burn-in at full rated load • • • • I N P U T S P E C I F I C AT I O N S Input voltage： Input frequency： Input current： Leakage current： 8 5 t o 1 3 2 VA C , o r 1 7 0 t o 2 6 4 VA C （ a u t o - r a n g i n g ） 47 to 63 Hz 3 . 4 A （ r m s ） f o r 11 5 VA C 2 . 0 A （ r m s ） f o r 2 3 0 VA C 0 . 4 m A m a x . @ 11 5 VA C , 6 0 H z 0 . 8 m A m a x . @ 2 3 0 VA C , 5 0 H z S a f e t y St a n d a r d A p p ro v a l s ： UL 60950-1 File No. E137410 CSA C22.2 No. 60950-1 File No. LR93632 TÜV EN60950-1 Certificate No. R9954992 OUTPUT SPECIFICATIONS GENERAL SPECIFICATIONS Output voltage/current ： Total output power ： See rating chart 150 watts maximum at 30 CFM forced air cooling or 110 watts maximum at convection cooling Switching frequency ： 120KHz ±15% Efficiency ： Hold-up time ： Line regulation ： 70 ﹪ typical on all models 15 msec minimum at 115VAC ±0.5 ﹪ maximum at full load Ripple and noise ： 1 ﹪ peak to peak maximum Inrush current ： Overvoltage protection ： Provided on output #1 only; set at 112-136 ﹪ of its nominal output voltage Overcurrent protection ： All outputs protected to short circuit conditions Temperature coefficient ： All outputs ±0.04 ﹪ / ℃ maximum Transient response ： Maximum excursion of 4 ﹪ or better on all models, recovering to 1 ﹪ of final value within 500us after a 25 ﹪ step load change 20 amps @ 115VAC, or 40 amps @ 230VAC, at 25 ℃ cold start Withstand voltage ： 3000VAC from input to output 1500VAC from input to ground 500VAC from output to ground MTBF ： 300,000 hours minimum at full load at 25 ℃ ambient, calculated per MIL-HDBK-217F EMC performance (EN55024) EN55022: FCC: VCCI: EN61000-3-2: EN61000-3-3: EN61000-4-2: Class B conducted, Class B radiated Class B conducted, Class B radiated Class B conducted, Class B radiated Harmonic distortion, Class A Line flicker ESD, ± 8KV air and ± 4KV contact EN61000-4-3: Radiated immunity, 3V/m E N V I R O N M E N TA L S P E C I F I C AT I O N S EN61000-4-4: Fast transient/burst, ± 1KV Operating temperature： St o r a g e t e m p e r a t u r e ： Relative humidity： Derating： EN61000-4-5: Surge, ± 1KV diff., ± 2KV com. EN61000-4-6: Conducted immunity, 3Vrms 1-11 0℃ to +70℃ -40℃ to +85℃ 5﹪ to 95% non-condensing Derate from 100﹪ at +50℃ Linearly to 50﹪at +70℃ EN61000-4-8: Magnetic field immunity, 1A/m E N 6 1 0 0 0 - 4 - 11 : Voltage dips, 30 ﹪ reduction for 500ms and > 95 ﹪ reduction for 10ms PU150 SERIES AUTORANGING INPUT OUTPUT VOLTAGE/CURRENT RATING CHART (1)(2) Output #1 (3) Model PU150-10B PU150-12B PU150-13B PU150-13-1B PU150-14B PU150-16B PU150-17B PU150-18B PU150-23B PU150-24B PU150-25B PU150-30B PU150-31B PU150-32B PU150-33B PU150-40B PU150-41B PU150-42B PU150-44B PU150-45B Notes: Output #2 Output #3 Vnom Imin Imax. Ipeak Tol. Vnom Imin. Imax. Ipeak Tol. 5V 12V 15V 18V 24V 30V 36V 48V +5V +5V +5V +5V +5V +5V +5V +5V +5V +5V +5V +5V 0A 0A 0A 0A 0A 0A 0A 0A 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A 2.0A 30A 12.5A 10A 8.3V 6.3A 5.0A 4.2A 3.1A 22A 22A 22A 22A 22A 22A 22A 22A 22A 22A 22A 22A 35A 14.5A 11.6A 9.7A 7.3A 6.0A 4.8A 3.6A 30A 30A 30A 30A 30A 30A 30A 30A 30A 30A 30A 30A 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% 2% +12V +15V +24V +12V +12V +15V +15V +12V +15V +12V +12V +12V (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) 0A 8A 0A 6.4A 0A 4.5A 0A 8A 0A 8A 0A 6.4A 0A 6.4A 0A 8A 0A 6.4A 0A 8A 0A 8A 0A 8A 10A 8A 5A 10A 10A 8A 8A 10A 8A 10A 10A 10A 3% 3% 3% 3% 3% 3% 3% 3% 3% 3% 3% 3% Vnom. Imin. Imax. Tol. -5V -12V -15V -12V -12V -15V -12V -15V -12V (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) 0A 2.5A 0A 2.5A 0A 2A 0A 2.5A 0A 2.5A 0A 2A 0A 2.5A 0A 2A 0A 2.5A 3% 3% 3% 3% 3% 3% 3% 3% 3% Output #4 Output Vnom Imin. Imax. Ipeak Tol. Power 5V 24V 12V 15V 24V (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) 0A 5A 0A 4.5A 0A 4.5A 0A 4A 0A 4.5A 5A 5A 5A 4.5A 5A 3% 3% 3% 3% 3% 150W 150W 150W 150W 150W 150W 150W 150W 150W 150W 150W 150W 150W 150W 150W 150W 150W 150W 150W 150W (1) Safety agency approvals are for the above listed models in U-braket format. To order model with a matallic cover, change suffix ”B” to ”C” for enclosed format (mechanical details shown in page7-3). e.g. PU150-45C (2) Output #1 can be built for one-wire current sharing. Add suffix “Z”, e.g. PU150-45B-Z for this requirement. (3) The maximum current of each output shall be derated to 75% if no forced air is provided by user. (4) The output #1 of all multiple output models needs a minimum load of 2A to support the other outputs at their maximum rated loads. MECHANICAL SPECIFICATIONS Single Output models NOTES: 1. Dimensions shown in inch [mm] 2. Tolerance 0.02 [0.5] maximum 3. Input connector P1 mates with Molex housing 09-50-3051 and Molex 2878 series crimp terminal. 4. Output connector P3 mates with Molex housing 09-50-3031 and Molex 2878 series crimp terminal. 5. Connector P4 mates with Molex housing 51110-0851 and pins 50394-8100. 6. Weight: 0.84 kgs (1.86 Lbs.) approx. Multiple Output models NOTES: 1. Dimensions shown in inch [mm] 2. Tolerance 0.02 [0.5] maximum 3. Input connector P1 mates with Molex housing 09-50-3051 and Molex 2878 series crimp terminal. 4. Output connector P3 mates with Molex housing 09-50-3091 and Molex 2878 series crimp terminal. 5. Connector P4 mates with Molex housing 51110-0851 and pins 50394-8100. 6. Weight: 0.84 kgs (1.86 Lbs.) approx. 1-12 PU150 SERIES AUTORANGING INPUT PIN CHART Single Output Models CONN P1 PIN 1 P2 2 3 1 P3 2 1 2 OUTPUT #1 PFD N.C. OUTPUT #1 N.C. N.C. 3 MODEL PU150-10 PU150-12 PU150-13 PU150-13-1 PU150-14 PU150-16 PU150-17 AC AC AC COM. NEUTRAL LIVE GROUND RET. AC AC AC NEUTRAL LIVE GROUND COM. RET. COM. RET. N.C. PU150-18 CONN P4 PIN 1 2 3 4 N.C. N.C. 5 6 7 8 COM. RET. -SENSE +SENSE MODEL PU150-10 PU150-12 COM PU150-13 PU150-13-1 RET PU150-14 PU150-16 INHIBIT PU150-17 PU150-18 -Ve INHIBIT +Ve CURRENT SHARE Multiple Output Models P1 CONN MODEL PU150-23 PIN PU150-24 PU150-25 P2 1 2 3 1 2 AC AC AC COM. OUTPUT RET. #1 COM. OUTPUT RET. #1 COM. RET. NEUTRAL LIVE GROUND PU150-30 PU150-31 PU150-32 PU150-33 PU150-40 PU150-41 PU150-42 PU150-44 PU150-45 P3 AC AC AC NEUTRAL LIVE GROUND AC AC AC NEUTRAL LIVE GROUND 1 2 3 4 N.C. N.C. PFD N.C. N.C. N.C. OUTPUT OUTPUT #4 OUTPUT #1 RETURN #4 CONN PIN PFD PFD 5,6,7 COM. 8,9 OUTPUT RET. #2 OUTPUT COM. OUTPUT #3 RET. #2 OUTPUT COM. OUTPUT #3 RET. #2 P4 1 2 3 4 5 6 7 -SENSE +SENSE -SENSE +SENSE 8 MODEL PU150-23 PU150-30 PU150-31 PU150-40 INHIBIT INHIBIT +12V PU150-42 PU150-44 -Ve +Ve (FAN) PU150-24 PU150-32 INHIBIT INHIBIT +15V PU150-33 PU150-41 -Ve +Ve (FAN) INHIBIT INHIBIT +24V -Ve +Ve (FAN) N.C. COM RET. CURRENT SHARE PU150-45 PU150-25 1-13 N.C. N.C. COM. RET. COM. RET. -SENSE +SENSE CURRENT SHARE CURRENT SHARE